/**
* @brief Disable low power mode behavior when the MCU is in Debug mode.
* @param Periph: specifies the low power mode.
* This parameter can be any combination of the following values:
* @arg DBGMCU_SLEEP: Keep debugger connection during SLEEP mode
* @arg DBGMCU_STOP: Keep debugger connection during STOP mode
* @arg DBGMCU_STANDBY: Keep debugger connection during STANDBY mode
* @retval None
*/
void HAL_DBGMCU_DBG_DisableLowPowerConfig(uint32_t Periph)
{
/* Check the parameters */
assert_param(IS_DBGMCU_PERIPH(Periph));
{
DBGMCU->CR &= ~Periph;
}
}
/**
* @brief Configures low power mode behavior when the MCU is in Debug mode.
* @param DBGMCU_Periph: specifies the low power mode.
* This parameter can be any combination of the following values:
* @arg DBGMCU_SLEEP: Keep debugger connection during SLEEP mode
* @arg DBGMCU_STOP: Keep debugger connection during STOP mode
* @arg DBGMCU_STANDBY: Keep debugger connection during STANDBY mode
* @param NewState: new state of the specified low power mode in Debug mode.
* This parameter can be: ENABLE or DISABLE.
* @retval None
*/
void DBGMCU_Config(uint32_t DBGMCU_Periph, FunctionalState NewState) {
/* Check the parameters */
assert_param(IS_DBGMCU_PERIPH(DBGMCU_Periph));
assert_param(IS_FUNCTIONAL_STATE(NewState));
if (NewState != DISABLE) {
DBGMCU->CR |= DBGMCU_Periph;
} else {
DBGMCU->CR &= ~DBGMCU_Periph;
}
}
