#define nitrogen6x __LINE__
#define nitrogen6max __LINE__
#define cubox_i __LINE__
static const struct iomux_conf iomux_data[] = {
#if (EVBARM_BOARDTYPE == nitrogen6x) || \
(EVBARM_BOARDTYPE == nitrogen6max)
/* UART1 RX */
{
.pin = MUX_PIN(SD3_DATA6),
.mux = IOMUX_CONFIG_ALT1,
.pad = PAD_CTL_HYS | PAD_CTL_PUS_22K_PU | PAD_CTL_PULL |
PAD_CTL_SPEED_100MHZ | PAD_CTL_DSE_40OHM | PAD_CTL_SRE_FAST
},
{
.pin = IOMUX_PIN(IOMUX_MUX_NONE,
IOMUXC_UART1_UART_RX_DATA_SELECT_INPUT),
.pad = INPUT_DAISY_3
},
/* UART1 TX */
{
.pin = MUX_PIN(SD3_DATA7),
.mux = IOMUX_CONFIG_ALT1,
.pad = PAD_CTL_HYS | PAD_CTL_PUS_22K_PU | PAD_CTL_PULL |
PAD_CTL_ODE |
PAD_CTL_SPEED_100MHZ | PAD_CTL_DSE_40OHM | PAD_CTL_SRE_FAST
},
#endif
/* end of table */
{.pin = IOMUX_CONF_EOT}
};
},
};
static struct mx3fb_platform_data mx3fb_pdata = {
.name = "Sharp-LQ035Q7DH06-QVGA",
.mode = fb_modedb,
.num_modes = ARRAY_SIZE(fb_modedb),
};
static struct resource pcm970_sja1000_resources[] = {
{
.start = MX31_CS5_BASE_ADDR,
.end = MX31_CS5_BASE_ADDR + 0x100 - 1,
.flags = IORESOURCE_MEM,
}, {
.start = IOMUX_TO_IRQ(IOMUX_PIN(48, 105)),
.end = IOMUX_TO_IRQ(IOMUX_PIN(48, 105)),
.flags = IORESOURCE_IRQ | IORESOURCE_IRQ_LOWEDGE,
},
};
struct sja1000_platform_data pcm970_sja1000_platform_data = {
.osc_freq = 16000000,
.ocr = OCR_TX1_PULLDOWN | OCR_TX0_PUSHPULL,
.cdr = CDR_CBP,
};
static struct platform_device pcm970_sja1000 = {
.name = "sja1000_platform",
.dev = {
.platform_data = &pcm970_sja1000_platform_data,
/*
* Board specific initialization.
*/
static void __init pcm037_init(void)
{
int ret;
imx31_soc_init();
regulator_register_fixed(0, dummy_supplies, ARRAY_SIZE(dummy_supplies));
mxc_iomux_set_gpr(MUX_PGP_UH2, 1);
mxc_iomux_setup_multiple_pins(pcm037_pins, ARRAY_SIZE(pcm037_pins),
"pcm037");
#define H2_PAD_CFG (PAD_CTL_DRV_MAX | PAD_CTL_SRE_FAST | PAD_CTL_HYS_CMOS \
| PAD_CTL_ODE_CMOS | PAD_CTL_100K_PU)
mxc_iomux_set_pad(MX31_PIN_USBH2_CLK, H2_PAD_CFG);
mxc_iomux_set_pad(MX31_PIN_USBH2_DIR, H2_PAD_CFG);
mxc_iomux_set_pad(MX31_PIN_USBH2_NXT, H2_PAD_CFG);
mxc_iomux_set_pad(MX31_PIN_USBH2_STP, H2_PAD_CFG);
mxc_iomux_set_pad(MX31_PIN_USBH2_DATA0, H2_PAD_CFG); /* USBH2_DATA0 */
mxc_iomux_set_pad(MX31_PIN_USBH2_DATA1, H2_PAD_CFG); /* USBH2_DATA1 */
mxc_iomux_set_pad(MX31_PIN_SRXD6, H2_PAD_CFG); /* USBH2_DATA2 */
mxc_iomux_set_pad(MX31_PIN_STXD6, H2_PAD_CFG); /* USBH2_DATA3 */
