void bootblock_mainboard_init(void)
{
if (rkclk_was_watchdog_reset())
reboot_from_watchdog();
gpio_output(GPIO(0, B, 3), 1); /* Power LED */
/* Up VDD_CPU (BUCK1) to 1.4V to support max CPU frequency (1.8GHz). */
setbits_le32(&rk3288_pmu->iomux_i2c0scl, IOMUX_I2C0SCL);
setbits_le32(&rk3288_pmu->iomux_i2c0sda, IOMUX_I2C0SDA);
assert(CONFIG_PMIC_BUS == 0); /* must correspond with IOMUX */
i2c_init(CONFIG_PMIC_BUS, 400*KHz);
/* Slowly raise to max CPU voltage to prevent overshoot */
rk808_configure_buck(1, 1200);
udelay(175);/* Must wait for voltage to stabilize,2mV/us */
rk808_configure_buck(1, 1400);
udelay(100);/* Must wait for voltage to stabilize,2mV/us */
rkclk_configure_cpu(APLL_1800_MHZ);
/* i2c1 for tpm */
write32(&rk3288_grf->iomux_i2c1, IOMUX_I2C1);
i2c_init(1, 400*KHz);
/* spi2 for firmware ROM */
write32(&rk3288_grf->iomux_spi2csclk, IOMUX_SPI2_CSCLK);
write32(&rk3288_grf->iomux_spi2txrx, IOMUX_SPI2_TXRX);
rockchip_spi_init(CONFIG_BOOT_MEDIA_SPI_BUS, 24750*KHz);
setup_chromeos_gpios();
}
void bootblock_mainboard_init(void)
{
/* adjust gpio params when external voltage is 1.8V */
gpio_init(GPIO_EINT_1P8V);
/* set i2c related gpio */
i2c_set_gpio_pinmux();
setup_chromeos_gpios();
if (board_id() < 4)
mt6391_enable_reset_when_ap_resets();
}
void bootblock_mainboard_init(void)
{
/* adjust gpio params when external voltage is 1.8V */
gpio_init(GPIO_EINT_1P8V);
/* set i2c related gpio */
i2c_set_gpio_pinmux();
mtk_spi_init(CONFIG_EC_GOOGLE_CHROMEEC_SPI_BUS, SPI_PAD1_MASK, 6*MHz);
setup_chromeos_gpios();
if (board_id() < 4)
mt6391_enable_reset_when_ap_resets();
}
void bootblock_mainboard_init(void)
{
/* Set pinmux and configure spi flashrom. */
write32(&rk3399_pmugrf->spi1_rxd, IOMUX_SPI1_RX);
write32(&rk3399_pmugrf->spi1_csclktx, IOMUX_SPI1_CSCLKTX);
rockchip_spi_init(CONFIG_BOOT_MEDIA_SPI_BUS, 24750*KHz);
/* Set pinmux and configure EC SPI. */
write32(&rk3399_grf->iomux_spi5, IOMUX_SPI5);
rockchip_spi_init(CONFIG_EC_GOOGLE_CHROMEEC_SPI_BUS, 3093750);
if (IS_ENABLED(CONFIG_GRU_HAS_TPM2)) {
/* Set pinmux and configure TPM SPI, which is not very fast. */
write32(&rk3399_grf->iomux_spi0, IOMUX_SPI0);
rockchip_spi_init(CONFIG_DRIVER_TPM_SPI_BUS, 1500*KHz);
} else {
/* Set pinmux and configure TPM I2C */
write32(&rk3399_pmugrf->iomux_i2c0_scl, IOMUX_I2C0_SCL);
write32(&rk3399_pmugrf->iomux_i2c0_sda, IOMUX_I2C0_SDA);
i2c_init(0, 400*KHz);
}
setup_chromeos_gpios();
}
