static irqreturn_t pcish5_err_irq(int irq, void *dev_id)
{
struct pt_regs *regs = get_irq_regs();
unsigned pci_int, pci_air, pci_cir, pci_aint;
pci_int = SH5PCI_READ(INT);
pci_cir = SH5PCI_READ(CIR);
pci_air = SH5PCI_READ(AIR);
if (pci_int) {
printk("PCI INTERRUPT (at %08llx)!\n", regs->pc);
printk("PCI INT -> 0x%x\n", pci_int & 0xffff);
printk("PCI AIR -> 0x%x\n", pci_air);
printk("PCI CIR -> 0x%x\n", pci_cir);
SH5PCI_WRITE(INT, ~0);
}
pci_aint = SH5PCI_READ(AINT);
if (pci_aint) {
printk("PCI ARB INTERRUPT!\n");
printk("PCI AINT -> 0x%x\n", pci_aint);
printk("PCI AIR -> 0x%x\n", pci_air);
printk("PCI CIR -> 0x%x\n", pci_cir);
SH5PCI_WRITE(AINT, ~0);
}
return IRQ_HANDLED;
}
static int sh5pci_write(struct pci_bus *bus, unsigned int devfn, int where,
int size, u32 val)
{
SH5PCI_WRITE(PAR, CONFIG_CMD(bus, devfn, where));
switch (size) {
case 1:
SH5PCI_WRITE_BYTE(PDR + (where & 3), (u8)val);
break;
case 2:
SH5PCI_WRITE_SHORT(PDR + (where & 2), (u16)val);
break;
case 4:
SH5PCI_WRITE(PDR, val);
break;
}
return PCIBIOS_SUCCESSFUL;
}
static int sh5pci_read(struct pci_bus *bus, unsigned int devfn, int where,
int size, u32 *val)
{
SH5PCI_WRITE(PAR, CONFIG_CMD(bus, devfn, where));
switch (size) {
case 1:
*val = (u8)SH5PCI_READ_BYTE(PDR + (where & 3));
break;
case 2:
*val = (u16)SH5PCI_READ_SHORT(PDR + (where & 2));
break;
case 4:
*val = SH5PCI_READ(PDR);
break;
}
return PCIBIOS_SUCCESSFUL;
}
static int __init sh5pci_init(void)
{
unsigned long memStart = __pa(memory_start);
unsigned long memSize = __pa(memory_end) - memStart;
u32 lsr0;
u32 uval;
if (request_irq(IRQ_ERR, pcish5_err_irq,
IRQF_DISABLED, "PCI Error",NULL) < 0) {
printk(KERN_ERR "PCISH5: Cannot hook PCI_PERR interrupt\n");
return -EINVAL;
}
if (request_irq(IRQ_SERR, pcish5_serr_irq,
IRQF_DISABLED, "PCI SERR interrupt", NULL) < 0) {
printk(KERN_ERR "PCISH5: Cannot hook PCI_SERR interrupt\n");
return -EINVAL;
}
pcicr_virt = (unsigned long)ioremap_nocache(SH5PCI_ICR_BASE, 1024);
if (!pcicr_virt) {
panic("Unable to remap PCICR\n");
}
PCI_IO_AREA = (unsigned long)ioremap_nocache(SH5PCI_IO_BASE, 0x10000);
if (!PCI_IO_AREA) {
panic("Unable to remap PCIIO\n");
}
/* Clear snoop registers */
SH5PCI_WRITE(CSCR0, 0);
SH5PCI_WRITE(CSCR1, 0);
/* Switch off interrupts */
SH5PCI_WRITE(INTM, 0);
SH5PCI_WRITE(AINTM, 0);
SH5PCI_WRITE(PINTM, 0);
/* Set bus active, take it out of reset */
uval = SH5PCI_READ(CR);
/* Set command Register */
SH5PCI_WRITE(CR, uval | CR_LOCK_MASK | CR_CFINT| CR_FTO | CR_PFE |
CR_PFCS | CR_BMAM);
uval=SH5PCI_READ(CR);
/* Allow it to be a master */
/* NB - WE DISABLE I/O ACCESS to stop overlap */
/* set WAIT bit to enable stepping, an attempt to improve stability */
SH5PCI_WRITE_SHORT(CSR_CMD,
PCI_COMMAND_MEMORY | PCI_COMMAND_MASTER |
PCI_COMMAND_WAIT);
/*
** Set translation mapping memory in order to convert the address
** used for the main bus, to the PCI internal address.
*/
SH5PCI_WRITE(MBR,0x40000000);
/* Always set the max size 512M */
SH5PCI_WRITE(MBMR, PCISH5_MEM_SIZCONV(512*1024*1024));
/*
** I/O addresses are mapped at internal PCI specific address
** as is described into the configuration bridge table.
** These are changed to 0, to allow cards that have legacy
** io such as vga to function correctly. We set the SH5 IOBAR to
** 256K, which is a bit big as we can only have 64K of address space
*/
SH5PCI_WRITE(IOBR,0x0);
/* Set up a 256K window. Totally pointless waste of address space */
SH5PCI_WRITE(IOBMR,0);
/* The SH5 has a HUGE 256K I/O region, which breaks the PCI spec.
* Ideally, we would want to map the I/O region somewhere, but it
* is so big this is not that easy!
*/
SH5PCI_WRITE(CSR_IBAR0,~0);
/* Set memory size value */
memSize = memory_end - memory_start;
/* Now we set up the mbars so the PCI bus can see the memory of
* the machine */
if (memSize < (1024 * 1024)) {
printk(KERN_ERR "PCISH5: Ridiculous memory size of 0x%lx?\n",
memSize);
return -EINVAL;
}
/* Set LSR 0 */
lsr0 = (memSize > (512 * 1024 * 1024)) ? 0x1ff00001 :
((r2p2(memSize) - 0x100000) | 0x1);
SH5PCI_WRITE(LSR0, lsr0);
/* Set MBAR 0 */
SH5PCI_WRITE(CSR_MBAR0, memory_start);
SH5PCI_WRITE(LAR0, memory_start);
SH5PCI_WRITE(CSR_MBAR1,0);
SH5PCI_WRITE(LAR1,0);
SH5PCI_WRITE(LSR1,0);
/* Enable the PCI interrupts on the device */
SH5PCI_WRITE(INTM, ~0);
SH5PCI_WRITE(AINTM, ~0);
SH5PCI_WRITE(PINTM, ~0);
sh5_io_resource.start = PCI_IO_AREA;
sh5_io_resource.end = PCI_IO_AREA + 0x10000;
sh5_mem_resource.start = memStart;
sh5_mem_resource.end = memStart + memSize;
register_pci_controller(&sh5pci_controller);
return 0;
}
