int main(void) {
#if defined (__USE_LPCOPEN)
// Read clock settings and update SystemCoreClock variable
SystemCoreClockUpdate();
#endif
SwitchMatrix_Init();
IOCON_Init();
uart_init();
uart_setup();
shell_init(uart_get_char, uart_put_char);
gpio_init();
if (!shell_add_command("version", command_version)) {
uart_put_line("shell_add_command(version) error\n");
}
shell_set_prompt("\n$>");
shell_start(); /* no return */
return 0 ;
}
int main(void)
{
/* Initialise the GPIO block */
gpioInit();
/* Initialise the UART0 block for printf output */
//uart0Init(115200);
uart0Init(9600);
/* Configure the multi-rate timer for 1ms ticks */
mrtInit(__SYSTEM_CLOCK/1000);
/* Configure the switch matrix (setup pins for UART0 and GPIO) */
//configurePins();
spiInit(LPC_SPI0, 6, 0);
SwitchMatrix_Init(); //uart & spi
LPC_GPIO_PORT->DIR0 |= (1 << CSN);
LPC_GPIO_PORT->DIR0 |= (1 << CE);
uint8_t temp = 0;
nrf24_init();
/* Set the LED pin to output (1 = output, 0 = input) */
#if !defined(USE_SWD)
LPC_GPIO_PORT->DIR0 |= (1 << LED_LOCATION);
#endif
//printf("write");
mrtDelay(500);
nrf24_config(2,16);
#if TX_NODE
nrf24_tx_address(tx_address);
nrf24_rx_address(rx_address);
#else
nrf24_tx_address(rx_address); //backwards looking but is fine
nrf24_rx_address(tx_address);
#endif
uint8_t i = 0;
while(1)
{
/* Turn LED On by setting the GPIO pin high */
LPC_GPIO_PORT->SET0 = 1 << LED_LOCATION;
mrtDelay(500);
/* Turn LED Off by setting the GPIO pin low */
LPC_GPIO_PORT->CLR0 = 1 << LED_LOCATION;
mrtDelay(500);
/*
printf("Send\r\n");
for(i=0; i<16; i++){
printf("%d: %d\n\r", i, tx_data_array[i]);
}
*/
nrf24_send(tx_data_array);
while(nrf24_isSending());
nrf24_powerUpRx();
//done transmitting, set back to rx mode
for(i=0; i<16; i++){
tx_data_array[i]++;
}
/*
if(nrf24_dataReady()){
printf("\n\rGot data\n\r");
nrf24_getData(rx_data_array);
for(i=0; i<16; i++){
printf("%d: %d\n\r", i, rx_data_array[i]);
}
}
*/
}
}
