void usage()
{
printf("Usage: rotctl [OPTION]... [COMMAND]...\n"
"Send COMMANDs to a connected antenna rotator.\n\n");
printf(
" -m, --model=ID select rotator model number. See model list\n"
" -r, --rot-file=DEVICE set device of the rotator to operate on\n"
" -s, --serial-speed=BAUD set serial speed of the serial port\n"
" -t, --send-cmd-term=CHAR set send_cmd command termination char\n"
" -C, --set-conf=PARM=VAL set config parameters\n"
" -L, --show-conf list all config parameters\n"
" -l, --list list all model numbers and exit\n"
" -u, --dump-caps dump capabilities and exit\n"
#ifdef HAVE_READLINE_HISTORY
" -i, --read-history read prior interactive session history\n"
" -I, --save-history save current interactive session history\n"
#endif
" -v, --verbose set verbose mode, cumulative\n"
" -h, --help display this help and exit\n"
" -V, --version output version information and exit\n\n"
);
usage_rot(stdout);
printf("\nReport bugs to <*****@*****.**>.\n");
}
void usage()
{
printf("Usage: rotctld [OPTION]... [COMMAND]...\n"
"Daemon serving COMMANDs to a connected antenna rotator.\n\n");
printf(
" -m, --model=ID select rotator model number. See model list\n"
" -r, --rot-file=DEVICE set device of the rotator to operate on\n"
" -s, --serial-speed=BAUD set serial speed of the serial port\n"
" -t, --port=NUM set TCP listening port, default %s\n"
" -T, --listen-addr=IPADDR set listening IP address, default ANY\n"
" -C, --set-conf=PARM=VAL set config parameters\n"
" -L, --show-conf list all config parameters\n"
" -l, --list list all model numbers and exit\n"
" -u, --dump-caps dump capabilities and exit\n"
" -e, --end-marker use END marker in rotctld protocol (obsolete)\n"
" -v, --verbose set verbose mode, cumulative\n"
" -h, --help display this help and exit\n"
" -V, --version output version information and exit\n\n",
portno);
usage_rot(stdout);
printf("\nReport bugs to <*****@*****.**>.\n");
}
