C++ (Cpp) PinConfig示例

示例#1

文件： SaLAltimeter-1_0.c 项目： SaLanc/SaLElectronics

int main(void) {
    SystemInit();
    SaLDelayInit();
    SalGclkInit();
    SaLRtcInit();
    PinConfig();
    uart_init(9600);
    //SaLTC4Init();
    sampleInit();
    adcInit();
    // UsbInit();
    // startUpTone();
    SaLBuzzerInit();



    struct IoDescriptor *UsartIoModule;
    struct IoDescriptor *UsartIoModuleUsb;

    struct AccelerometerModule myAccelerometer;

    SaLSyncUsartIo(&USART_0, &UsartIoModule);
    SaLSyncUsartIo(&USART_1, &UsartIoModuleUsb);

    initAccelerometer(&myAccelerometer);
    initBarometer();
    SaLFlashMemInit();


    volatile uint16_t ticks = 0;

    uint32_t lastTime = 0;
    //uint8_t message[255];
//     AT25SFErace4KBlock(0);
//     AT25SFWriteByte(0x00101,251);
//   volatile uint8_t byte = AT25SFGetByte(0x00101);

//     pinLow(CC1120_SLAVE_SELECT);
//     delay_ms(30);
//     pinHigh(CC1120_SLAVE_SELECT);
//     delay_ms(20);
//     pinLow(CC1120_SLAVE_SELECT);
//     delay_ms(30);
//     pinHigh(CC1120_SLAVE_SELECT);
//     delay_ms(20);

   // pinLow(CC1120_SLAVE_SELECT);
    //volatile uint8_t ccstatus = syncByte(CC1120_SCK ,CC1120_MOSI, CC1120_MISO, 0x80 | 0x30);
   // pinHigh(CC1120_SLAVE_SELECT);

    //delay_ms(200);

  //  pinLow(CC1120_SLAVE_SELECT);

    // while (pinRead(CC1120_MISO));
   // volatile uint8_t ccstatus2 = syncByte(CC1120_SCK ,CC1120_MOSI, CC1120_MISO, 0x80 | 0x3B);
   // volatile uint8_t ccstatus3 = getByte(CC1120_SCK_PIN,CC1120_MISO_PIN);
    // byteOut(CC1120_SCK_PIN,CC1120_MOSI_PIN, 0b10111101 );
  //  pinHigh(CC1120_SLAVE_SELECT);


    volatile float batt;

    //TC5->COUNT16.CTRLA.bit.ENABLE = 0;


   // TC5->COUNT16.CTRLBCLR.reg= TC_CTRLBCLR_CMD_RETRIGGER;

    while (1) {

        milliseconds = millis();

        sampleTick(); 
        batt = senseBatVolts(senseBat);
    }
}

示例#2

文件： CLed.cpp 项目： XiaoxingChen/Periph_drive_class

CLed::CLed(void):
	Is_On_Set(0)
{
	CLKConfig();
	PinConfig();
}