void set_dma_mde_base(dmach_t channel, const char *mde_vaddr)
{
struct arch_dma_t *arch_dma;
dma_t *dma;
if (channel >= MAX_DMA_CHANNELS) {
printk(KERN_ERR "Invalid dma channel %d\n", channel);
return;
}
if (((unsigned long)mde_vaddr) & 0x03) {
printk(KERN_ERR "set channel %d mde, invalid mde_base address %p (must alignment 4 bytes)\n",
channel, mde_vaddr);
return;
}
arch_dma = &arch_dma_chan[channel];
dma = arch_dma->dma;
if (dma->active) {
printk(KERN_ERR "dma%d: altering DMA mde while DMA active\n", channel);
}
dma->using_sg = 1;
dma->prolific_sg = 1; /* using mde insead of sg */
arch_dma->mde = (dma_mdt_t *)mde_vaddr;
dma_writeb(0, DMA_IDX_REG, channel);
dma_writel((unsigned int) virt_to_bus(&arch_dma->mde[0]), DMA_MDT_REG, channel);
}
static void ar231x_reset_regs(struct eth_device *edev)
{
struct ar231x_eth_priv *priv = edev->priv;
struct ar231x_eth_platform_data *cfg = priv->cfg;
u32 flags;
ar231x_reset_bit_(priv, cfg->reset_mac, SET);
mdelay(10);
ar231x_reset_bit_(priv, cfg->reset_mac, REMOVE);
mdelay(10);
ar231x_reset_bit_(priv, cfg->reset_phy, SET);
mdelay(10);
ar231x_reset_bit_(priv, cfg->reset_phy, REMOVE);
mdelay(10);
dma_writel(priv, DMA_BUS_MODE_SWR, AR231X_DMA_BUS_MODE);
mdelay(10);
dma_writel(priv, ((32 << DMA_BUS_MODE_PBL_SHIFT) | DMA_BUS_MODE_BLE),
AR231X_DMA_BUS_MODE);
/* FIXME: priv->{t,r}x_ring are virtual addresses,
* use virt-to-phys convertion */
dma_writel(priv, (u32)priv->tx_ring, AR231X_DMA_TX_RING);
dma_writel(priv, (u32)priv->rx_ring, AR231X_DMA_RX_RING);
dma_writel(priv, (DMA_CONTROL_SR | DMA_CONTROL_ST | DMA_CONTROL_SF),
AR231X_DMA_CONTROL);
eth_writel(priv, FLOW_CONTROL_FCE, AR231X_ETH_FLOW_CONTROL);
/* TODO: not sure if we need it here. */
eth_writel(priv, 0x8100, AR231X_ETH_VLAN_TAG);
/* Enable Ethernet Interface */
flags = (MAC_CONTROL_TE | /* transmit enable */
/* FIXME: MAC_CONTROL_PM - pass mcast.
* Seems like it makes no difference on some WiSoCs,
* for example ar2313.
* It should be tested on ar231[5,6,7] */
MAC_CONTROL_PM |
MAC_CONTROL_F | /* full duplex */
MAC_CONTROL_HBD); /* heart beat disabled */
eth_writel(priv, flags, AR231X_ETH_MAC_CONTROL);
}
static int imapx200_dma_start(struct imapx200_dma_chan *chan)
{
struct imapx200_dmac *dmac= chan->dmac;
u32 bit = chan->bit;
pr_debug("%s: clearing interrupts\n", __func__);
/* clear interrupts */
dma_writel(dmac,CLEAR.XFER ,bit);
dma_writel(dmac,CLEAR.ERROR ,bit);
pr_debug("%s: starting channel\n", __func__);
//enable dma channel
dma_set_bit(dmac,CH_EN,bit);
return 0;
}
static void pl_enable_dma(dmach_t channel, dma_t *dma)
{
unsigned char val;
struct arch_dma_t *arch_dma;
int count;
int i;
unsigned int dcnt = 0;
if (channel >= MAX_DMA_CHANNELS) {
printk(KERN_ERR "Invalid dma channel %d\n", channel);
return;
}
arch_dma = &arch_dma_chan[channel];
if (dma->using_sg == 0) {
if (arch_dma->mde == NULL) {
