Exemplos de target_usb_setup em C++ (Cpp)

Exemplo n.º 1

Arquivo: init.c Projeto: XRobinHe/lk

void target_init(void)
{
    stm32_debug_init();

    qspi_flash_init(N25Q128A_FLASH_SIZE);

#if ENABLE_LCD
    memory_lcd_init();
#endif

#if WITH_LIB_MINIP
    uint8_t mac_addr[6];
    gen_random_mac_address(mac_addr);
    eth_init(mac_addr, PHY_KSZ8721);

    /* start minip */
    minip_set_macaddr(mac_addr);

    uint32_t ip_addr = IPV4(192, 168, 0, 98);
    uint32_t ip_mask = IPV4(255, 255, 255, 0);
    uint32_t ip_gateway = IPV4_NONE;

    minip_init(stm32_eth_send_minip_pkt, NULL, ip_addr, ip_mask, ip_gateway);
#endif

#if WITH_LIB_FS_SPIFS
    status_t mount_success = fs_mount(DEAULT_SPIFS_MOUNT_POINT,
                                      DEAULT_SPIFS_NAME, SPIFS_TARGET_DEVICE);
    if (mount_success != NO_ERROR) {
        printf("failed to mount '%s' at path '%s' on '%s'."
               " Make sure that device is formatted\n",
               DEAULT_SPIFS_NAME, DEAULT_SPIFS_MOUNT_POINT,
               SPIFS_TARGET_DEVICE);
    }

#endif

    // start usb
    target_usb_setup();

#if ENABLE_SENSORBUS
    sensor_bus_init();
#endif
}

Exemplo n.º 2

Arquivo: init.c Projeto: DSKIM3/lk

void target_init(void)
{
	target_usb_setup();
}