/** Removes access to the target's NVM controller and physically disables the target's physical TPI interface. */
void TINYNVM_DisableTPI(void)
{
TINYNVM_WaitWhileNVMBusBusy();
/* Clear the NVMEN bit in the TPI STATUS register to disable TPI mode */
XPROGTarget_SendByte(TPI_CMD_SSTCS | TPI_STATUS_REG);
XPROGTarget_SendByte(0x00);
XPROGTarget_DisableTargetTPI();
}
/** Removes access to the target's NVM controller and physically disables the target's physical TPI interface. */
void TINYNVM_DisableTPI(void)
{
TINYNVM_WaitWhileNVMBusBusy();
do
{
/* Clear the NVMEN bit in the TPI STATUS register to disable TPI mode */
XPROGTarget_SendByte(TPI_CMD_SSTCS | TPI_STATUS_REG);
XPROGTarget_SendByte(0x00);
/* Read back the STATUS register, check to see if it took effect */
XPROGTarget_SendByte(TPI_CMD_SLDCS | PDI_RESET_REG);
} while (XPROGTarget_ReceiveByte() != 0x00);
XPROGTarget_DisableTargetTPI();
}
/** Handler for the XPROG LEAVE_PROGMODE command to terminate the PDI programming connection with
* the attached device.
*/
static void XPROGProtocol_LeaveXPROGMode(void)
{
Endpoint_ClearOUT();
Endpoint_SelectEndpoint(AVRISP_DATA_IN_EPNUM);
Endpoint_SetEndpointDirection(ENDPOINT_DIR_IN);
if (XPROG_SelectedProtocol == XPRG_PROTOCOL_PDI)
{
XMEGANVM_WaitWhileNVMBusBusy();
/* Clear the RESET key in the RESET PDI register to allow the XMEGA to run */
XPROGTarget_SendByte(PDI_CMD_STCS | PDI_RESET_REG);
XPROGTarget_SendByte(0x00);
/* Do it twice to make sure it takes affect (silicon bug?) */
XPROGTarget_SendByte(PDI_CMD_STCS | PDI_RESET_REG);
XPROGTarget_SendByte(0x00);
XPROGTarget_DisableTargetPDI();
}
else
{
TINYNVM_WaitWhileNVMBusBusy();
/* Clear the NVMEN bit in the TPI CONTROL register to disable TPI mode */
XPROGTarget_SendByte(TPI_CMD_SSTCS | TPI_CTRL_REG);
XPROGTarget_SendByte(0x00);
XPROGTarget_DisableTargetTPI();
}
Endpoint_Write_Byte(CMD_XPROG);
Endpoint_Write_Byte(XPRG_CMD_LEAVE_PROGMODE);
Endpoint_Write_Byte(XPRG_ERR_OK);
Endpoint_ClearIN();
}