__init void plat_time_init(void)
{
unsigned int configPR;
unsigned int n;
unsigned int m;
unsigned int p;
unsigned int pow2p;
pnx8xxx_clockevent.cpumask = cpu_none_mask;
clockevents_register_device(&pnx8xxx_clockevent);
clocksource_register(&pnx_clocksource);
/* Timer 1 start */
configPR = read_c0_config7();
configPR &= ~0x00000008;
write_c0_config7(configPR);
/* Timer 2 start */
configPR = read_c0_config7();
configPR &= ~0x00000010;
write_c0_config7(configPR);
/* Timer 3 stop */
configPR = read_c0_config7();
configPR |= 0x00000020;
write_c0_config7(configPR);
/* PLL0 sets MIPS clock (PLL1 <=> TM1, PLL6 <=> TM2, PLL5 <=> mem) */
/* (but only if CLK_MIPS_CTL select value [bits 3:1] is 1: FIXME) */
n = (PNX8550_CM_PLL0_CTL & PNX8550_CM_PLL_N_MASK) >> 16;
m = (PNX8550_CM_PLL0_CTL & PNX8550_CM_PLL_M_MASK) >> 8;
p = (PNX8550_CM_PLL0_CTL & PNX8550_CM_PLL_P_MASK) >> 2;
pow2p = (1 << p);
db_assert(m != 0 && pow2p != 0);
/*
* Compute the frequency as in the PNX8550 User Manual 1.0, p.186
* (a.k.a. 8-10). Divide by HZ for a timer offset that results in
* HZ timer interrupts per second.
*/
mips_hpt_frequency = 27UL * ((1000000UL * n)/(m * pow2p));
cpj = (mips_hpt_frequency + HZ / 2) / HZ;
write_c0_count(0);
timer_ack();
/* Setup Timer 2 */
write_c0_count2(0);
write_c0_compare2(0xffffffff);
setup_irq(PNX8550_INT_TIMER1, &pnx8xxx_timer_irq);
setup_irq(PNX8550_INT_TIMER2, &monotonic_irqaction);
}
void __init plat_timer_setup(struct irqaction *irq)
{
int configPR;
setup_irq(PNX8550_INT_TIMER1, irq);
/* Start timer1 */
configPR = read_c0_config7();
configPR &= ~0x00000008;
write_c0_config7(configPR);
/* Timer 2 stop */
configPR = read_c0_config7();
configPR |= 0x00000010;
write_c0_config7(configPR);
write_c0_count2(0);
write_c0_compare2(0xffffffff);
/* Timer 3 stop */
configPR = read_c0_config7();
configPR |= 0x00000020;
write_c0_config7(configPR);
}
static irqreturn_t monotonic_interrupt(int irq, void *dev_id)
{
/* Timer 2 clear interrupt */
write_c0_compare2(-1);
return IRQ_HANDLED;
}
