LONGBOW_TEST_CASE(Local, metisControl_UnsetDebug_Execute_WrongArgCount)
{
MetisCommandReturn result = testDebug(testCase, metisControlUnsetDebug_Create, 3, true, false);
assertTrue(result == MetisCommandReturn_Failure,
"metisControl_UnsetDebug_Execute should return %d, got %d", MetisCommandReturn_Failure, result);
}
LONGBOW_TEST_CASE(Local, metisControl_UnsetDebug_Execute_Good)
{
MetisCommandReturn result = testDebug(testCase, metisControlUnsetDebug_Create, 2, true, false);
assertTrue(result == MetisCommandReturn_Success,
"metisControl_UnsetDebug_Execute should return %d, got %d", MetisCommandReturn_Success, result);
}
void ProgramSenoko::runTest()
{
QProcess stm32flash;
int tries;
if (prepGPIO()) {
testError("Unable to set up reset GPIO");
return;
}
testInfo("Please hold the \"Reflash\" button on Senoko");
/* Wait for the flashing process to start */
while (1) {
bool foundBanner = false;
/* This string is the last thing to appear before programming starts */
const char *searchString = "Serial Config: 115200 8E1";
testDebug("Trying to initiate upload...");
resetGPIO();
stm32flash.terminate();
stm32flash.setProcessChannelMode(QProcess::MergedChannels);
stm32flash.start("/factory/stm32flash", QStringList()
<< "-b" << "115200"
<< "-w" << firmware
<< "/dev/ttymxc3");
stm32flash.waitForStarted();
tries = 0;
while (!foundBanner && (tries++ < 10)) {
if (!stm32flash.waitForReadyRead(1000)) {
testDebug("Process wasn't ready for read in 1 second");
break;
}
QByteArray output = stm32flash.readLine();
testDebug(QString("Output string: ") + output);
if (stm32flash.state() != QProcess::Running) {
testDebug("Process no longer running");
break;
}
if (output.startsWith(searchString)) {
testDebug("Found search string");
foundBanner = true;
}
else {
testDebug(QString("Line doesn't contain string %1: %2").arg(searchString).arg((const char *)output));
}
}
if (!foundBanner) {
testDebug("Didn't find banner");
continue;
}
if (!stm32flash.waitForReadyRead(1000)) {
testDebug("Didn't find data after 1 second");
continue;
}
break;
}
testInfo("Upload started, release the \"Reflash\" button");
if (!stm32flash.waitForFinished(60000)) {
testError("Flashing process took too long");
testError(stm32flash.readAllStandardOutput());
return;
}
testInfo("Senoko reflashed successfully");
resetGPIO();
testInfo("Attempting to rescan device bus");
QFile autoprobeFile("/sys/bus/platform/drivers_autoprobe");
if (!autoprobeFile.open(QIODevice::WriteOnly)) {
testError(QString() + "Unable to open platform/drivers_autoprobe file: " + autoprobeFile.errorString());
return;
}
autoprobeFile.write("1\n");
autoprobeFile.close();
sleep(1);
}
