int board_init(void)
{
/* address of boot parameters */
gd->bd->bi_boot_params = PHYS_SDRAM + 0x100;
/* Reset peripherals */
imx_iomux_v3_setup_multiple_pads(per_rst_pads, ARRAY_SIZE(per_rst_pads));
gpio_direction_output(IMX_GPIO_NR(1, 3) , 0);
udelay(500);
gpio_set_value(IMX_GPIO_NR(1, 3), 1);
#ifdef CONFIG_SYS_USE_SPINOR
setup_spinor();
#endif
#ifdef CONFIG_SYS_USE_EIMNOR
setup_eimnor();
#endif
#ifdef CONFIG_SYS_USE_NAND
setup_gpmi_nand();
#endif
#ifdef CONFIG_FEC_MXC
setup_fec();
#endif
#ifdef CONFIG_QSPI
board_qspi_init();
#endif
return 0;
}
int board_early_init_f(void)
{
setup_iomux_uart();
#ifdef CONFIG_SYS_USE_SPINOR
setup_spinor();
#endif
return 0;
}
int board_early_init_f(void)
{
setup_iomux_uart();
#if defined(CONFIG_VIDEO_IPUV3)
setup_display();
#endif
#ifdef CONFIG_SYS_USE_SPINOR
setup_spinor();
#endif
#ifdef CONFIG_CMD_SATA
setup_sata();
#endif
return 0;
}
int board_init(void)
{
/* Address of boot parameters */
gd->bd->bi_boot_params = PHYS_SDRAM + 0x100;
#ifdef CONFIG_SYS_I2C_MXC
setup_i2c(0, CONFIG_SYS_I2C_SPEED, 0x7f, &i2c_pad_info1);
#endif
#ifdef CONFIG_FEC_MXC
setup_fec(CONFIG_FEC_ENET_DEV);
#endif
#ifdef CONFIG_SYS_USE_SPINOR
setup_spinor();
#endif
#ifdef CONFIG_SYS_USE_NAND
setup_gpmi_nand();
#endif
#ifdef CONFIG_SYS_USE_EIMNOR
/*
* This function should be invoked after setup_fec,
* because ENET2_RX_ER conflicts. However, we rarely need
* ENET2_RX_ER for enet, and when use eimnor, we do not
* have sd1/sd2, enet is a must to boot kernel and nfsrootfs.
*/
setup_eimnor();
#endif
#ifdef CONFIG_SYS_USE_QSPI
board_qspi_init();
#endif
return 0;
}
