void ofxLibdc::setPosition(unsigned int left, unsigned int top) {
bool changed = left != this->left || top != this->top;
this->left = left;
this->top = top;
if(camera && changed) {
quantizePosition();
dc1394_format7_set_image_position(camera, videoMode, this->left, this->top);
}
}
// Note:
// the following was tested on a IIDC camera over USB therefore might not work as
// well on a camera over proper firewire transport
void FirewireVideo::init_format7_camera(
uint64_t guid, int dma_frames,
dc1394speed_t iso_speed,
dc1394video_mode_t video_mode,
float framerate,
uint32_t width, uint32_t height,
uint32_t left, uint32_t top, bool reset_at_boot
) {
if(video_mode< DC1394_VIDEO_MODE_FORMAT7_0)
throw VideoException("roi can be specified only for format7 modes");
camera = dc1394_camera_new (d, guid);
if (!camera)
throw VideoException("Failed to initialize camera");
// Attempt to stop camera if it is already running
dc1394switch_t is_iso_on = DC1394_OFF;
dc1394_video_get_transmission(camera, &is_iso_on);
if (is_iso_on==DC1394_ON) {
dc1394_video_set_transmission(camera, DC1394_OFF);
}
cout << "Using camera with GUID " << camera->guid << endl;
if(reset_at_boot){
dc1394_camera_reset(camera);
}
//-----------------------------------------------------------------------
// setup mode and roi
//-----------------------------------------------------------------------
if(iso_speed >= DC1394_ISO_SPEED_800)
{
err=dc1394_video_set_operation_mode(camera, DC1394_OPERATION_MODE_1394B);
if( err != DC1394_SUCCESS )
throw VideoException("Could not set DC1394_OPERATION_MODE_1394B");
}
err=dc1394_video_set_iso_speed(camera, iso_speed);
if( err != DC1394_SUCCESS )
throw VideoException("Could not set iso speed");
// check that the required mode is actually supported
dc1394format7mode_t format7_info;
err = dc1394_format7_get_mode_info(camera, video_mode, &format7_info);
if( err != DC1394_SUCCESS )
throw VideoException("Could not get format7 mode info");
// safely set the video mode
err=dc1394_video_set_mode(camera, video_mode);
if( err != DC1394_SUCCESS )
throw VideoException("Could not set format7 video mode");
// set position to 0,0 so that setting any size within min and max is a valid command
err = dc1394_format7_set_image_position(camera, video_mode,0,0);
if( err != DC1394_SUCCESS )
throw VideoException("Could not set format7 image position");
// work out the desired image size
width = nearest_value(width, format7_info.unit_pos_x, 0, format7_info.max_size_x - left);
height = nearest_value(height, format7_info.unit_pos_y, 0, format7_info.max_size_y - top);
// set size
err = dc1394_format7_set_image_size(camera,video_mode,width,height);
if( err != DC1394_SUCCESS )
throw VideoException("Could not set format7 size");
// get the info again since many parameters depend on image size
err = dc1394_format7_get_mode_info(camera, video_mode, &format7_info);
if( err != DC1394_SUCCESS )
throw VideoException("Could not get format7 mode info");
// work out position of roi
left = nearest_value(left, format7_info.unit_size_x, format7_info.unit_size_x, format7_info.max_size_x - width);
top = nearest_value(top, format7_info.unit_size_y, format7_info.unit_size_y, format7_info.max_size_y - height);
// set roi position
err = dc1394_format7_set_image_position(camera,video_mode,left,top);
if( err != DC1394_SUCCESS )
throw VideoException("Could not set format7 size");
this->width = width;
this->height = height;
this->top = top;
this->left = left;
cout<<"roi: "<<left<<" "<<top<<" "<<width<<" "<<height<<" ";
//-----------------------------------------------------------------------
// setup frame rate
//-----------------------------------------------------------------------
