void iwl_set_rxon_ht(struct iwl_priv *priv, struct iwl_ht_config *ht_conf)
{
struct iwl_rxon_context *ctx;
for_each_context(priv, ctx)
_iwl_set_rxon_ht(priv, ht_conf, ctx);
}
int iwlagn_mac_config(struct ieee80211_hw *hw, u32 changed)
{
struct iwl_priv *priv = hw->priv;
struct iwl_rxon_context *ctx;
struct ieee80211_conf *conf = &hw->conf;
struct ieee80211_channel *channel = conf->channel;
const struct iwl_channel_info *ch_info;
int ret = 0;
IWL_DEBUG_MAC80211(priv, "changed %#x", changed);
mutex_lock(&priv->mutex);
if (unlikely(test_bit(STATUS_SCANNING, &priv->status))) {
IWL_DEBUG_MAC80211(priv, "leave - scanning\n");
goto out;
}
if (!iwl_is_ready(priv)) {
IWL_DEBUG_MAC80211(priv, "leave - not ready\n");
goto out;
}
if (changed & (IEEE80211_CONF_CHANGE_SMPS |
IEEE80211_CONF_CHANGE_CHANNEL)) {
/* mac80211 uses static for non-HT which is what we want */
priv->current_ht_config.smps = conf->smps_mode;
/*
* Recalculate chain counts.
*
* If monitor mode is enabled then mac80211 will
* set up the SM PS mode to OFF if an HT channel is
* configured.
*/
if (priv->cfg->ops->hcmd->set_rxon_chain)
for_each_context(priv, ctx)
priv->cfg->ops->hcmd->set_rxon_chain(priv, ctx);
}
if (changed & IEEE80211_CONF_CHANGE_CHANNEL) {
unsigned long flags;
ch_info = iwl_get_channel_info(priv, channel->band,
channel->hw_value);
if (!is_channel_valid(ch_info)) {
IWL_DEBUG_MAC80211(priv, "leave - invalid channel\n");
ret = -EINVAL;
goto out;
}
spin_lock_irqsave(&priv->lock, flags);
for_each_context(priv, ctx) {
/* Configure HT40 channels */
if (ctx->ht.enabled != conf_is_ht(conf))
ctx->ht.enabled = conf_is_ht(conf);
if (ctx->ht.enabled) {
if (conf_is_ht40_minus(conf)) {
ctx->ht.extension_chan_offset =
IEEE80211_HT_PARAM_CHA_SEC_BELOW;
ctx->ht.is_40mhz = true;
} else if (conf_is_ht40_plus(conf)) {
ctx->ht.extension_chan_offset =
IEEE80211_HT_PARAM_CHA_SEC_ABOVE;
ctx->ht.is_40mhz = true;
} else {
ctx->ht.extension_chan_offset =
IEEE80211_HT_PARAM_CHA_SEC_NONE;
ctx->ht.is_40mhz = false;
}
} else
ctx->ht.is_40mhz = false;
/*
* Default to no protection. Protection mode will
* later be set from BSS config in iwl_ht_conf
*/
ctx->ht.protection = IEEE80211_HT_OP_MODE_PROTECTION_NONE;
/* if we are switching from ht to 2.4 clear flags
* from any ht related info since 2.4 does not
* support ht */
if (le16_to_cpu(ctx->staging.channel) !=
channel->hw_value)
ctx->staging.flags = 0;
iwl_set_rxon_channel(priv, channel, ctx);
iwl_set_rxon_ht(priv, &priv->current_ht_config);
iwl_set_flags_for_band(priv, ctx, channel->band,
ctx->vif);
}
spin_unlock_irqrestore(&priv->lock, flags);
iwl_update_bcast_stations(priv);
/*
* The list of supported rates and rate mask can be different
* for each band; since the band may have changed, reset
* the rate mask to what mac80211 lists.
*/
iwl_set_rate(priv);
}
/**
* iwl_legacy_mac_config - mac80211 config callback
*/
int iwl_legacy_mac_config(struct ieee80211_hw *hw, u32 changed)
{
struct iwl_priv *priv = hw->priv;
const struct iwl_channel_info *ch_info;
struct ieee80211_conf *conf = &hw->conf;
struct ieee80211_channel *channel = conf->channel;
struct iwl_ht_config *ht_conf = &priv->current_ht_config;
struct iwl_rxon_context *ctx;
unsigned long flags = 0;
int ret = 0;
u16 ch;
int scan_active = 0;
bool ht_changed[NUM_IWL_RXON_CTX] = {};
if (WARN_ON(!priv->cfg->ops->legacy))
return -EOPNOTSUPP;
mutex_lock(&priv->mutex);
IWL_DEBUG_MAC80211(priv, "enter to channel %d changed 0x%X\n",
channel->hw_value, changed);
if (unlikely(test_bit(STATUS_SCANNING, &priv->status))) {
scan_active = 1;
IWL_DEBUG_MAC80211(priv, "scan active\n");
}
if (changed & (IEEE80211_CONF_CHANGE_SMPS |
IEEE80211_CONF_CHANGE_CHANNEL)) {
/* mac80211 uses static for non-HT which is what we want */
priv->current_ht_config.smps = conf->smps_mode;
/*
* Recalculate chain counts.
