示例#1
0
int smc_set_configuration(int cs, const struct smc_config *config)
{
	unsigned long mul;
	unsigned long offset;
	u32 setup, pulse, cycle, mode;

	if (!hsmc)
		return -ENODEV;
	if (cs >= NR_CHIP_SELECTS)
		return -EINVAL;

	/*
	 * cycles = x / T = x * f
	 *   = ((x * 1000000000) * ((f * 65536) / 1000000000)) / 65536
	 *   = ((x * 1000000000) * (((f / 10000) * 65536) / 100000)) / 65536
	 */
	mul = (clk_get_rate(hsmc->mck) / 10000) << 16;
	mul /= 100000;

#define ns2cyc(x) ((((x) * mul) + 65535) >> 16)

	setup = (HSMC_BF(NWE_SETUP, ns2cyc(config->nwe_setup))
		 | HSMC_BF(NCS_WR_SETUP, ns2cyc(config->ncs_write_setup))
		 | HSMC_BF(NRD_SETUP, ns2cyc(config->nrd_setup))
		 | HSMC_BF(NCS_RD_SETUP, ns2cyc(config->ncs_read_setup)));
	pulse = (HSMC_BF(NWE_PULSE, ns2cyc(config->nwe_pulse))
		 | HSMC_BF(NCS_WR_PULSE, ns2cyc(config->ncs_write_pulse))
		 | HSMC_BF(NRD_PULSE, ns2cyc(config->nrd_pulse))
		 | HSMC_BF(NCS_RD_PULSE, ns2cyc(config->ncs_read_pulse)));
	cycle = (HSMC_BF(NWE_CYCLE, ns2cyc(config->write_cycle))
		 | HSMC_BF(NRD_CYCLE, ns2cyc(config->read_cycle)));

	switch (config->bus_width) {
	case 1:
		mode = HSMC_BF(DBW, HSMC_DBW_8_BITS);
		break;
	case 2:
		mode = HSMC_BF(DBW, HSMC_DBW_16_BITS);
		break;
	case 4:
		mode = HSMC_BF(DBW, HSMC_DBW_32_BITS);
		break;
	default:
		return -EINVAL;
	}

	if (config->nrd_controlled)
		mode |= HSMC_BIT(READ_MODE);
	if (config->nwe_controlled)
		mode |= HSMC_BIT(WRITE_MODE);
	if (config->byte_write)
		mode |= HSMC_BIT(BAT);

	pr_debug("smc cs%d: setup/%08x pulse/%08x cycle/%08x mode/%08x\n",
		 cs, setup, pulse, cycle, mode);

	offset = cs * 0x10;
	hsmc_writel(hsmc, SETUP0 + offset, setup);
	hsmc_writel(hsmc, PULSE0 + offset, pulse);
	hsmc_writel(hsmc, CYCLE0 + offset, cycle);
	hsmc_writel(hsmc, MODE0 + offset, mode);
	hsmc_readl(hsmc, MODE0); /* I/O barrier */

	return 0;
}
示例#2
0
void smc_set_timing(struct smc_config *config,
		    const struct smc_timing *timing)
{
	int recover;
	int cycle;

	unsigned long mul;

	/* Reset all SMC timings */
	config->ncs_read_setup	= 0;
	config->nrd_setup	= 0;
	config->ncs_write_setup	= 0;
	config->nwe_setup	= 0;
	config->ncs_read_pulse	= 0;
	config->nrd_pulse	= 0;
	config->ncs_write_pulse	= 0;
	config->nwe_pulse	= 0;
	config->read_cycle	= 0;
	config->write_cycle	= 0;

	/*
	 * cycles = x / T = x * f
	 *   = ((x * 1000000000) * ((f * 65536) / 1000000000)) / 65536
	 *   = ((x * 1000000000) * (((f / 10000) * 65536) / 100000)) / 65536
	 */
	mul = (clk_get_rate(hsmc->mck) / 10000) << 16;
	mul /= 100000;

#define ns2cyc(x) ((((x) * mul) + 65535) >> 16)

	if (timing->ncs_read_setup > 0)
		config->ncs_read_setup = ns2cyc(timing->ncs_read_setup);

	if (timing->nrd_setup > 0)
		config->nrd_setup = ns2cyc(timing->nrd_setup);

	if (timing->ncs_write_setup > 0)
		config->ncs_write_setup = ns2cyc(timing->ncs_write_setup);

	if (timing->nwe_setup > 0)
		config->nwe_setup = ns2cyc(timing->nwe_setup);

	if (timing->ncs_read_pulse > 0)
		config->ncs_read_pulse = ns2cyc(timing->ncs_read_pulse);

	if (timing->nrd_pulse > 0)
		config->nrd_pulse = ns2cyc(timing->nrd_pulse);

	if (timing->ncs_write_pulse > 0)
		config->ncs_write_pulse = ns2cyc(timing->ncs_write_pulse);

	if (timing->nwe_pulse > 0)
		config->nwe_pulse = ns2cyc(timing->nwe_pulse);

	if (timing->read_cycle > 0)
		config->read_cycle = ns2cyc(timing->read_cycle);

	if (timing->write_cycle > 0)
		config->write_cycle = ns2cyc(timing->write_cycle);

	/* Extend read cycle in needed */
	if (timing->ncs_read_recover > 0)
		recover = ns2cyc(timing->ncs_read_recover);
	else
		recover = 1;

	cycle = config->ncs_read_setup + config->ncs_read_pulse + recover;

	if (config->read_cycle < cycle)
		config->read_cycle = cycle;

	/* Extend read cycle in needed */
	if (timing->nrd_recover > 0)
		recover = ns2cyc(timing->nrd_recover);
	else
		recover = 1;

	cycle = config->nrd_setup + config->nrd_pulse + recover;

	if (config->read_cycle < cycle)
		config->read_cycle = cycle;

	/* Extend write cycle in needed */
	if (timing->ncs_write_recover > 0)
		recover = ns2cyc(timing->ncs_write_recover);
	else
		recover = 1;

	cycle = config->ncs_write_setup + config->ncs_write_pulse + recover;

	if (config->write_cycle < cycle)
		config->write_cycle = cycle;

	/* Extend write cycle in needed */
	if (timing->nwe_recover > 0)
		recover = ns2cyc(timing->nwe_recover);
	else
		recover = 1;

	cycle = config->nwe_setup + config->nwe_pulse + recover;

	if (config->write_cycle < cycle)
		config->write_cycle = cycle;
}