static void __devinit palm_bk3710_chipinit(void __iomem *base)
{
/*
* REVISIT: the ATA reset signal needs to be managed through a
* GPIO, which means it should come from platform_data. Until
* we get and use such information, we have to trust that things
* have been reset before we get here.
*/
/*
* Program the IDETIMP Register Value based on the following assumptions
*
* (ATA_IDETIMP_IDEEN , ENABLE ) |
* (ATA_IDETIMP_PREPOST1 , DISABLE) |
* (ATA_IDETIMP_PREPOST0 , DISABLE) |
*
* DM6446 silicon rev 2.1 and earlier have no observed net benefit
* from enabling prefetch/postwrite.
*/
writew(BIT(15), base + BK3710_IDETIMP);
/*
* UDMACTL Ultra-ATA DMA Control
* (ATA_UDMACTL_UDMAP1 , 0 ) |
* (ATA_UDMACTL_UDMAP0 , 0 )
*
*/
writew(0, base + BK3710_UDMACTL);
/*
* MISCCTL Miscellaneous Conrol Register
* (ATA_MISCCTL_HWNHLD1P , 1 cycle)
* (ATA_MISCCTL_HWNHLD0P , 1 cycle)
* (ATA_MISCCTL_TIMORIDE , 1)
*/
writel(0x001, base + BK3710_MISCCTL);
/*
* IORDYTMP IORDY Timer for Primary Register
* (ATA_IORDYTMP_IORDYTMP , 0xffff )
*/
writel(0xFFFF, base + BK3710_IORDYTMP);
/*
* Configure BMISP Register
* (ATA_BMISP_DMAEN1 , DISABLE ) |
* (ATA_BMISP_DMAEN0 , DISABLE ) |
* (ATA_BMISP_IORDYINT , CLEAR) |
* (ATA_BMISP_INTRSTAT , CLEAR) |
* (ATA_BMISP_DMAERROR , CLEAR)
*/
writew(0, base + BK3710_BMISP);
palm_bk3710_setpiomode(base, NULL, 0, 600, 0);
palm_bk3710_setpiomode(base, NULL, 1, 600, 0);
}
static void palm_bk3710_set_pio_mode(ide_drive_t *drive, u8 pio)
{
unsigned int cycle_time;
int is_slave = drive->dn & 1;
ide_drive_t *mate;
void __iomem *base = (void *)drive->hwif->dma_base;
/*
* Obtain the drive PIO data for tuning the Palm Chip registers
*/
cycle_time = ide_pio_cycle_time(drive, pio);
mate = ide_get_pair_dev(drive);
palm_bk3710_setpiomode(base, mate, is_slave, cycle_time, pio);
}
static void palm_bk3710_tune_drive(ide_drive_t *drive, u8 pio)
{
ide_pio_data_t piodata;
int is_slave = drive->dn & 1;
ide_drive_t *mate;
void __iomem *base = (void *)drive->hwif->dma_base;
/*
* Obtain the drive PIO data for tuning the Palm Chip registers
*/
pio = ide_get_best_pio_mode(drive, pio, 4, &piodata);
mate = ide_get_paired_drive(drive);
palm_bk3710_setpiomode(base, mate, is_slave, piodata.cycle_time, pio);
(void)ide_config_drive_speed(drive, XFER_PIO_0 + pio);
}
static void __devinit palm_bk3710_chipinit(void __iomem *base)
{
/*
* enable the reset_en of ATA controller so that when ata signals
* are brought out, by writing into device config. at that
* time por_n signal should not be 'Z' and have a stable value.
*/
writel(0x0300, base + BK3710_MISCCTL);
/* wait for some time and deassert the reset of ATA Device. */
mdelay(100);
/* Deassert the Reset */
writel(0x0200, base + BK3710_MISCCTL);
/*
* Program the IDETIMP Register Value based on the following assumptions
*
* (ATA_IDETIMP_IDEEN , ENABLE ) |
* (ATA_IDETIMP_SLVTIMEN , DISABLE) |
* (ATA_IDETIMP_RDYSMPL , 70NS) |
* (ATA_IDETIMP_RDYRCVRY , 50NS) |
* (ATA_IDETIMP_DMAFTIM1 , PIOCOMP) |
* (ATA_IDETIMP_PREPOST1 , DISABLE) |
* (ATA_IDETIMP_RDYSEN1 , DISABLE) |
* (ATA_IDETIMP_PIOFTIM1 , DISABLE) |
* (ATA_IDETIMP_DMAFTIM0 , PIOCOMP) |
* (ATA_IDETIMP_PREPOST0 , DISABLE) |
* (ATA_IDETIMP_RDYSEN0 , DISABLE) |
* (ATA_IDETIMP_PIOFTIM0 , DISABLE)
*/
writew(0xB388, base + BK3710_IDETIMP);
/*
* Configure SIDETIM Register
* (ATA_SIDETIM_RDYSMPS1 ,120NS ) |
* (ATA_SIDETIM_RDYRCYS1 ,120NS )
*/
writeb(0, base + BK3710_SIDETIM);
/*
* UDMACTL Ultra-ATA DMA Control
* (ATA_UDMACTL_UDMAP1 , 0 ) |
* (ATA_UDMACTL_UDMAP0 , 0 )
*
*/
writew(0, base + BK3710_UDMACTL);
/*
* MISCCTL Miscellaneous Conrol Register
* (ATA_MISCCTL_RSTMODEP , 1) |
* (ATA_MISCCTL_RESETP , 0) |
* (ATA_MISCCTL_TIMORIDE , 1)
*/
writel(0x201, base + BK3710_MISCCTL);
/*
* IORDYTMP IORDY Timer for Primary Register
* (ATA_IORDYTMP_IORDYTMP , 0xffff )
*/
writel(0xFFFF, base + BK3710_IORDYTMP);
/*
* Configure BMISP Register
* (ATA_BMISP_DMAEN1 , DISABLE ) |
* (ATA_BMISP_DMAEN0 , DISABLE ) |
* (ATA_BMISP_IORDYINT , CLEAR) |
* (ATA_BMISP_INTRSTAT , CLEAR) |
* (ATA_BMISP_DMAERROR , CLEAR)
*/
writew(0, base + BK3710_BMISP);
palm_bk3710_setpiomode(base, NULL, 0, 600, 0);
palm_bk3710_setpiomode(base, NULL, 1, 600, 0);
}
