/*
* Gets current TWL4030 RTC alarm time.
*/
static int twl4030_rtc_read_alarm(struct device *dev, struct rtc_wkalrm *alm)
{
unsigned char rtc_data[ALL_TIME_REGS + 1];
int ret;
ret = twl4030_i2c_read(TWL4030_MODULE_RTC, rtc_data,
REG_ALARM_SECONDS_REG, ALL_TIME_REGS);
if (ret < 0) {
dev_err(dev, "rtc_read_alarm error %d\n", ret);
return ret;
}
/* some of these fields may be wildcard/"match all" */
alm->time.tm_sec = bcd2bin(rtc_data[0]);
alm->time.tm_min = bcd2bin(rtc_data[1]);
alm->time.tm_hour = bcd2bin(rtc_data[2]);
alm->time.tm_mday = bcd2bin(rtc_data[3]);
alm->time.tm_mon = bcd2bin(rtc_data[4]) - 1;
alm->time.tm_year = bcd2bin(rtc_data[5]) + 100;
/* report cached alarm enable state */
if (rtc_irq_bits & BIT_RTC_INTERRUPTS_REG_IT_ALARM_M)
alm->enabled = 1;
return ret;
}
static int beagle_detect(SIM_HBA *hba)
{
SIM_MMC_EXT *ext;
omap3_ext_t *omap;
beagle_ext_t *beagle;
uint8_t pmic_gpio_status;
ext = (SIM_MMC_EXT *) hba->ext;
omap = (omap3_ext_t *) ext->handle;
beagle = (beagle_ext_t *) omap->bshdl;
// read MMC1_CD via PMIC GPIO (i2c access) on GPIODATAIN1 register
if (twl4030_i2c_read(beagle->fd, 0x49, 0x98, &pmic_gpio_status))
return MMC_FAILURE; // bail if the access fails
// MMC1_CD is bit 0 and is high when card removed and low when card present
if (!(pmic_gpio_status & 1))
{
// Beagleboard xM has no write protect pin on the microSD slot
// as such, return not write protected.
ext->eflags &= ~MMC_EFLAG_WP;
return MMC_SUCCESS;
}
return MMC_FAILURE;
}
/*
* Gets current TWL4030 RTC time and date parameters.
*
* The RTC's time/alarm representation is not what gmtime(3) requires
* Linux to use:
*
* - Months are 1..12 vs Linux 0-11
* - Years are 0..99 vs Linux 1900..N (we assume 21st century)
*/
static int twl4030_rtc_read_time(struct device *dev, struct rtc_time *tm)
{
unsigned char rtc_data[ALL_TIME_REGS + 1];
int ret;
u8 save_control;
ret = twl4030_rtc_read_u8(&save_control, REG_RTC_CTRL_REG);
if (ret < 0)
return ret;
save_control |= BIT_RTC_CTRL_REG_GET_TIME_M;
ret = twl4030_rtc_write_u8(save_control, REG_RTC_CTRL_REG);
if (ret < 0)
return ret;
ret = twl4030_i2c_read(TWL4030_MODULE_RTC, rtc_data,
REG_SECONDS_REG, ALL_TIME_REGS);
if (ret < 0) {
dev_err(dev, "rtc_read_time error %d\n", ret);
return ret;
}
tm->tm_sec = bcd2bin(rtc_data[0]);
tm->tm_min = bcd2bin(rtc_data[1]);
tm->tm_hour = bcd2bin(rtc_data[2]);
tm->tm_mday = bcd2bin(rtc_data[3]);
tm->tm_mon = bcd2bin(rtc_data[4]) - 1;
tm->tm_year = bcd2bin(rtc_data[5]) + 100;
return ret;
}
/*
* Gets current TWL4030 RTC alarm time.
