/* Return amount of RAM in bytes */
long ramsize(void)
{
static long size = 0;
if(!size){
size = probe_memory(RAM_BASE,RAM_MAX_SIZE);
}
return size;
}
int _start(char *boot_args, char *monitor)
{
unsigned int bootdir_pages;
memset(&ka, 0, sizeof(ka));
init_nextmon(monitor);
dprintf("\nNewOS stage2: args '%s', monitor %p\n", boot_args, monitor);
probe_memory(&ka);
dprintf("tc 0x%x\n", get_tc());
dprintf("urp 0x%x\n", get_urp());
dprintf("srp 0x%x\n", get_srp());
// calculate how big the bootdir is
{
int entry;
bootdir_pages = 0;
for (entry = 0; entry < BOOTDIR_MAX_ENTRIES; entry++) {
if (bootdir[entry].be_type == BE_TYPE_NONE)
break;
bootdir_pages += bootdir[entry].be_size;
}
ka.bootdir_addr.start = (unsigned long)bootdir;
ka.bootdir_addr.size = bootdir_pages * PAGE_SIZE;
dprintf("bootdir: start %p, size 0x%x\n", (char *)ka.bootdir_addr.start, ka.bootdir_addr.size);
}
// begin to set up the physical page allocation range data structures
ka.num_phys_alloc_ranges = 1;
ka.phys_alloc_range[0].start = ka.bootdir_addr.start;
ka.phys_alloc_range[0].size = ka.bootdir_addr.size;
// allocate a stack for the kernel when we jump into it
ka.cpu_kstack[0].start = allocate_page(&ka);
ka.cpu_kstack[0].size = PAGE_SIZE;
ka.num_cpus = 1;
return 0;
}
void __init sgimc_init(void)
{
u32 tmp;
/* ioremap can't fail */
sgimc = (struct sgimc_regs *)
ioremap(SGIMC_BASE, sizeof(struct sgimc_regs));
printk(KERN_INFO "MC: SGI memory controller Revision %d\n",
(int) sgimc->systemid & SGIMC_SYSID_MASKREV);
/* Place the MC into a known state. This must be done before
* interrupts are first enabled etc.
*/
/* Step 0: Make sure we turn off the watchdog in case it's
* still running (which might be the case after a
* soft reboot).
*/
tmp = sgimc->cpuctrl0;
tmp &= ~SGIMC_CCTRL0_WDOG;
sgimc->cpuctrl0 = tmp;
/* Step 1: The CPU/GIO error status registers will not latch
* up a new error status until the register has been
* cleared by the cpu. These status registers are
* cleared by writing any value to them.
*/
sgimc->cstat = sgimc->gstat = 0;
/* Step 2: Enable all parity checking in cpu control register
* zero.
*/
/* don't touch parity settings for IP28 */
tmp = sgimc->cpuctrl0;
#ifndef CONFIG_SGI_IP28
tmp |= SGIMC_CCTRL0_EPERRGIO | SGIMC_CCTRL0_EPERRMEM;
#endif
tmp |= SGIMC_CCTRL0_R4KNOCHKPARR;
sgimc->cpuctrl0 = tmp;
/* Step 3: Setup the MC write buffer depth, this is controlled
* in cpu control register 1 in the lower 4 bits.
*/
tmp = sgimc->cpuctrl1;
tmp &= ~0xf;
tmp |= 0xd;
sgimc->cpuctrl1 = tmp;
/* Step 4: Initialize the RPSS divider register to run as fast
* as it can correctly operate. The register is laid
* out as follows:
*
* ----------------------------------------
* | RESERVED | INCREMENT | DIVIDER |
* ----------------------------------------
* 31 16 15 8 7 0
*
* DIVIDER determines how often a 'tick' happens,
* INCREMENT determines by how the RPSS increment
* registers value increases at each 'tick'. Thus,
* for IP22 we get INCREMENT=1, DIVIDER=1 == 0x101
*/
sgimc->divider = 0x101;
/* Step 5: Initialize GIO64 arbitrator configuration register.
*
* NOTE: HPC init code in sgihpc_init() must run before us because
* we need to know Guiness vs. FullHouse and the board
* revision on this machine. You have been warned.
*/
/* First the basic invariants across all GIO64 implementations. */
tmp = sgimc->giopar & SGIMC_GIOPAR_GFX64; /* keep gfx 64bit settings */
tmp |= SGIMC_GIOPAR_HPC64; /* All 1st HPC's interface at 64bits */
tmp |= SGIMC_GIOPAR_ONEBUS; /* Only one physical GIO bus exists */
if (ip22_is_fullhouse()) {
/* Fullhouse specific settings. */
if (SGIOC_SYSID_BOARDREV(sgioc->sysid) < 2) {
tmp |= SGIMC_GIOPAR_HPC264; /* 2nd HPC at 64bits */
tmp |= SGIMC_GIOPAR_PLINEEXP0; /* exp0 pipelines */
tmp |= SGIMC_GIOPAR_MASTEREXP1; /* exp1 masters */
tmp |= SGIMC_GIOPAR_RTIMEEXP0; /* exp0 is realtime */
} else {
tmp |= SGIMC_GIOPAR_HPC264; /* 2nd HPC 64bits */
tmp |= SGIMC_GIOPAR_PLINEEXP0; /* exp[01] pipelined */
tmp |= SGIMC_GIOPAR_PLINEEXP1;
tmp |= SGIMC_GIOPAR_MASTEREISA; /* EISA masters */
}
} else {
/* Guiness specific settings. */
tmp |= SGIMC_GIOPAR_EISA64; /* MC talks to EISA at 64bits */
tmp |= SGIMC_GIOPAR_MASTEREISA; /* EISA bus can act as master */
}
sgimc->giopar = tmp; /* poof */
probe_memory();
}