static void __init mpr2_setup(char **cmdline_p)
{
__raw_writew(0xAABC, PORT_PSELA);
__raw_writew(0x3C00, PORT_PSELB);
__raw_writew(0x0000, PORT_PSELC);
__raw_writew(0x0000, PORT_PSELD);
__raw_writew(0x0101, PORT_UTRCTL);
__raw_writew(0xA5C0, PORT_UCLKCR_W);
setup_chip_select();
setup_port_multiplexing();
reset_ethernet();
printk(KERN_INFO "Magic Panel Release 2 A.%i\n",
CONFIG_SH_MAGIC_PANEL_R2_VERSION);
if (ethernet_reset_finished() == 0)
printk(KERN_WARNING "Ethernet not ready\n");
}
static void __init mpr2_setup(char **cmdline_p)
{
/* set Pin Select Register A:
* /PCC_CD1, /PCC_CD2, PCC_BVD1, PCC_BVD2,
* /IOIS16, IRQ4, IRQ5, USB1d_SUSPEND
*/
ctrl_outw(0xAABC, PORT_PSELA);
/* set Pin Select Register B:
* /SCIF0_RTS, /SCIF0_CTS, LCD_VCPWC,
* LCD_VEPWC, IIC_SDA, IIC_SCL, Reserved
*/
ctrl_outw(0x3C00, PORT_PSELB);
/* set Pin Select Register C:
* SIOF1_SCK, SIOF1_RxD, SCIF1_RxD, SCIF1_TxD, Reserved
*/
ctrl_outw(0x0000, PORT_PSELC);
/* set Pin Select Register D: Reserved, SIOF1_TxD, Reserved, SIOF1_MCLK,
* Reserved, SIOF1_SYNC, Reserved, SCIF1_SCK, Reserved
*/
ctrl_outw(0x0000, PORT_PSELD);
/* set USB TxRx Control: Reserved, DRV, Reserved, USB_TRANS, USB_SEL */
ctrl_outw(0x0101, PORT_UTRCTL);
/* set USB Clock Control: USSCS, USSTB, Reserved (HighByte always A5) */
ctrl_outw(0xA5C0, PORT_UCLKCR_W);
setup_chip_select();
setup_port_multiplexing();
reset_ethernet();
printk(KERN_INFO "Magic Panel Release 2 A.%i\n",
CONFIG_SH_MAGIC_PANEL_R2_VERSION);
if (ethernet_reset_finished() == 0)
printk(KERN_WARNING "Ethernet not ready\n");
}
