Example #1
0
static int load_mc_dpc(u64 mc_ram_addr, size_t mc_ram_size)
{
	u64 mc_dpc_offset;
#ifndef CONFIG_SYS_LS_MC_DPC_IN_DDR
	int error;
	void *dpc_fdt_hdr;
	int dpc_size;
#endif

#ifdef CONFIG_SYS_LS_MC_DRAM_DPC_OFFSET
	BUILD_BUG_ON((CONFIG_SYS_LS_MC_DRAM_DPC_OFFSET & 0x3) != 0 ||
		     CONFIG_SYS_LS_MC_DRAM_DPC_OFFSET > 0xffffffff);

	mc_dpc_offset = CONFIG_SYS_LS_MC_DRAM_DPC_OFFSET;
#else
#error "CONFIG_SYS_LS_MC_DRAM_DPC_OFFSET not defined"
#endif

	/*
	 * Load the MC DPC blob in the MC private DRAM block:
	 */
#ifdef CONFIG_SYS_LS_MC_DPC_IN_DDR
	printf("MC DPC is preloaded to %#llx\n", mc_ram_addr + mc_dpc_offset);
#else
	/*
	 * Get address and size of the DPC blob stored in flash:
	 */
#ifdef CONFIG_SYS_LS_MC_DPC_IN_NOR
	dpc_fdt_hdr = (void *)CONFIG_SYS_LS_MC_DPC_ADDR;
#else
#error "No CONFIG_SYS_LS_MC_DPC_IN_xxx defined"
#endif

	error = fdt_check_header(dpc_fdt_hdr);
	if (error != 0) {
		/*
		 * Don't return with error here, since the MC firmware can
		 * still boot without a DPC
		 */
		printf("\nfsl-mc: WARNING: No DPC image found");
		return 0;
	}

	dpc_size = fdt_totalsize(dpc_fdt_hdr);
	if (dpc_size > CONFIG_SYS_LS_MC_DPC_MAX_LENGTH) {
		printf("\nfsl-mc: ERROR: Bad DPC image (too large: %d)\n",
		       dpc_size);
		return -EINVAL;
	}

	mc_copy_image("MC DPC blob",
		      (u64)dpc_fdt_hdr, dpc_size, mc_ram_addr + mc_dpc_offset);
#endif /* not defined CONFIG_SYS_LS_MC_DPC_IN_DDR */

	if (mc_fixup_dpc(mc_ram_addr + mc_dpc_offset))
		return -EINVAL;

	dump_ram_words("DPC", (void *)(mc_ram_addr + mc_dpc_offset));
	return 0;
}
Example #2
0
static int load_mc_dpl(u64 mc_ram_addr, size_t mc_ram_size)
{
	u64 mc_dpl_offset;
#ifndef CONFIG_SYS_LS_MC_DPL_IN_DDR
	int error;
	void *dpl_fdt_hdr;
	int dpl_size;
#endif

#ifdef CONFIG_SYS_LS_MC_DRAM_DPL_OFFSET
	BUILD_BUG_ON((CONFIG_SYS_LS_MC_DRAM_DPL_OFFSET & 0x3) != 0 ||
		     CONFIG_SYS_LS_MC_DRAM_DPL_OFFSET > 0xffffffff);

	mc_dpl_offset = CONFIG_SYS_LS_MC_DRAM_DPL_OFFSET;
#else
#error "CONFIG_SYS_LS_MC_DRAM_DPL_OFFSET not defined"
#endif

	/*
	 * Load the MC DPL blob in the MC private DRAM block:
	 */
#ifdef CONFIG_SYS_LS_MC_DPL_IN_DDR
	printf("MC DPL is preloaded to %#llx\n", mc_ram_addr + mc_dpl_offset);
#else
	/*
	 * Get address and size of the DPL blob stored in flash:
	 */
#ifdef CONFIG_SYS_LS_MC_DPL_IN_NOR
	dpl_fdt_hdr = (void *)CONFIG_SYS_LS_MC_DPL_ADDR;
#else
#error "No CONFIG_SYS_LS_MC_DPL_IN_xxx defined"
#endif

	error = fdt_check_header(dpl_fdt_hdr);
	if (error != 0) {
		printf("\nfsl-mc: ERROR: Bad DPL image (bad header)\n");
		return error;
	}

	dpl_size = fdt_totalsize(dpl_fdt_hdr);
	if (dpl_size > CONFIG_SYS_LS_MC_DPL_MAX_LENGTH) {
		printf("\nfsl-mc: ERROR: Bad DPL image (too large: %d)\n",
		       dpl_size);
		return -EINVAL;
	}

	mc_copy_image("MC DPL blob",
		      (u64)dpl_fdt_hdr, dpl_size, mc_ram_addr + mc_dpl_offset);
#endif /* not defined CONFIG_SYS_LS_MC_DPL_IN_DDR */

	dump_ram_words("DPL", (void *)(mc_ram_addr + mc_dpl_offset));
	return 0;
}
Example #3
0
int mc_init(u64 mc_fw_addr, u64 mc_dpc_addr)
{
	int error = 0;
	int portal_id = 0;
	struct mc_ccsr_registers __iomem *mc_ccsr_regs = MC_CCSR_BASE_ADDR;
	u64 mc_ram_addr = mc_get_dram_addr();
	u32 reg_gsr;
	u32 reg_mcfbalr;
#ifndef CONFIG_SYS_LS_MC_FW_IN_DDR
	const void *raw_image_addr;
	size_t raw_image_size = 0;
#endif
	struct mc_version mc_ver_info;
	u64 mc_ram_aligned_base_addr;
	u8 mc_ram_num_256mb_blocks;
	size_t mc_ram_size = mc_get_dram_block_size();


	error = calculate_mc_private_ram_params(mc_ram_addr,
						mc_ram_size,
						&mc_ram_aligned_base_addr,
						&mc_ram_num_256mb_blocks);
	if (error != 0)
		goto out;

