static int
mpssas_add_device(struct mps_softc *sc, u16 handle, u8 linkrate){
char devstring[80];
struct mpssas_softc *sassc;
struct mpssas_target *targ;
Mpi2ConfigReply_t mpi_reply;
Mpi2SasDevicePage0_t config_page;
uint64_t sas_address, sata_sas_address;
uint64_t parent_sas_address = 0;
u16 ioc_pg8_flags = le16toh(sc->ioc_pg8.Flags);
u32 device_info, parent_devinfo = 0;
unsigned int id;
int ret;
int error = 0;
sassc = sc->sassc;
mpssas_startup_increment(sassc);
if ((mps_config_get_sas_device_pg0(sc, &mpi_reply, &config_page,
MPI2_SAS_DEVICE_PGAD_FORM_HANDLE, handle))) {
kprintf("%s: error reading SAS device page0\n", __func__);
error = ENXIO;
goto out;
}
device_info = le32toh(config_page.DeviceInfo);
if (((device_info & MPI2_SAS_DEVICE_INFO_SMP_TARGET) == 0)
&& (config_page.ParentDevHandle != 0)) {
Mpi2ConfigReply_t tmp_mpi_reply;
Mpi2SasDevicePage0_t parent_config_page;
if ((mps_config_get_sas_device_pg0(sc, &tmp_mpi_reply,
&parent_config_page, MPI2_SAS_DEVICE_PGAD_FORM_HANDLE,
le16toh(config_page.ParentDevHandle)))) {
kprintf("%s: error reading SAS device %#x page0\n",
__func__, le16toh(config_page.ParentDevHandle));
} else {
parent_sas_address = parent_config_page.SASAddress.High;
parent_sas_address = (parent_sas_address << 32) |
parent_config_page.SASAddress.Low;
parent_devinfo = le32toh(parent_config_page.DeviceInfo);
}
}
/* TODO Check proper endianess */
sas_address = config_page.SASAddress.High;
sas_address = (sas_address << 32) |
config_page.SASAddress.Low;
if ((ioc_pg8_flags & MPI2_IOCPAGE8_FLAGS_MASK_MAPPING_MODE)
== MPI2_IOCPAGE8_FLAGS_DEVICE_PERSISTENCE_MAPPING) {
if (device_info & MPI2_SAS_DEVICE_INFO_SATA_DEVICE) {
ret = mpssas_get_sas_address_for_sata_disk(sc,
&sata_sas_address, handle, device_info);
if (!ret)
id = mps_mapping_get_sas_id(sc,
sata_sas_address, handle);
else
id = mps_mapping_get_sas_id(sc,
sas_address, handle);
} else
id = mps_mapping_get_sas_id(sc, sas_address,
handle);
} else
id = mps_mapping_get_sas_id(sc, sas_address, handle);
if (id == MPS_MAP_BAD_ID) {
kprintf("failure at %s:%d/%s()! Could not get ID for device "
"with handle 0x%04x\n", __FILE__, __LINE__, __func__,
handle);
error = ENXIO;
goto out;
}
mps_vprintf(sc, "SAS Address from SAS device page0 = %jx\n",
sas_address);
targ = &sassc->targets[id];
targ->devinfo = device_info;
targ->devname = le32toh(config_page.DeviceName.High);
targ->devname = (targ->devname << 32) |
le32toh(config_page.DeviceName.Low);
targ->encl_handle = le16toh(config_page.EnclosureHandle);
targ->encl_slot = le16toh(config_page.Slot);
targ->handle = handle;
targ->parent_handle = le16toh(config_page.ParentDevHandle);
targ->sasaddr = mps_to_u64(&config_page.SASAddress);
targ->parent_sasaddr = le64toh(parent_sas_address);
targ->parent_devinfo = parent_devinfo;
targ->tid = id;
targ->linkrate = (linkrate>>4);
targ->flags = 0;
TAILQ_INIT(&targ->commands);
TAILQ_INIT(&targ->timedout_commands);
SLIST_INIT(&targ->luns);
mps_describe_devinfo(targ->devinfo, devstring, 80);
mps_vprintf(sc, "Found device <%s> <%s> <0x%04x> <%d/%d>\n", devstring,
mps_describe_table(mps_linkrate_names, targ->linkrate),
targ->handle, targ->encl_handle, targ->encl_slot);
if ((sassc->flags & MPSSAS_IN_STARTUP) == 0)
mpssas_rescan_target(sc, targ);
mps_vprintf(sc, "Target id 0x%x added\n", targ->tid);
out:
mpssas_startup_decrement(sassc);
return (error);
}
static int
mpssas_add_device(struct mps_softc *sc, u16 handle, u8 linkrate){
char devstring[80];
struct mpssas_softc *sassc;
struct mpssas_target *targ;
Mpi2ConfigReply_t mpi_reply;
Mpi2SasDevicePage0_t config_page;
uint64_t sas_address;
uint64_t parent_sas_address = 0;
u32 device_info, parent_devinfo = 0;
unsigned int id;
int ret = 1, error = 0, i;
struct mpssas_lun *lun;
u8 is_SATA_SSD = 0;
struct mps_command *cm;
sassc = sc->sassc;
mpssas_startup_increment(sassc);
if ((mps_config_get_sas_device_pg0(sc, &mpi_reply, &config_page,
MPI2_SAS_DEVICE_PGAD_FORM_HANDLE, handle))) {
printf("%s: error reading SAS device page0\n", __func__);
error = ENXIO;
goto out;
}
device_info = le32toh(config_page.DeviceInfo);
if (((device_info & MPI2_SAS_DEVICE_INFO_SMP_TARGET) == 0)
&& (le16toh(config_page.ParentDevHandle) != 0)) {
Mpi2ConfigReply_t tmp_mpi_reply;
Mpi2SasDevicePage0_t parent_config_page;
if ((mps_config_get_sas_device_pg0(sc, &tmp_mpi_reply,
&parent_config_page, MPI2_SAS_DEVICE_PGAD_FORM_HANDLE,
le16toh(config_page.ParentDevHandle)))) {
printf("%s: error reading SAS device %#x page0\n",
__func__, le16toh(config_page.ParentDevHandle));
} else {
parent_sas_address = parent_config_page.SASAddress.High;
parent_sas_address = (parent_sas_address << 32) |
parent_config_page.SASAddress.Low;
parent_devinfo = le32toh(parent_config_page.DeviceInfo);
}
}
/* TODO Check proper endianess */
sas_address = config_page.SASAddress.High;
sas_address = (sas_address << 32) | config_page.SASAddress.Low;
/*
* Always get SATA Identify information because this is used to
* determine if Start/Stop Unit should be sent to the drive when the
* system is shutdown.
