void rcar_swdt_exec(uint64_t p)
{
gicv2_end_of_interrupt(ARM_IRQ_SEC_WDT);
rcar_swdt_release();
ERROR("\n");
ERROR("System WDT overflow, occured address is %p\n", (void *)p);
panic();
}
void bl2_interrupt_error_id(uint32_t int_id)
{
ERROR("\n");
if (int_id >= SWDT_ERROR_ID) {
ERROR("Unhandled exception occurred.\n");
ERROR(" Exception type = FIQ_SP_ELX\n");
panic();
}
/* Clear the interrupt request */
gicv2_end_of_interrupt((uint32_t) int_id);
rcar_swdt_release();
ERROR("Unhandled exception occurred.\n");
ERROR(" Exception type = FIQ_SP_ELX\n");
ERROR(" SPSR_EL1 = 0x%x\n", (uint32_t) read_spsr_el1());
ERROR(" ELR_EL1 = 0x%x\n", (uint32_t) read_elr_el1());
ERROR(" ESR_EL1 = 0x%x\n", (uint32_t) read_esr_el1());
ERROR(" FAR_EL1 = 0x%x\n", (uint32_t) read_far_el1());
ERROR("\n");
panic();
}
/*******************************************************************************
* STM32MP1 handler called when a CPU is about to enter standby.
* call by core 1 to enter in wfi
******************************************************************************/
static void stm32_cpu_standby(plat_local_state_t cpu_state)
{
uint32_t interrupt = GIC_SPURIOUS_INTERRUPT;
assert(cpu_state == ARM_LOCAL_STATE_RET);
/*
* Enter standby state
* dsb is good practice before using wfi to enter low power states
*/
dsb();
while (interrupt == GIC_SPURIOUS_INTERRUPT) {
wfi();
/* Acknoledge IT */
interrupt = gicv2_acknowledge_interrupt();
/* If Interrupt == 1022 it will be acknowledged by non secure */
if ((interrupt != PENDING_G1_INTID) &&
(interrupt != GIC_SPURIOUS_INTERRUPT)) {
gicv2_end_of_interrupt(interrupt);
}
}
}
/*
* This functions is used to indicate to the interrupt controller that
* the processing of the interrupt corresponding to the `id` has
* finished.
*/
void plat_ic_end_of_interrupt(uint32_t id)
{
gicv2_end_of_interrupt(id);
}