err=dc1394_format7_set_packet_size(camera,video_mode, format7_info.max_packet_size);
if( err != DC1394_SUCCESS )
throw VideoException("Could not set format7 packet size");
if((framerate != MAX_FR) && (framerate != EXT_TRIG)){
//set the framerate by using the absolute feature as suggested by the
//folks at PointGrey
err = dc1394_feature_set_absolute_control(camera,DC1394_FEATURE_FRAME_RATE,DC1394_ON);
if( err != DC1394_SUCCESS )
throw VideoException("Could not turn on absolute frame rate control");
err = dc1394_feature_set_mode(camera,DC1394_FEATURE_FRAME_RATE,DC1394_FEATURE_MODE_MANUAL);
if( err != DC1394_SUCCESS )
throw VideoException("Could not make frame rate manual ");
err=dc1394_feature_set_absolute_value(camera,DC1394_FEATURE_FRAME_RATE,framerate);
if( err != DC1394_SUCCESS )
throw VideoException("Could not set format7 framerate ");
}
// ask the camera what is the resulting framerate (this assume that such a rate is actually
// allowed by the shutter time)
float value;
err=dc1394_feature_get_absolute_value(camera,DC1394_FEATURE_FRAME_RATE,&value);
if( err != DC1394_SUCCESS )
throw VideoException("Could not get framerate");
cout<<" framerate(shutter permitting):"<<value<<endl;
//-----------------------------------------------------------------------
// setup capture
//-----------------------------------------------------------------------
err=dc1394_capture_setup(camera,dma_frames, DC1394_CAPTURE_FLAGS_DEFAULT);
if( err != DC1394_SUCCESS )
throw VideoException("Could not setup camera - check settings");
Start();
}
// Note:
// the following was tested on a IIDC camera over USB therefore might not work as
// well on a camera over proper firewire transport
void FirewireVideo::init_format7_camera(
uint64_t guid, int dma_frames,
dc1394speed_t iso_speed,
dc1394video_mode_t video_mode,
int framerate,
uint32_t width, uint32_t height,
uint32_t left, uint32_t top, bool reset_at_boot
) {
if(video_mode< DC1394_VIDEO_MODE_FORMAT7_0)
throw VideoException("roi can be specified only for format7 modes");
camera = dc1394_camera_new (d, guid);
if (!camera)
throw VideoException("Failed to initialize camera");
// Attempt to stop camera if it is already running
dc1394switch_t is_iso_on = DC1394_OFF;
dc1394_video_get_transmission(camera, &is_iso_on);
if (is_iso_on==DC1394_ON) {
dc1394_video_set_transmission(camera, DC1394_OFF);
}
cout << "Using camera with GUID " << camera->guid << endl;
if(reset_at_boot){
dc1394_camera_reset(camera);
}
//-----------------------------------------------------------------------
// setup mode and roi
//-----------------------------------------------------------------------
if(iso_speed >= DC1394_ISO_SPEED_800)
{
err=dc1394_video_set_operation_mode(camera, DC1394_OPERATION_MODE_1394B);
if( err != DC1394_SUCCESS )
throw VideoException("Could not set DC1394_OPERATION_MODE_1394B");
}
err=dc1394_video_set_iso_speed(camera, iso_speed);
if( err != DC1394_SUCCESS )
throw VideoException("Could not set iso speed");
// check that the required mode is actually supported
dc1394format7mode_t format7_info;
err = dc1394_format7_get_mode_info(camera, video_mode, &format7_info);
if( err != DC1394_SUCCESS )
throw VideoException("Could not get format7 mode info");
// safely set the video mode
err=dc1394_video_set_mode(camera, video_mode);
if( err != DC1394_SUCCESS )
throw VideoException("Could not set format7 video mode");
// set position to 0,0 so that setting any size within min and max is a valid command
err = dc1394_format7_set_image_position(camera, video_mode,0,0);
if( err != DC1394_SUCCESS )
throw VideoException("Could not set format7 image position");
// work out the desired image size
width = nearest_value(width, format7_info.unit_pos_x, 0, format7_info.max_size_x - left);
