static int tegra_clk_rst_assert(struct reset_controller_dev *rcdev,
unsigned long id)
{
tegra_read_chipid();
writel(BIT(id % 32), car_base + periph_regs[id / 32].rst_set_reg);
return 0;
}
static void __init tegra20_fuse_add_randomness(void)
{
u32 randomness[7];
randomness[0] = tegra_sku_info.sku_id;
randomness[1] = tegra_read_straps();
randomness[2] = tegra_read_chipid();
randomness[3] = tegra_sku_info.cpu_process_id << 16;
randomness[3] |= tegra_sku_info.core_process_id;
randomness[4] = tegra_sku_info.cpu_speedo_id << 16;
randomness[4] |= tegra_sku_info.soc_speedo_id;
randomness[5] = tegra20_fuse_early(FUSE_UID_LOW);
randomness[6] = tegra20_fuse_early(FUSE_UID_HIGH);
add_device_randomness(randomness, sizeof(randomness));
}
static int tegra_clk_rst_assert(struct reset_controller_dev *rcdev,
unsigned long id)
{
/*
* If peripheral is on the APB bus then we must read the APB bus to
* flush the write operation in apb bus. This will avoid peripheral
* access after disabling clock. Since the reset driver has no
* knowledge of which reset IDs represent which devices, simply do
* this all the time.
*/
tegra_read_chipid();
writel_relaxed(BIT(id % 32),
clk_base + periph_regs[id / 32].rst_set_reg);
return 0;
}
static void __init tegra30_fuse_add_randomness(void)
{
u32 randomness[12];
randomness[0] = tegra_sku_info.sku_id;
randomness[1] = tegra_read_straps();
randomness[2] = tegra_read_chipid();
randomness[3] = tegra_sku_info.cpu_process_id << 16;
randomness[3] |= tegra_sku_info.core_process_id;
randomness[4] = tegra_sku_info.cpu_speedo_id << 16;
randomness[4] |= tegra_sku_info.soc_speedo_id;
randomness[5] = tegra30_fuse_readl(FUSE_VENDOR_CODE);
randomness[6] = tegra30_fuse_readl(FUSE_FAB_CODE);
randomness[7] = tegra30_fuse_readl(FUSE_LOT_CODE_0);
randomness[8] = tegra30_fuse_readl(FUSE_LOT_CODE_1);
randomness[9] = tegra30_fuse_readl(FUSE_WAFER_ID);
randomness[10] = tegra30_fuse_readl(FUSE_X_COORDINATE);
randomness[11] = tegra30_fuse_readl(FUSE_Y_COORDINATE);
add_device_randomness(randomness, sizeof(randomness));
}