int rl78_cmd_baud_rate_set(port_handle_t fd, int baud, float voltage)
{
unsigned char buf[2];
int baud_code;
switch (baud)
{
default:
fprintf(stderr, "Unsupported baudrate %ubps. Using default baudrate 115200bps.\n", baud);
baud = 115200;
case 115200:
baud_code = RL78_BAUD_115200;
break;
case 250000:
baud_code = RL78_BAUD_250000;
break;
case 500000:
baud_code = RL78_BAUD_500000;
break;
case 1000000:
baud_code = RL78_BAUD_1000000;
break;
}
buf[0] = baud_code;
buf[1] = (int)(voltage * 10);
if (3 <= verbose_level)
{
printf("Send \"Set Baud Rate\" command (baud=%ubps, voltage=%1.1fV)\n", baud, voltage);
}
rl78_send_cmd(fd, CMD_BAUD_RATE_SET, buf, 2);
int len = 0;
unsigned char data[3];
int rc = rl78_recv(fd, &data, &len, 3);
if (RESPONSE_OK != rc)
{
fprintf(stderr, "FAILED\n");
return rc;
}
if (STATUS_ACK != data[0])
{
fprintf(stderr, "ACK not received\n");
return data[0];
}
if (3 <= verbose_level)
{
printf("\tOK\n");
printf("\tFrequency: %u MHz\n", data[1]);
printf("\tMode: %s\n", 0 == data[2] ? "full-speed mode" : "wide-voltage mode");
}
/* If no need to change baudrate, just exit */
if (115200 == baud)
{
return 0;
}
return serial_set_baud(fd, baud);
}
/** Creates a basic fd, setting baud to 9600, raw data i/o (no flow
control, no fancy character handling. Configures it for blocking
reads.
Returns the fd, -1 on error
**/
int serial_open(const char *port, int baud, int blocking)
{
struct termios opts;
int flags = O_RDWR | O_NOCTTY;
if (!blocking)
flags |= O_NONBLOCK;
int fd=open(port, flags, 0);
if (fd==-1)
return -1;
if (tcgetattr(fd, &opts))
{
printf("*** %i\n",fd);
perror("tcgetattr");
return -1;
}
cfsetispeed(&opts, serial_translate_baud(9600));
cfsetospeed(&opts, serial_translate_baud(9600));
cfmakeraw(&opts);
// set one stop bit
opts.c_cflag &= ~CSTOPB;
if (tcsetattr(fd,TCSANOW,&opts)) {
perror("tcsetattr");
return -1;
}
tcflush(fd, TCIOFLUSH);
serial_set_baud(fd, baud);
return fd;
}
/* Symbol for common u-boot code to call.
* Setup the baudrate (brg: baudrate generator).
*/
void serial_setbrg(void)
{
DECLARE_GLOBAL_DATA_PTR;
serial_set_baud(gd->baudrate);
}