height = nearest_value(height, format7_info.unit_pos_y, 0, format7_info.max_size_y - top);
// set size
err = dc1394_format7_set_image_size(camera,video_mode,width,height);
if( err != DC1394_SUCCESS )
throw VideoException("Could not set format7 size");
// get the info again since many parameters depend on image size
err = dc1394_format7_get_mode_info(camera, video_mode, &format7_info);
if( err != DC1394_SUCCESS )
throw VideoException("Could not get format7 mode info");
// work out position of roi
left = nearest_value(left, format7_info.unit_size_x, format7_info.unit_size_x, format7_info.max_size_x - width);
top = nearest_value(top, format7_info.unit_size_y, format7_info.unit_size_y, format7_info.max_size_y - height);
// set roi position
err = dc1394_format7_set_image_position(camera,video_mode,left,top);
if( err != DC1394_SUCCESS )
throw VideoException("Could not set format7 size");
this->width = width;
this->height = height;
this->top = top;
this->left = left;
cout<<"roi: "<<left<<" "<<top<<" "<<width<<" "<<height<<" ";
//-----------------------------------------------------------------------
// setup frame rate
//-----------------------------------------------------------------------
if((framerate == MAX_FR)||(framerate == EXT_TRIG)){
err=dc1394_format7_set_packet_size(camera,video_mode, format7_info.max_packet_size);
if( err != DC1394_SUCCESS )
throw VideoException("Could not set format7 packet size");
} else {
// setting packet size to get the desired frame rate according to the libdc docs
// does not do the trick, so for now we support only max frame rate
throw VideoException("In format 7 only max frame rate is currently supported");
// uint32_t depth;
// err = dc1394_format7_get_data_depth(camera, video_mode, &depth);
// if( err != DC1394_SUCCESS )
// throw VideoException("Could not get format7 depth");
//
// // the following is straight from the libdc docs
// double bus_period = bus_period_from_iso_speed(iso_speed);
//
// // work out the max number of packets that the bus can deliver
// int num_packets = (int) (1.0/(bus_period*framerate) + 0.5);
//
// if((num_packets > 4095)||(num_packets < 0))
// throw VideoException("number of format7 packets out of range");
//
// // work out what the packet size should be for the requested size and framerate
// uint32_t packet_size = (width*964*depth + (num_packets*8) - 1)/(num_packets*8);
// packet_size = nearest_value(packet_size,format7_info.unit_packet_size,format7_info.unit_packet_size,format7_info.max_packet_size);
//
// if(packet_size > format7_info.max_packet_size){
// throw VideoException("format7 requested frame rate and size exceed bus bandwidth");
// }
//
// err=dc1394_format7_set_packet_size(camera,video_mode, packet_size);
// if( err != DC1394_SUCCESS ){
// throw VideoException("Could not set format7 packet size");
// }
}
// ask the camera what is the resulting framerate (this assume that such a rate is actually
// allowed by the shutter time)
err = dc1394_feature_set_power(camera,DC1394_FEATURE_FRAME_RATE,DC1394_OFF);
if( err != DC1394_SUCCESS )
throw VideoException("Could not turn off frame rate");
float value;
err=dc1394_feature_get_absolute_value(camera,DC1394_FEATURE_FRAME_RATE,&value);
if( err != DC1394_SUCCESS )
throw VideoException("Could not get framerate");
cout<<" framerate(shutter permitting):"<<value<<endl;
//-----------------------------------------------------------------------
// setup capture
//-----------------------------------------------------------------------
err=dc1394_capture_setup(camera,dma_frames, DC1394_CAPTURE_FLAGS_DEFAULT);
if( err != DC1394_SUCCESS )
throw VideoException("Could not setup camera - check settings");
Start();
}
