Пример #1
0
int mt76x2_register_device(struct mt76x02_dev *dev)
{
	int ret;

	INIT_DELAYED_WORK(&dev->cal_work, mt76x2_phy_calibrate);

	mt76x02_init_device(dev);

	ret = mt76x2_init_hardware(dev);
	if (ret)
		return ret;

	mt76x02_config_mac_addr_list(dev);

	ret = mt76_register_device(&dev->mt76, true, mt76x02_rates,
				   ARRAY_SIZE(mt76x02_rates));
	if (ret)
		goto fail;

	mt76x02_init_debugfs(dev);
	mt76x2_init_txpower(dev, &dev->mt76.sband_2g.sband);
	mt76x2_init_txpower(dev, &dev->mt76.sband_5g.sband);

	return 0;

fail:
	mt76x2_stop_hardware(dev);
	return ret;
}
Пример #2
0
int mt76x2_register_device(struct mt76x2_dev *dev)
{
	struct ieee80211_hw *hw = mt76_hw(dev);
	struct wiphy *wiphy = hw->wiphy;
	void *status_fifo;
	int fifo_size;
	int i, ret;

	fifo_size = roundup_pow_of_two(32 * sizeof(struct mt76x2_tx_status));
	status_fifo = devm_kzalloc(dev->mt76.dev, fifo_size, GFP_KERNEL);
	if (!status_fifo)
		return -ENOMEM;

	kfifo_init(&dev->txstatus_fifo, status_fifo, fifo_size);
	INIT_DELAYED_WORK(&dev->cal_work, mt76x2_phy_calibrate);
	INIT_DELAYED_WORK(&dev->mac_work, mt76x2_mac_work);

	mt76x2_init_device(dev);

	ret = mt76x2_init_hardware(dev);
	if (ret)
		return ret;

	for (i = 0; i < ARRAY_SIZE(dev->macaddr_list); i++) {
		u8 *addr = dev->macaddr_list[i].addr;

		memcpy(addr, dev->mt76.macaddr, ETH_ALEN);

		if (!i)
			continue;

		addr[0] |= BIT(1);
		addr[0] ^= ((i - 1) << 2);
	}
	wiphy->addresses = dev->macaddr_list;
	wiphy->n_addresses = ARRAY_SIZE(dev->macaddr_list);

	wiphy->iface_combinations = if_comb;
	wiphy->n_iface_combinations = ARRAY_SIZE(if_comb);

	wiphy->reg_notifier = mt76x2_regd_notifier;

	wiphy->interface_modes =
		BIT(NL80211_IFTYPE_STATION) |
		BIT(NL80211_IFTYPE_AP) |
#ifdef CONFIG_MAC80211_MESH
		BIT(NL80211_IFTYPE_MESH_POINT) |
#endif
		BIT(NL80211_IFTYPE_ADHOC);

	wiphy_ext_feature_set(wiphy, NL80211_EXT_FEATURE_VHT_IBSS);

	mt76x2_dfs_init_detector(dev);

	/* init led callbacks */
	dev->mt76.led_cdev.brightness_set = mt76x2_led_set_brightness;
	dev->mt76.led_cdev.blink_set = mt76x2_led_set_blink;

	ret = mt76_register_device(&dev->mt76, true, mt76x2_rates,
				   ARRAY_SIZE(mt76x2_rates));
	if (ret)
		goto fail;

	mt76x2_init_debugfs(dev);
	mt76x2_init_txpower(dev, &dev->mt76.sband_2g.sband);
	mt76x2_init_txpower(dev, &dev->mt76.sband_5g.sband);

	return 0;

fail:
	mt76x2_stop_hardware(dev);
	return ret;
}