static int __maybe_unused spi_imx2_3_config(struct spi_imx_data *spi_imx,
struct spi_imx_config *config)
{
u32 ctrl = SPI_IMX2_3_CTRL_ENABLE, cfg = 0;
/* set master mode */
ctrl |= SPI_IMX2_3_CTRL_MODE(config->cs);
/* set clock speed */
ctrl |= spi_imx2_3_clkdiv(spi_imx->spi_clk, config->speed_hz);
/* set chip select to use */
ctrl |= SPI_IMX2_3_CTRL_CS(config->cs);
ctrl |= (config->bpw - 1) << SPI_IMX2_3_CTRL_BL_OFFSET;
cfg |= SPI_IMX2_3_CONFIG_SBBCTRL(config->cs);
if (config->mode & SPI_CPHA)
cfg |= SPI_IMX2_3_CONFIG_SCLKPHA(config->cs);
if (config->mode & SPI_CPOL)
cfg |= SPI_IMX2_3_CONFIG_SCLKPOL(config->cs);
if (config->mode & SPI_CS_HIGH)
cfg |= SPI_IMX2_3_CONFIG_SSBPOL(config->cs);
writel(ctrl, spi_imx->base + SPI_IMX2_3_CTRL);
writel(cfg, spi_imx->base + SPI_IMX2_3_CONFIG);
return 0;
}
static int __maybe_unused spi_imx2_3_config(struct spi_imx_data *spi_imx,
struct spi_imx_config *config)
{
u32 ctrl = SPI_IMX2_3_CTRL_ENABLE, cfg = 0;
/*
* The hardware seems to have a race condition when changing modes. The
* current assumption is that the selection of the channel arrives
* earlier in the hardware than the mode bits when they are written at
* the same time.
* So set master mode for all channels as we do not support slave mode.
*/
ctrl |= SPI_IMX2_3_CTRL_MODE_MASK;
/* set clock speed */
ctrl |= spi_imx2_3_clkdiv(spi_imx->spi_clk, config->speed_hz);
/* set chip select to use */
ctrl |= SPI_IMX2_3_CTRL_CS(config->cs);
ctrl |= (config->bpw - 1) << SPI_IMX2_3_CTRL_BL_OFFSET;
cfg |= SPI_IMX2_3_CONFIG_SBBCTRL(config->cs);
if (config->mode & SPI_CPHA)
cfg |= SPI_IMX2_3_CONFIG_SCLKPHA(config->cs);
if (config->mode & SPI_CPOL)
cfg |= SPI_IMX2_3_CONFIG_SCLKPOL(config->cs);
if (config->mode & SPI_CS_HIGH)
cfg |= SPI_IMX2_3_CONFIG_SSBPOL(config->cs);
writel(ctrl, spi_imx->base + SPI_IMX2_3_CTRL);
writel(cfg, spi_imx->base + SPI_IMX2_3_CONFIG);
return 0;
}