/**
* iwl_scan_cancel_timeout - Cancel any currently executing HW scan
* @ms: amount of time to wait (in milliseconds) for scan to abort
*
* NOTE: priv->mutex must be held before calling this function
*/
int iwl_scan_cancel_timeout(struct iwl_priv *priv, unsigned long ms)
{
unsigned long now = jiffies;
int ret;
ret = iwl_scan_cancel(priv);
if (ret && ms) {
mutex_unlock(&priv->mutex);
while (!time_after(jiffies, now + msecs_to_jiffies(ms)) &&
test_bit(STATUS_SCANNING, &priv->status))
msleep(1);
mutex_lock(&priv->mutex);
return test_bit(STATUS_SCANNING, &priv->status);
}
return ret;
}
void iwl_update_tkip_key(struct iwl_priv *priv,
struct ieee80211_vif *vif,
struct ieee80211_key_conf *keyconf,
struct ieee80211_sta *sta, u32 iv32, u16 *phase1key)
{
u8 sta_id = iwlagn_key_sta_id(priv, vif, sta);
if (sta_id == IWL_INVALID_STATION)
return;
if (iwl_scan_cancel(priv)) {
/* cancel scan failed, just live w/ bad key and rely
briefly on SW decryption */
return;
}
iwlagn_send_sta_key(priv, keyconf, sta_id,
iv32, phase1key, CMD_ASYNC);
}
/*
* CARD_STATE_CMD
*
* Use: Sets the device's internal card state to enable, disable, or halt
*
* When in the 'enable' state the card operates as normal.
* When in the 'disable' state, the card enters into a low power mode.
* When in the 'halt' state, the card is shut down and must be fully
* restarted to come back on.
*/
static int iwl_send_card_state(struct iwl_priv *priv, u32 flags, u8 meta_flag)
{
struct iwl_host_cmd cmd = {
.id = REPLY_CARD_STATE_CMD,
.len = sizeof(u32),
.data = &flags,
.meta.flags = meta_flag,
};
return iwl_send_cmd(priv, &cmd);
}
void iwl_radio_kill_sw_disable_radio(struct iwl_priv *priv)
{
unsigned long flags;
if (test_bit(STATUS_RF_KILL_SW, &priv->status))
return;
IWL_DEBUG_RF_KILL("Manual SW RF KILL set to: RADIO OFF\n");
iwl_scan_cancel(priv);
/* FIXME: This is a workaround for AP */
if (priv->iw_mode != NL80211_IFTYPE_AP) {
spin_lock_irqsave(&priv->lock, flags);
iwl_write32(priv, CSR_UCODE_DRV_GP1_SET,
CSR_UCODE_SW_BIT_RFKILL);
spin_unlock_irqrestore(&priv->lock, flags);
/* call the host command only if no hw rf-kill set */
if (!test_bit(STATUS_RF_KILL_HW, &priv->status) &&
iwl_is_ready(priv))
iwl_send_card_state(priv,
CARD_STATE_CMD_DISABLE, 0);
set_bit(STATUS_RF_KILL_SW, &priv->status);
/* make sure mac80211 stop sending Tx frame */
if (priv->mac80211_registered)
ieee80211_stop_queues(priv->hw);
}
}
