static int ssb_gige_pci_write_config(struct pci_bus *bus, unsigned int devfn,
int reg, int size, u32 val)
{
struct ssb_gige *dev = container_of(bus->ops, struct ssb_gige, pci_ops);
unsigned long flags;
if ((PCI_SLOT(devfn) > 0) || (PCI_FUNC(devfn) > 0))
return PCIBIOS_DEVICE_NOT_FOUND;
if (reg >= 256)
return PCIBIOS_DEVICE_NOT_FOUND;
spin_lock_irqsave(&dev->lock, flags);
switch (size) {
case 1:
gige_pcicfg_write8(dev, reg, val);
break;
case 2:
gige_pcicfg_write16(dev, reg, val);
break;
case 4:
gige_pcicfg_write32(dev, reg, val);
break;
default:
WARN_ON(1);
}
spin_unlock_irqrestore(&dev->lock, flags);
return PCIBIOS_SUCCESSFUL;
}
static int ssb_gige_probe(struct ssb_device *sdev, const struct ssb_device_id *id)
{
struct ssb_gige *dev;
u32 base, tmslow, tmshigh;
dev = kzalloc(sizeof(*dev), GFP_KERNEL);
if (!dev)
return -ENOMEM;
dev->dev = sdev;
spin_lock_init(&dev->lock);
dev->pci_controller.pci_ops = &dev->pci_ops;
dev->pci_controller.io_resource = &dev->io_resource;
dev->pci_controller.mem_resource = &dev->mem_resource;
dev->pci_controller.io_map_base = 0x800;
dev->pci_ops.read = ssb_gige_pci_read_config;
dev->pci_ops.write = ssb_gige_pci_write_config;
dev->io_resource.name = SSB_GIGE_IO_RES_NAME;
dev->io_resource.start = 0x800;
dev->io_resource.end = 0x8FF;
dev->io_resource.flags = IORESOURCE_IO | IORESOURCE_PCI_FIXED;
if (!ssb_device_is_enabled(sdev))
ssb_device_enable(sdev, 0);
/* Setup BAR0. This is a 64k MMIO region. */
base = ssb_admatch_base(ssb_read32(sdev, SSB_ADMATCH1));
gige_pcicfg_write32(dev, PCI_BASE_ADDRESS_0, base);
gige_pcicfg_write32(dev, PCI_BASE_ADDRESS_1, 0);
dev->mem_resource.name = SSB_GIGE_MEM_RES_NAME;
dev->mem_resource.start = base;
dev->mem_resource.end = base + 0x10000 - 1;
dev->mem_resource.flags = IORESOURCE_MEM | IORESOURCE_PCI_FIXED;
/* Enable the memory region. */
gige_pcicfg_write16(dev, PCI_COMMAND,
gige_pcicfg_read16(dev, PCI_COMMAND)
| PCI_COMMAND_MEMORY);
/* Write flushing is controlled by the Flush Status Control register.
* We want to flush every register write with a timeout and we want
* to disable the IRQ mask while flushing to avoid concurrency.
* Note that automatic write flushing does _not_ work from
* an IRQ handler. The driver must flush manually by reading a register.
*/
gige_write32(dev, SSB_GIGE_SHIM_FLUSHSTAT, 0x00000068);
/* Check if we have an RGMII or GMII PHY-bus.
* On RGMII do not bypass the DLLs */
tmslow = ssb_read32(sdev, SSB_TMSLOW);
tmshigh = ssb_read32(sdev, SSB_TMSHIGH);
if (tmshigh & SSB_GIGE_TMSHIGH_RGMII) {
tmslow &= ~SSB_GIGE_TMSLOW_TXBYPASS;
tmslow &= ~SSB_GIGE_TMSLOW_RXBYPASS;
dev->has_rgmii = 1;
} else {
tmslow |= SSB_GIGE_TMSLOW_TXBYPASS;
tmslow |= SSB_GIGE_TMSLOW_RXBYPASS;
dev->has_rgmii = 0;
}
tmslow |= SSB_GIGE_TMSLOW_DLLEN;
ssb_write32(sdev, SSB_TMSLOW, tmslow);
ssb_set_drvdata(sdev, dev);
register_pci_controller(&dev->pci_controller);
return 0;
}
static int __devinit ssb_gige_probe(struct ssb_device *sdev,
const struct ssb_device_id *id)
{
struct ssb_gige *dev;
u32 base, tmslow, tmshigh;
dev = kzalloc(sizeof(*dev), GFP_KERNEL);
if (!dev)
return -ENOMEM;
dev->dev = sdev;
spin_lock_init(&dev->lock);
dev->pci_controller.pci_ops = &dev->pci_ops;
dev->pci_controller.io_resource = &dev->io_resource;
dev->pci_controller.mem_resource = &dev->mem_resource;
dev->pci_controller.io_map_base = 0x800;
dev->pci_ops.read = ssb_gige_pci_read_config;
dev->pci_ops.write = ssb_gige_pci_write_config;
dev->io_resource.name = SSB_GIGE_IO_RES_NAME;
dev->io_resource.start = 0x800;
dev->io_resource.end = 0x8FF;
dev->io_resource.flags = IORESOURCE_IO | IORESOURCE_PCI_FIXED;
if (!ssb_device_is_enabled(sdev))
ssb_device_enable(sdev, 0);
base = ssb_admatch_base(ssb_read32(sdev, SSB_ADMATCH1));
gige_pcicfg_write32(dev, PCI_BASE_ADDRESS_0, base);
gige_pcicfg_write32(dev, PCI_BASE_ADDRESS_1, 0);
dev->mem_resource.name = SSB_GIGE_MEM_RES_NAME;
dev->mem_resource.start = base;
dev->mem_resource.end = base + 0x10000 - 1;
dev->mem_resource.flags = IORESOURCE_MEM | IORESOURCE_PCI_FIXED;
gige_pcicfg_write16(dev, PCI_COMMAND,
gige_pcicfg_read16(dev, PCI_COMMAND)
| PCI_COMMAND_MEMORY);
gige_write32(dev, SSB_GIGE_SHIM_FLUSHSTAT, 0x00000068);
tmslow = ssb_read32(sdev, SSB_TMSLOW);
tmshigh = ssb_read32(sdev, SSB_TMSHIGH);
if (tmshigh & SSB_GIGE_TMSHIGH_RGMII) {
tmslow &= ~SSB_GIGE_TMSLOW_TXBYPASS;
tmslow &= ~SSB_GIGE_TMSLOW_RXBYPASS;
dev->has_rgmii = 1;
} else {
tmslow |= SSB_GIGE_TMSLOW_TXBYPASS;
tmslow |= SSB_GIGE_TMSLOW_RXBYPASS;
dev->has_rgmii = 0;
}
tmslow |= SSB_GIGE_TMSLOW_DLLEN;
ssb_write32(sdev, SSB_TMSLOW, tmslow);
ssb_set_drvdata(sdev, dev);
register_pci_controller(&dev->pci_controller);
return 0;
}