mxc_iomux_set_pad(MX31_PIN_SFS3, H2_PAD_CFG); /* USBH2_DATA4 */
mxc_iomux_set_pad(MX31_PIN_SCK3, H2_PAD_CFG); /* USBH2_DATA5 */
mxc_iomux_set_pad(MX31_PIN_SRXD3, H2_PAD_CFG); /* USBH2_DATA6 */
mxc_iomux_set_pad(MX31_PIN_STXD3, H2_PAD_CFG); /* USBH2_DATA7 */
if (pcm037_variant() == PCM037_EET)
mxc_iomux_setup_multiple_pins(pcm037_uart1_pins,
ARRAY_SIZE(pcm037_uart1_pins), "pcm037_uart1");
else
mxc_iomux_setup_multiple_pins(pcm037_uart1_handshake_pins,
ARRAY_SIZE(pcm037_uart1_handshake_pins),
"pcm037_uart1");
platform_add_devices(devices, ARRAY_SIZE(devices));
imx31_add_imx2_wdt();
imx31_add_imx_uart0(&uart_pdata);
/* XXX: should't this have .flags = 0 (i.e. no RTSCTS) on PCM037_EET? */
imx31_add_imx_uart1(&uart_pdata);
imx31_add_imx_uart2(&uart_pdata);
imx31_add_mxc_w1();
/* LAN9217 IRQ pin */
ret = gpio_request(IOMUX_TO_GPIO(MX31_PIN_GPIO3_1), "lan9217-irq");
if (ret)
pr_warning("could not get LAN irq gpio\n");
else {
gpio_direction_input(IOMUX_TO_GPIO(MX31_PIN_GPIO3_1));
smsc911x_resources[1].start =
gpio_to_irq(IOMUX_TO_GPIO(MX31_PIN_GPIO3_1));
smsc911x_resources[1].end =
gpio_to_irq(IOMUX_TO_GPIO(MX31_PIN_GPIO3_1));
platform_device_register(&pcm037_eth);
}
/* I2C adapters and devices */
i2c_register_board_info(1, pcm037_i2c_devices,
ARRAY_SIZE(pcm037_i2c_devices));
imx31_add_imx_i2c1(&pcm037_i2c1_data);
imx31_add_imx_i2c2(&pcm037_i2c2_data);
imx31_add_mxc_nand(&pcm037_nand_board_info);
imx31_add_mxc_mmc(0, &sdhc_pdata);
imx31_add_ipu_core();
imx31_add_mx3_sdc_fb(&mx3fb_pdata);
/* CSI */
/* Camera power: default - off */
ret = gpio_request(IOMUX_TO_GPIO(MX31_PIN_CSI_D5), "mt9t031-power");
if (!ret)
gpio_direction_output(IOMUX_TO_GPIO(MX31_PIN_CSI_D5), 1);
else
iclink_mt9t031.power = NULL;
pcm037_init_camera();
pcm970_sja1000_resources[1].start =
gpio_to_irq(IOMUX_TO_GPIO(IOMUX_PIN(48, 105)));
pcm970_sja1000_resources[1].end =
gpio_to_irq(IOMUX_TO_GPIO(IOMUX_PIN(48, 105)));
platform_device_register(&pcm970_sja1000);
if (otg_mode_host) {
otg_pdata.otg = imx_otg_ulpi_create(ULPI_OTG_DRVVBUS |
ULPI_OTG_DRVVBUS_EXT);
if (otg_pdata.otg)
imx31_add_mxc_ehci_otg(&otg_pdata);
}
usbh2_pdata.otg = imx_otg_ulpi_create(ULPI_OTG_DRVVBUS |
ULPI_OTG_DRVVBUS_EXT);
if (usbh2_pdata.otg)
imx31_add_mxc_ehci_hs(2, &usbh2_pdata);
if (!otg_mode_host)
imx31_add_fsl_usb2_udc(&otg_device_pdata);
}