	/*
	 * Management Complex cores should be held at reset out of POR.
	 * U-boot should be the first software to touch MC. To be safe,
	 * we reset all cores again by setting GCR1 to 0. It doesn't do
	 * anything if they are held at reset. After we setup the firmware
	 * we kick off MC by deasserting the reset bit for core 0, and
	 * deasserting the reset bits for Command Portal Managers.
	 * The stop bits are not touched here. They are used to stop the
	 * cores when they are active. Setting stop bits doesn't stop the
	 * cores from fetching instructions when they are released from
	 * reset.
	 */
	out_le32(&mc_ccsr_regs->reg_gcr1, 0);
	dmb();

#ifdef CONFIG_SYS_LS_MC_FW_IN_DDR
	printf("MC firmware is preloaded to %#llx\n", mc_ram_addr);
#else
	error = parse_mc_firmware_fit_image(mc_fw_addr, &raw_image_addr,
					    &raw_image_size);
	if (error != 0)
		goto out;
	/*
	 * Load the MC FW at the beginning of the MC private DRAM block:
	 */
	mc_copy_image("MC Firmware",
		      (u64)raw_image_addr, raw_image_size, mc_ram_addr);
#endif
	dump_ram_words("firmware", (void *)mc_ram_addr);

	error = load_mc_dpc(mc_ram_addr, mc_ram_size, mc_dpc_addr);
	if (error != 0)
		goto out;

	debug("mc_ccsr_regs %p\n", mc_ccsr_regs);
	dump_mc_ccsr_regs(mc_ccsr_regs);

	/*
	 * Tell MC what is the address range of the DRAM block assigned to it:
	 */
	reg_mcfbalr = (u32)mc_ram_aligned_base_addr |
		      (mc_ram_num_256mb_blocks - 1);
	out_le32(&mc_ccsr_regs->reg_mcfbalr, reg_mcfbalr);
	out_le32(&mc_ccsr_regs->reg_mcfbahr,
		 (u32)(mc_ram_aligned_base_addr >> 32));
	out_le32(&mc_ccsr_regs->reg_mcfapr, FSL_BYPASS_AMQ);

	/*
	 * Tell the MC that we want delayed DPL deployment.
	 */
	out_le32(&mc_ccsr_regs->reg_gsr, 0xDD00);

	printf("\nfsl-mc: Booting Management Complex ... ");

	/*
	 * Deassert reset and release MC core 0 to run
	 */
	out_le32(&mc_ccsr_regs->reg_gcr1, GCR1_P1_DE_RST | GCR1_M_ALL_DE_RST);
	error = wait_for_mc(true, &reg_gsr);
	if (error != 0)
		goto out;

	/*
	 * TODO: need to obtain the portal_id for the root container from the
	 * DPL
	 */
	portal_id = 0;

	/*
	 * Initialize the global default MC portal
	 * And check that the MC firmware is responding portal commands:
	 */
	root_mc_io = (struct fsl_mc_io *)malloc(sizeof(struct fsl_mc_io));
	if (!root_mc_io) {
		printf(" No memory: malloc() failed\n");
		return -ENOMEM;
	}

	root_mc_io->mmio_regs = SOC_MC_PORTAL_ADDR(portal_id);
	debug("Checking access to MC portal of root DPRC container (portal_id %d, portal physical addr %p)\n",
	      portal_id, root_mc_io->mmio_regs);

	error = mc_get_version(root_mc_io, MC_CMD_NO_FLAGS, &mc_ver_info);
	if (error != 0) {
		printf("fsl-mc: ERROR: Firmware version check failed (error: %d)\n",
		       error);
		goto out;
	}

	if (MC_VER_MAJOR != mc_ver_info.major) {
		printf("fsl-mc: ERROR: Firmware major version mismatch (found: %d, expected: %d)\n",
		       mc_ver_info.major, MC_VER_MAJOR);
		printf("fsl-mc: Update the Management Complex firmware\n");

		error = -ENODEV;
		goto out;
	}

	if (MC_VER_MINOR != mc_ver_info.minor)
		printf("fsl-mc: WARNING: Firmware minor version mismatch (found: %d, expected: %d)\n",
		       mc_ver_info.minor, MC_VER_MINOR);

	printf("fsl-mc: Management Complex booted (version: %d.%d.%d, boot status: %#x)\n",
	       mc_ver_info.major, mc_ver_info.minor, mc_ver_info.revision,
	       reg_gsr & GSR_FS_MASK);

out:
	if (error != 0)
		mc_boot_status = error;
	else
		mc_boot_status = 0;

	return error;
}