void LeweiTcpClient::writeRom(String value)
{
for(int i =0;i<52;i++)
{
EEPROM.write(i, value.charAt(i));
}
softwareReset();
}
void
Mci::initialise(mci::CardSlot_t cardSlot)
{
OSDeviceDebug::putString("avr32::uc3::Mci::initialise()");
OSDeviceDebug::putNewLine();
m_shadowStatusRegister = 0;
softwareReset();
disableInterface();
disableAllInterrupts();
clearConfiguration();
clearModeBits();
// Set the Data Timeout Register to 1 Mega Cycles
initDataTimeout(MCI_DEFAULT_DTOLMUL, MCI_DEFAULT_DTOLCYC);
// Start with low speed
configureClockFrequencyHz(400000);
// Set the Mode register
// The two bits, Read Proof Enable and Write Proof Enable in the
// MR register (MR.RDPROOF and MR.WRPROOF) allow stopping the
// MCI Clock (CLK) during read or write access if the internal
// FIFO is full. This will guarantee data integrity, not bandwidth
enableModeBits(
(MCI_DEFAULT_PWSDIV << AVR32_MCI_MR_PWSDIV)
| AVR32_MCI_MR_RDPROOF_MASK | AVR32_MCI_MR_WRPROOF_MASK);
// Set the SD/MMC Card register
// Start with bus width = 1bit
configureSdCardBusWidthAndSlot(mci::BusWidth::_1bit, cardSlot);
// Enable the MCI and the Power Saving
// The Power Save Mode Enable bit in the CR register (CR.PWSEN)
// saves power by dividing the MCI clock (CLK) by 2PWSDIV + 1
// when the bus is inactive. The Power Saving Divider field locates
// in the Mode Register (MR.PWSDIV).
enableInterface();
}
uint32_t
sdHalInit()
{
enableIfaceAndFunctionalClock();
if ( softwareReset() )
{
return 1;
}
if ( resetLines( MMCHS_SYSCTL_SRA_BIT ) )
{
return 1;
}
selectSupportedVoltage( MMCHS_CAPA_VS18_BIT | MMCHS_CAPA_VS30_BIT );
// want enable wakeup when card is inserted
systemConfig( MMCHS_SYSCONFIG_AUTOIDLE_BIT /*| MMCHS_SYSCONFIG_ENAWAKEUP_BIT */ );
setBusWidth( BUS_WIDTH_1BIT );
setBusVoltage( MMCHS_HCTL_SDVS_30V_BIT );
if ( setBusPower( TRUE ) )
{
return 1;
}
// need some initial clock divider otherwise would not work to set the bus frequency
MMCHS_SYSCTL = 0x0000a007;
if ( setBusFrequency( SDMMC_CONTROLLER_CLOCK, SDMMC_BUS_CLOCK, FALSE ) )
{
return 1;
}
/*
// wake-up event enabled on card-insertion
MMCHS_HCTL |= MMCHS_HCTL_INS_BIT;
// clear all and set card-interrupt enable
MMCHS_ISE = MMCHS_ISE_CIRQ_SIGEN_BIT;
// TODO: the next only when card is inserted!
*/
sendInitStream();
if ( identifyCard() )
{
return 1;
}
if ( configBusWidth() )
{
return 1;
}
configTransferSpeed();
return 0;
}