static void interrupt_handler()
{
uint32_t recv_data;
uint32_t status;
status = MAP_SPIIntStatus(GSPI_BASE,true);
MAP_SPIIntClear(GSPI_BASE,SPI_INT_RX_FULL|SPI_INT_TX_EMPTY);
if(status & SPI_INT_TX_EMPTY)
{
MAP_SPIDataPut(GSPI_BASE,tx_buffer[tx_count % TR_BUFF_SIZE]);
tx_count++;
}
if(status & SPI_INT_RX_FULL)
{
MAP_SPIDataGetNonBlocking(GSPI_BASE,&recv_data);
rx_buffer[rx_count % TR_BUFF_SIZE] = recv_data;
rx_count++;
}
interrupt_count++;
if(interrupt_count % (TR_BUFF_SIZE * 2) == 0 && interrupt_count > 0)
{
transfer_count++;
}
}
STATIC void pyb_sleep_flash_powerdown (void) {
uint32_t status;
// Enable clock for SSPI module
MAP_PRCMPeripheralClkEnable(PRCM_SSPI, PRCM_RUN_MODE_CLK | PRCM_SLP_MODE_CLK);
// Reset SSPI at PRCM level and wait for reset to complete
MAP_PRCMPeripheralReset(PRCM_SSPI);
while(!MAP_PRCMPeripheralStatusGet(PRCM_SSPI));
// Reset SSPI at module level
MAP_SPIReset(SSPI_BASE);
// Configure SSPI module
MAP_SPIConfigSetExpClk (SSPI_BASE, PRCMPeripheralClockGet(PRCM_SSPI),
20000000, SPI_MODE_MASTER,SPI_SUB_MODE_0,
(SPI_SW_CTRL_CS |
SPI_4PIN_MODE |
SPI_TURBO_OFF |
SPI_CS_ACTIVELOW |
SPI_WL_8));
// Enable SSPI module
MAP_SPIEnable(SSPI_BASE);
// Enable chip select for the spi flash.
MAP_SPICSEnable(SSPI_BASE);
// Wait for the spi flash
do {
// Send the status register read instruction and read back a dummy byte.
MAP_SPIDataPut(SSPI_BASE, SPIFLASH_INSTR_READ_STATUS);
MAP_SPIDataGet(SSPI_BASE, &status);
// Write a dummy byte then read back the actual status.
MAP_SPIDataPut(SSPI_BASE, 0xFF);
MAP_SPIDataGet(SSPI_BASE, &status);
} while ((status & 0xFF) == SPIFLASH_STATUS_BUSY);
// Disable chip select for the spi flash.
MAP_SPICSDisable(SSPI_BASE);
// Start another CS enable sequence for Power down command.
MAP_SPICSEnable(SSPI_BASE);
// Send Deep Power Down command to spi flash
MAP_SPIDataPut(SSPI_BASE, SPIFLASH_INSTR_DEEP_POWER_DOWN);
// Disable chip select for the spi flash.
MAP_SPICSDisable(SSPI_BASE);
}
void CC3200Helpers_HibernateNowFor(unsigned long dwSeconds, char flStopSL)
{
unsigned long long qwTicks = dwSeconds;
qwTicks *= SLOW_CLK_FREQ;
MAP_PRCMHibernateIntervalSet(qwTicks);
MAP_PRCMHibernateWakeupSourceEnable(PRCM_HIB_SLOW_CLK_CTR);
MAP_UtilsDelay(80000);
if ( flStopSL )
{
sl_WlanDisconnect();
sl_Stop(0);
}
MAP_SPICSDisable(SSPI_BASE);
MAP_SPICSEnable(SSPI_BASE);
MAP_SPIDataPut(SSPI_BASE, 0xB9); // deep power down
MAP_SPICSDisable(SSPI_BASE);
MAP_PRCMHibernateEnter();
}
