static void h3600_audio_shutdown(void *dummy)
{
/* disable the audio power and all signals leading to the audio chip */
l3_close(&uda1341);
Ser4SSCR0 = 0;
clr_h3600_egpio(IPAQ_EGPIO_CODEC_NRESET);
clr_h3600_egpio(IPAQ_EGPIO_AUDIO_ON);
clr_h3600_egpio(IPAQ_EGPIO_QMUTE);
}
static void pangolin_audio_shutdown(void *dummy)
{
GPSR = QmutePin;
l3_close(&uda1341);
Ser4SSCR0 = 0;
MDREFR &= ~(MDREFR_K2DB2 | MDREFR_K2RUN);
}
/*
* Shutdown the Assabet audio driver.
*
* We have to be careful about the SFRM line here for the same reasons
* described in the initialisation comments above. This basically means
* that we must hand the SSP pins back to the GPIO module before disabling
* the SSP.
*
* In addition, to reduce power drain, we toggle the SFRM line once so
* that the UDA_WS line is at logic 0.
*
* We can't clear ASSABET_BCR_CODEC_RST without knowing if the UCB1300 or
* ADV7171 driver is still active. If it is, then we still need to play
* games, so we might as well leave ASSABET_BCR_CODEC_RST set.
*/
static void assabet_audio_shutdown(void *dummy)
{
ASSABET_BCR_set(ASSABET_BCR_STEREO_LB | ASSABET_BCR_QMUTE |
ASSABET_BCR_SPK_OFF);
l3_close(&uda1341);
GAFR &= ~(GPIO_SSP_TXD | GPIO_SSP_RXD | GPIO_SSP_SCLK | GPIO_SSP_SFRM);
Ser4SSCR0 = 0;
#ifdef FIX_POWER_DRAIN
GPSR = GPIO_SSP_SFRM;
GPCR = GPIO_SSP_SFRM;
#endif
/* disable the audio power */
ASSABET_BCR_clear(ASSABET_BCR_AUDIO_ON);
}
static void omap1510_audio_shutdown(void *dummy)
{
u8 fpga;
printk(__FUNCTION__ "called\n");
#ifndef CONFIG_DSP_MCBSP1
// Disable the McBSP channel
outw(0x0000, OMAP1510_MCBSP1_BASE + 0x806); // flush data
outw(0x0000, OMAP1510_MCBSP1_BASE + 0x806); // flush data
outw(0x0000, OMAP1510_MCBSP1_BASE + 0x80a); // disable SPCR1
outw(0x0000, OMAP1510_MCBSP1_BASE + 0x808); // disable SPCR2
#endif
/* disable the audio clocks/signals */
l3_close(&uda1341);
// Turn off clocks, but don't turn off audio amplifier
// or you will hear a nasty noise when you turn it back
// on.
fpga = 0;
fpga_write(fpga, OMAP1510P1_FPGA_AUDIO);
}
static void sa1111_audio_shutdown(void *dummy)
{
l3_close(&uda1341);
SACR0 &= ~SACR0_ENB;
}
