static void enable_parallel_programming(void) // TODO
{
#if 1
PGMW1 &= ~(PAGEL | XA1 | XA0 | BS1);
read_switch();
// Applied +5V & +12V
erase_chip();
write_fuse(0, 0x99E0);
#else
_delay_us(100);
PGMW2 &= ~RESETb;
xtal1_pulse();
xtal1_pulse();
xtal1_pulse();
PGMW1 &= ~(PAGEL | XA1 | XA0 | BS1);
_delay_us(1);
read_switch();
apply_high_voltage_to_reset();
_delay_us(1);
#endif
}
// Handle an initial switch closure by backing off the closed switch
// NOTE: Relies on independent switches per axis (not shared)
static stat_t _homing_axis_clear(int8_t axis) // first clear move
{
#ifndef __NEW_SWITCHES
if (read_switch(hm.homing_switch) == SW_CLOSED) {
_homing_axis_move(axis, hm.latch_backoff, hm.search_velocity);
} else if (read_switch(hm.limit_switch) == SW_CLOSED) {
_homing_axis_move(axis, -hm.latch_backoff, hm.search_velocity);
} else { // no move needed, so target position is same as current position
hm.target_position = cm_get_absolute_position(MODEL, axis);
}
#else
if (read_switch(hm.homing_switch_axis, hm.homing_switch_position) == SW_CLOSED) {
_homing_axis_move(axis, hm.latch_backoff, hm.search_velocity);
} else if (read_switch(hm.limit_switch_axis, hm.limit_switch_position) == SW_CLOSED) {
_homing_axis_move(axis, -hm.latch_backoff, hm.search_velocity);
} else { // no move needed, so target position is same as current position
hm.target_position = cm_get_absolute_position(MODEL, axis);
}
#endif
return (_set_homing_func(_homing_axis_search));
}