arch_dma->mde = arch_dma->mde_default;
}
arch_dma->mde[0].saddr = (unsigned int)virt_to_bus(dma->buf.address);
count = dma->buf.length;
if (count > MAX_DMA_MDT * MAX_DMA_MDT_COUNT) {
printk(KERN_ERR "Exceed max transfer size %d\n", count);
return;
}
for (i = 0; i < MAX_DMA_MDT; i++) {
if (i > 0) {
arch_dma->mde[i].saddr = arch_dma->mde[i-1].saddr + dcnt;
}
if (count > MAX_DMA_MDT_COUNT)
dcnt = MAX_DMA_MDT_COUNT;
else
dcnt = count;
count -= dcnt;
arch_dma->mde[i].flag = dcnt | ((i+1) << MDT_FLAG_NXT_SHIFT) | MDT_FLAG_V;
if (count == 0)
break;
}
arch_dma->mde[i].flag |= MDT_FLAG_E;
dma_writeb(0, DMA_IDX_REG, channel);
dma_writel((unsigned int) virt_to_bus(arch_dma->mde), DMA_MDT_REG, channel);
pci_map_single(NULL, arch_dma->mde, MAX_DMA_MDT*sizeof(dma_mdt_t), PCI_DMA_TODEVICE);
} else {
if (dma->prolific_sg) {
/* do nothing */
} else {
/* TBD */
printk(KERN_ERR "Not implement yet!!!!");
return;
}
}
val = dma_readb(DMA_CMD_REG, channel);
if (dma->dma_mode == DMA_MODE_READ)
val |= DMA_MODE_UPSTREAM;
else
val &= ~DMA_MODE_UPSTREAM;
dma_writeb(val | DMA_CHN_ENABLE, DMA_CMD_REG, channel);
}
static int imapx200_dma_init_xxx(int chno, int dma_ch,
int irq, unsigned int base)
{
struct imapx200_dma_chan *chptr = &imapx200_chans[chno];
struct imapx200_dmac *dmac;
char clkname[16];
void __iomem *regs;
void __iomem *regptr;
int err, ch;
dmac = kzalloc(sizeof(struct imapx200_dmac), GFP_KERNEL);
if (!dmac) {
printk(KERN_ERR "%s: failed to alloc mem\n", __func__);
return -ENOMEM;
}
dmac->sysdev.id = chno / 8;
dmac->sysdev.cls = &dma_sysclass;
err = sysdev_register(&dmac->sysdev);
if (err) {
printk(KERN_ERR "%s: failed to register sysdevice\n", __func__);
goto err_alloc;
}
regs = ioremap(base, DW_REGLEN);
if (!regs) {
printk(KERN_ERR "%s: failed to ioremap()\n", __func__);
err = -ENXIO;
goto err_dev;
}
snprintf(clkname, sizeof(clkname), "dma%d", dmac->sysdev.id);
/*
dmac->clk = clk_get(NULL, clkname);
if (IS_ERR(dmac->clk)) {
printk(KERN_ERR "%s: failed to get clock %s\n", __func__, clkname);
err = PTR_ERR(dmac->clk);
goto err_map;
}
clk_enable(dmac->clk);
*/
dmac->regs = regs;
dmac->dma_ch = dma_ch;
dmac->channels = chptr;
err = request_irq(irq, imapx200_dma_irq, 0, "DMA", dmac);
if (err < 0) {
printk(KERN_ERR "%s: failed to get irq\n", __func__);
goto err_clk;
}
regptr = regs + (0);
for (ch = 0; ch < 8; ch++, chno++, chptr++) {
printk(KERN_INFO "%s: registering DMA %d (%p)\n",
__func__, chno, regptr);
chptr->bit = 1 << ch;
chptr->number = chno;
chptr->regs = regptr;
regptr += DW_CH_STRIDE;
dma_clear_bit(dmac,CH_EN,chptr->bit);
}
/* for the moment, permanently enable the controller */
dma_writel(dmac, CFG, DW_CFG_DMA_EN);
printk(KERN_INFO "DW: IRQ %d, at %p\n", irq, regs);
return 0;
err_clk:
clk_disable(dmac->clk);
clk_put(dmac->clk);
err_map:
iounmap(regs);
err_dev:
sysdev_unregister(&dmac->sysdev);
err_alloc:
kfree(dmac);
return err;
}
