void InitializeNRF24L01()
{
// NRF24L01 goes to RX mode by default;
NRF24L01_Init(DEFAULT_CHANNEL, DEFAULT_PAYLOAD_SIZE);
NRF24L01_SetRF(NRF24L01_DataRate_2M, NRF24L01_OutputPower_M18dBm);
NRF24L01_SetMyAddress(MyAddress);
NRF24L01_SetTxAddress(TxAddress);
}
void retranslate(void)
{
/* Receiver address */
uint8_t TxAddress[] = {
0xE7,
0xE7,
0xE7,
0xE7,
0xE7
};
/* My address */
uint8_t MyAddress[] = {
0x7E,
0x7E,
0x7E,
0x7E,
0x7E
};
uint8_t dataIn[32];
NRF24L01_Transmit_Status_t transmissionStatus;
/* Initialize NRF24L01+ on channel 15 and 32bytes of payload */
/* By default 2Mbps data rate and 0dBm output power */
/* NRF24L01 goes to RX mode by default */
NRF24L01_Init(15, 32);
/* Set RF settings, Data rate to 2Mbps, Output power to -18dBm */
NRF24L01_SetRF(NRF24L01_DataRate_2M, NRF24L01_OutputPower_M18dBm);
/* Set my address, 5 bytes */
NRF24L01_SetMyAddress(MyAddress);
/* Set TX address, 5 bytes */
NRF24L01_SetTxAddress(TxAddress);
LED1_ON;
delay_(3600000);
LED1_OFF;
while (1)
{
/* If data is ready on NRF24L01+ */
if (NRF24L01_DataReady())
{
/* Get data from NRF24L01+ */
NRF24L01_GetData(dataIn);
delay_(36000);
/* Send it back, automatically goes to TX mode */
NRF24L01_Transmit(dataIn);
/* Start send */
LED1_ON;;
delay_(360000);
/* Wait for data to be sent */
do {
transmissionStatus = NRF24L01_GetTransmissionStatus();
} while (transmissionStatus == NRF24L01_Transmit_Status_Sending);
/* Send done */
LED1_OFF;
/* Go back to RX Mode */
NRF24L01_PowerUpRx();
}
}
}