static int fill_ctrlset(struct zd_mac *mac,
struct sk_buff *skb,
struct ieee80211_tx_control *control)
{
int r;
struct ieee80211_hdr *hdr = (struct ieee80211_hdr *) skb->data;
unsigned int frag_len = skb->len + FCS_LEN;
unsigned int packet_length;
struct zd_ctrlset *cs = (struct zd_ctrlset *)
skb_push(skb, sizeof(struct zd_ctrlset));
ZD_ASSERT(frag_len <= 0xffff);
cs->modulation = control->tx_rate->hw_value;
if (control->flags & IEEE80211_TXCTL_SHORT_PREAMBLE)
cs->modulation = control->tx_rate->hw_value_short;
cs->tx_length = cpu_to_le16(frag_len);
cs_set_control(mac, cs, hdr, control->flags);
packet_length = frag_len + sizeof(struct zd_ctrlset) + 10;
ZD_ASSERT(packet_length <= 0xffff);
/* ZD1211B: Computing the length difference this way, gives us
* flexibility to compute the packet length.
*/
cs->packet_length = cpu_to_le16(zd_chip_is_zd1211b(&mac->chip) ?
packet_length - frag_len : packet_length);
/*
* CURRENT LENGTH:
* - transmit frame length in microseconds
* - seems to be derived from frame length
* - see Cal_Us_Service() in zdinlinef.h
* - if macp->bTxBurstEnable is enabled, then multiply by 4
* - bTxBurstEnable is never set in the vendor driver
*
* SERVICE:
* - "for PLCP configuration"
* - always 0 except in some situations at 802.11b 11M
* - see line 53 of zdinlinef.h
*/
cs->service = 0;
r = zd_calc_tx_length_us(&cs->service, ZD_RATE(cs->modulation),
le16_to_cpu(cs->tx_length));
if (r < 0)
return r;
cs->current_length = cpu_to_le16(r);
cs->next_frame_length = 0;
return 0;
}
int zd_rf_init_rf2959(struct zd_rf *rf)
{
struct zd_chip *chip = zd_rf_to_chip(rf);
if (zd_chip_is_zd1211b(chip)) {
dev_err(zd_chip_dev(chip),
"RF2959 is currently not supported for ZD1211B"
" devices\n");
return -ENODEV;
}
rf->init_hw = rf2959_init_hw;
rf->set_channel = rf2959_set_channel;
rf->switch_radio_on = rf2959_switch_radio_on;
rf->switch_radio_off = rf2959_switch_radio_off;
return 0;
}
int zd_rf_init_al2230(struct zd_rf *rf)
{
struct zd_chip *chip = zd_rf_to_chip(rf);
rf->switch_radio_off = al2230_switch_radio_off;
if (zd_chip_is_zd1211b(chip)) {
rf->init_hw = zd1211b_al2230_init_hw;
rf->set_channel = zd1211b_al2230_set_channel;
rf->switch_radio_on = zd1211b_al2230_switch_radio_on;
} else {
rf->init_hw = zd1211_al2230_init_hw;
rf->set_channel = zd1211_al2230_set_channel;
rf->switch_radio_on = zd1211_al2230_switch_radio_on;
}
rf->patch_6m_band_edge = zd_rf_generic_patch_6m;
rf->patch_cck_gain = 1;
return 0;
}
static int uw2453_switch_radio_on(struct zd_rf *rf)
{
int r;
struct zd_chip *chip = zd_rf_to_chip(rf);
struct zd_ioreq16 ioreqs[] = {
{ CR11, 0x00 }, { CR251, 0x3f },
};
/* enter RXTX mode */
r = zd_rfwrite_locked(chip, UW2453_REGWRITE(0, 0x25f94), RF_RV_BITS);
if (r)
return r;
if (zd_chip_is_zd1211b(chip))
ioreqs[1].value = 0x7f;
return zd_iowrite16a_locked(chip, ioreqs, ARRAY_SIZE(ioreqs));
}
/* Prints an identifier line, which will support debugging. */
static int scnprint_id(struct zd_chip *chip, char *buffer, size_t size)
{
int i = 0;
i = scnprintf(buffer, size, "zd1211%s chip ",
zd_chip_is_zd1211b(chip) ? "b" : "");
i += zd_usb_scnprint_id(&chip->usb, buffer+i, size-i);
i += scnprintf(buffer+i, size-i, " ");
i += scnprint_mac_oui(chip, buffer+i, size-i);
i += scnprintf(buffer+i, size-i, " ");
i += zd_rf_scnprint_id(&chip->rf, buffer+i, size-i);
i += scnprintf(buffer+i, size-i, " pa%1x %c%c%c%c%c", chip->pa_type,
chip->patch_cck_gain ? 'g' : '-',
chip->patch_cr157 ? '7' : '-',
chip->patch_6m_band_edge ? '6' : '-',
chip->new_phy_layout ? 'N' : '-',
chip->al2230s_bit ? 'S' : '-');
return i;
}
void zd_mac_config_beacon(struct ieee80211_hw *hw, struct sk_buff *beacon)
{
struct zd_mac *mac = zd_hw_mac(hw);
u32 tmp, j = 0;
/* 4 more bytes for tail CRC */
u32 full_len = beacon->len + 4;
zd_iowrite32(&mac->chip, CR_BCN_FIFO_SEMAPHORE, 0);
zd_ioread32(&mac->chip, CR_BCN_FIFO_SEMAPHORE, &tmp);
while (tmp & 0x2) {
zd_ioread32(&mac->chip, CR_BCN_FIFO_SEMAPHORE, &tmp);
if ((++j % 100) == 0) {
printk(KERN_ERR "CR_BCN_FIFO_SEMAPHORE not ready\n");
if (j >= 500) {
printk(KERN_ERR "Giving up beacon config.\n");
return;
}
}
msleep(1);
}
zd_iowrite32(&mac->chip, CR_BCN_FIFO, full_len - 1);
if (zd_chip_is_zd1211b(&mac->chip))
zd_iowrite32(&mac->chip, CR_BCN_LENGTH, full_len - 1);
for (j = 0 ; j < beacon->len; j++)
zd_iowrite32(&mac->chip, CR_BCN_FIFO,
*((u8 *)(beacon->data + j)));
for (j = 0; j < 4; j++)
zd_iowrite32(&mac->chip, CR_BCN_FIFO, 0x0);
zd_iowrite32(&mac->chip, CR_BCN_FIFO_SEMAPHORE, 1);
/* 802.11b/g 2.4G CCK 1Mb
* 802.11a, not yet implemented, uses different values (see GPL vendor
* driver)
*/
zd_iowrite32(&mac->chip, CR_BCN_PLCP_CFG, 0x00000400 |
(full_len << 19));
}