*/
static int get_rtc_alm_time(struct rtc_time *alm_tm)
{
unsigned char rtc_data[ALL_TIME_REGS + 1];
int ret;
ret = twl4030_i2c_read(TWL4030_MODULE_RTC, rtc_data,
REG_ALARM_SECONDS_REG, ALL_TIME_REGS);
if (ret < 0) {
printk(KERN_ERR "twl4030_rtc: twl4030_i2c_read error.\n");
return ret;
}
alm_tm->tm_sec = BCD2BIN(rtc_data[0]);
alm_tm->tm_min = BCD2BIN(rtc_data[1]);
alm_tm->tm_hour = BCD2BIN(rtc_data[2]);
alm_tm->tm_mday = BCD2BIN(rtc_data[3]);
alm_tm->tm_mon = BCD2BIN(rtc_data[4]);
alm_tm->tm_year = BCD2BIN(rtc_data[5]);
/*
* Account for differences between how the RTC uses the values
* and how they are defined in a struct rtc_time;
*/
if ((alm_tm->tm_year += (epoch - 1900)) <= 69)
alm_tm->tm_year += 100;
alm_tm->tm_mon--;
return ret;
}
static int twl4030_kpread(struct twl4030_keypad *kp,
u8 *data, u32 reg, u8 num_bytes)
{
int ret;
ret = twl4030_i2c_read(TWL4030_MODULE_KEYPAD, data, reg, num_bytes);
if (ret < 0) {
dev_warn(kp->dbg_dev,
"Couldn't read TWL4030: %X - ret %d[%x]\n",
reg, ret, ret);
return ret;
}
return ret;
}
static void twl4030_load_rev(void)
{
int err;
err = twl4030_i2c_write_u8(TWL4030_MODULE_INTBR,
TWL_EEPROM_R_UNLOCK, R_UNLOCK_TEST_REG);
if (err)
pr_err("TWL4030 Unable to unlock IDCODE registers\n");
err = twl4030_i2c_read(TWL4030_MODULE_INTBR, (u8 *)(&twl4030_rev), 0x0, 4);
if (err)
pr_err("TWL4030: unable to read IDCODE-%d\n", err);
err = twl4030_i2c_write_u8(TWL4030_MODULE_INTBR, 0x0, R_UNLOCK_TEST_REG);
if (err)
pr_err("TWL4030 Unable to relock IDCODE registers\n");
}
/*
* Gets current TWL4030 RTC time and date parameters.
*/
static int get_rtc_time(struct rtc_time *rtc_tm)
{
unsigned char rtc_data[ALL_TIME_REGS + 1];
int ret;
u8 save_control;
ret = twl4030_rtc_read_u8(&save_control, REG_RTC_CTRL_REG);
if (ret < 0)
return ret;
save_control |= BIT_RTC_CTRL_REG_GET_TIME_M;
ret = twl4030_rtc_write_u8(save_control, REG_RTC_CTRL_REG);
if (ret < 0)
return ret;
ret = twl4030_i2c_read(TWL4030_MODULE_RTC, rtc_data,
REG_SECONDS_REG, ALL_TIME_REGS);
if (ret < 0) {
printk(KERN_ERR "twl4030_rtc: twl4030_i2c_read error.\n");
return ret;
}
rtc_tm->tm_sec = BCD2BIN(rtc_data[0]);
rtc_tm->tm_min = BCD2BIN(rtc_data[1]);
rtc_tm->tm_hour = BCD2BIN(rtc_data[2]);
rtc_tm->tm_mday = BCD2BIN(rtc_data[3]);
rtc_tm->tm_mon = BCD2BIN(rtc_data[4]);
rtc_tm->tm_year = BCD2BIN(rtc_data[5]);
/*
* Account for differences between how the RTC uses the values
* and how they are defined in a struct rtc_time;
*/
if ((rtc_tm->tm_year += (epoch - 1900)) <= 69)
rtc_tm->tm_year += 100;
rtc_tm->tm_mon--;
return ret;
}
int twl4030_enable_dvi(disp_adapter_t *adapter)
{
unsigned speed;
unsigned char b;
int err;
/*
* Open the I2C controller device for the codec
*/
fd = open(TWL4030_I2C_DEVICE, O_RDWR);
if (fd == NULL) {
perror("open");
return -1;
}
printf("\n Enable DVI output on BeagleBoard-xM\n");
slogf(21,0,"Enable DVI output on BeagleBoard-xM\n" );
/*
* Set the I2C speed for the codec
*/
speed = TWL4030_I2C_SPEED;
err = devctl(fd, DCMD_I2C_SET_BUS_SPEED, &speed, sizeof(speed), NULL);
if (err != EOK) {
return -1;
}
/* Set GPOI2 (DVI_PU) high, to power on the DVI */
// First set the direction. Read in the existing direction value
if (twl4030_i2c_read(TWL4030_ADDR_GRP4, 0x9B, &b))
return -1; // bail if the access fails
b |= (1 << 2);
twl4030_i2c_write(adapter, TWL4030_ADDR_GRP4, 0x9B, b);
// Now set the value high
twl4030_i2c_write(adapter, TWL4030_ADDR_GRP4, 0xA4, (unsigned char)(1<<2));
return 0;
}
/**
* twl4030_i2c_read_u8 - Reads a 8 bit register from TWL4030
* @mod_no: module number
* @value: the value read 8 bit
* @reg: register address (just offset will do)
*
* Returns result of operation - 0 is success
*/
int twl4030_i2c_read_u8(u8 mod_no, u8 *value, u8 reg)
{
return twl4030_i2c_read(mod_no, value, reg, 1);
}