*/
if (device_info & MPI2_SAS_DEVICE_INFO_SATA_DEVICE) {
ret = mpssas_get_sas_address_for_sata_disk(sc, &sas_address,
handle, device_info, &is_SATA_SSD);
if (ret) {
mps_dprint(sc, MPS_INFO, "%s: failed to get disk type "
"(SSD or HDD) for SATA device with handle 0x%04x\n",
__func__, handle);
} else {
mps_dprint(sc, MPS_INFO, "SAS Address from SATA "
"device = %jx\n", sas_address);
}
}
id = mps_mapping_get_sas_id(sc, sas_address, handle);
if (id == MPS_MAP_BAD_ID) {
printf("failure at %s:%d/%s()! Could not get ID for device "
"with handle 0x%04x\n", __FILE__, __LINE__, __func__,
handle);
error = ENXIO;
goto out;
}
if (mpssas_check_id(sassc, id) != 0) {
device_printf(sc->mps_dev, "Excluding target id %d\n", id);
error = ENXIO;
goto out;
}
mps_dprint(sc, MPS_MAPPING, "SAS Address from SAS device page0 = %jx\n",
sas_address);
targ = &sassc->targets[id];
targ->devinfo = device_info;
targ->devname = le32toh(config_page.DeviceName.High);
targ->devname = (targ->devname << 32) |
le32toh(config_page.DeviceName.Low);
targ->encl_handle = le16toh(config_page.EnclosureHandle);
targ->encl_slot = le16toh(config_page.Slot);
targ->handle = handle;
targ->parent_handle = le16toh(config_page.ParentDevHandle);
targ->sasaddr = mps_to_u64(&config_page.SASAddress);
targ->parent_sasaddr = le64toh(parent_sas_address);
targ->parent_devinfo = parent_devinfo;
targ->tid = id;
targ->linkrate = (linkrate>>4);
targ->flags = 0;
if (is_SATA_SSD) {
targ->flags = MPS_TARGET_IS_SATA_SSD;
}
TAILQ_INIT(&targ->commands);
TAILQ_INIT(&targ->timedout_commands);
while(!SLIST_EMPTY(&targ->luns)) {
lun = SLIST_FIRST(&targ->luns);
SLIST_REMOVE_HEAD(&targ->luns, lun_link);
free(lun, M_MPT2);
}
SLIST_INIT(&targ->luns);
mps_describe_devinfo(targ->devinfo, devstring, 80);
mps_dprint(sc, MPS_MAPPING, "Found device <%s> <%s> <0x%04x> <%d/%d>\n",
devstring, mps_describe_table(mps_linkrate_names, targ->linkrate),
targ->handle, targ->encl_handle, targ->encl_slot);
#if __FreeBSD_version < 1000039
if ((sassc->flags & MPSSAS_IN_STARTUP) == 0)
#endif
mpssas_rescan_target(sc, targ);
mps_dprint(sc, MPS_MAPPING, "Target id 0x%x added\n", targ->tid);
/*
* Check all commands to see if the SATA_ID_TIMEOUT flag has been set.
* If so, send a Target Reset TM to the target that was just created.
* An Abort Task TM should be used instead of a Target Reset, but that
* would be much more difficult because targets have not been fully
* discovered yet, and LUN's haven't been setup. So, just reset the
* target instead of the LUN.
*/
for (i = 1; i < sc->num_reqs; i++) {
cm = &sc->commands[i];
if (cm->cm_flags & MPS_CM_FLAGS_SATA_ID_TIMEOUT) {
targ->timeouts++;
cm->cm_state = MPS_CM_STATE_TIMEDOUT;
if ((targ->tm = mpssas_alloc_tm(sc)) != NULL) {
mps_dprint(sc, MPS_INFO, "%s: sending Target "
"Reset for stuck SATA identify command "
"(cm = %p)\n", __func__, cm);
targ->tm->cm_targ = targ;
mpssas_send_reset(sc, targ->tm,
MPI2_SCSITASKMGMT_TASKTYPE_TARGET_RESET);
} else {
mps_dprint(sc, MPS_ERROR, "Failed to allocate "
"tm for Target Reset after SATA ID command "
"timed out (cm %p)\n", cm);
}
/*
* No need to check for more since the target is
* already being reset.
*/
break;
}
}
out:
/*
* Free the commands that may not have been freed from the SATA ID call
*/
for (i = 1; i < sc->num_reqs; i++) {
cm = &sc->commands[i];
if (cm->cm_flags & MPS_CM_FLAGS_SATA_ID_TIMEOUT) {
mps_free_command(sc, cm);
}
}
mpssas_startup_decrement(sassc);
return (error);
}