*
* If monitor mode is enabled then mac80211 will
* set up the SM PS mode to OFF if an HT channel is
* configured.
*/
if (priv->cfg->ops->hcmd->set_rxon_chain)
for_each_context(priv, ctx)
priv->cfg->ops->hcmd->set_rxon_chain(priv, ctx);
}
/* during scanning mac80211 will delay channel setting until
* scan finish with changed = 0
*/
if (!changed || (changed & IEEE80211_CONF_CHANGE_CHANNEL)) {
if (scan_active)
goto set_ch_out;
ch = channel->hw_value;
ch_info = iwl_get_channel_info(priv, channel->band, ch);
if (!is_channel_valid(ch_info)) {
IWL_DEBUG_MAC80211(priv, "leave - invalid channel\n");
ret = -EINVAL;
goto set_ch_out;
}
spin_lock_irqsave(&priv->lock, flags);
for_each_context(priv, ctx) {
/* Configure HT40 channels */
if (ctx->ht.enabled != conf_is_ht(conf)) {
ctx->ht.enabled = conf_is_ht(conf);
ht_changed[ctx->ctxid] = true;
}
if (ctx->ht.enabled) {
if (conf_is_ht40_minus(conf)) {
ctx->ht.extension_chan_offset =
IEEE80211_HT_PARAM_CHA_SEC_BELOW;
ctx->ht.is_40mhz = true;
} else if (conf_is_ht40_plus(conf)) {
ctx->ht.extension_chan_offset =
IEEE80211_HT_PARAM_CHA_SEC_ABOVE;
ctx->ht.is_40mhz = true;
} else {
ctx->ht.extension_chan_offset =
IEEE80211_HT_PARAM_CHA_SEC_NONE;
ctx->ht.is_40mhz = false;
}
} else
ctx->ht.is_40mhz = false;
/*
* Default to no protection. Protection mode will
* later be set from BSS config in iwl_ht_conf
*/
ctx->ht.protection = IEEE80211_HT_OP_MODE_PROTECTION_NONE;
/* if we are switching from ht to 2.4 clear flags
* from any ht related info since 2.4 does not
* support ht */
if ((le16_to_cpu(ctx->staging.channel) != ch))
ctx->staging.flags = 0;
iwl_set_rxon_channel(priv, channel, ctx);
iwl_set_rxon_ht(priv, ht_conf);
iwl_set_flags_for_band(priv, ctx, channel->band,
ctx->vif);
}
spin_unlock_irqrestore(&priv->lock, flags);
if (priv->cfg->ops->legacy->update_bcast_stations)
ret = priv->cfg->ops->legacy->update_bcast_stations(priv);
set_ch_out:
/* The list of supported rates and rate mask can be different
* for each band; since the band may have changed, reset
* the rate mask to what mac80211 lists */
iwl_set_rate(priv);
}
if (changed & (IEEE80211_CONF_CHANGE_PS |
IEEE80211_CONF_CHANGE_IDLE)) {
ret = iwl_power_update_mode(priv, false);
if (ret)
IWL_DEBUG_MAC80211(priv, "Error setting sleep level\n");
}
if (changed & IEEE80211_CONF_CHANGE_POWER) {
IWL_DEBUG_MAC80211(priv, "TX Power old=%d new=%d\n",
priv->tx_power_user_lmt, conf->power_level);
iwl_set_tx_power(priv, conf->power_level, false);
}
if (!iwl_is_ready(priv)) {
IWL_DEBUG_MAC80211(priv, "leave - not ready\n");
goto out;
}
if (scan_active)
goto out;
for_each_context(priv, ctx) {
if (memcmp(&ctx->active, &ctx->staging, sizeof(ctx->staging)))
iwlcore_commit_rxon(priv, ctx);
else
IWL_DEBUG_INFO(priv,
"Not re-sending same RXON configuration.\n");
if (ht_changed[ctx->ctxid])
iwl_update_qos(priv, ctx);
}
out:
IWL_DEBUG_MAC80211(priv, "leave\n");
mutex_unlock(&priv->mutex);
return ret;
}
