void main (void)
{
unsigned char flags;
/* Init the hardware */
flags = catgenie_init();
#ifdef HAS_BLUETOOTH
serial_init(BT_BITRATE);
bluetooth_init();
serial_term();
#endif /* HAS_BLUETOOTH */
/* Initialize the serial port */
serial_init(BITRATE);
printf("\n*** GenieDiag ***\n");
if (!nPOR) {
DBG("Power-on reset\n");
flags |= POWER_FAILURE;
} else if (!nBOR) {
DBG("Brown-out reset\n");
flags |= POWER_FAILURE;
}
#ifdef __RESETBITS_ADDR
else if (!__timeout)
DBG("Watchdog reset\n");
else if (!__powerdown)
DBG("Pin reset (sleep)\n");
else
DBG("Pin reset\n");
#else
else
/**
* @brief Main program.
* @param None
* @retval None
*/
int main(void)
{
// int c;
/*!< At this stage the microcontroller clock setting is already configured,
this is done through SystemInit() function which is called from startup
file (startup_stm32f10x_xx.s) before to branch to application main.
To reconfigure the default setting of SystemInit() function, refer to
system_stm32f10x.c file
*/
SystemInit();
RCC_GetClocksFreq(&RCC_Clocks);
SysTick_Config(SystemCoreClock / SYSTICK_FREQUENCY_HZ);
#ifdef TRACEUART
TRACEUART_Configuration();
#endif //TRACEUART
UART_Configuration();
LED_Init();
/* Output a message on Hyperterminal using printf function */
printf("\n\r\n\r");
printf("*** LATTICE FW LOADER V1.00 Build by phalt on ("__DATE__ "-" __TIME__ ")\n\r");
printf("*** LATTICE FW LOADER V1.00 Rebooting ...\n\r");
/*
* wait for a keystroke (or a button press if you want.)
*/
// printf("\n\rPress Return to start, any other key To Enter the Console ...\n\r");
// c = awaitkey(DEFAULT_BOOT_DELAY);
if(1) //(((c != '\r') && (c != '\n') && (c != '\0')))
{
Delay(500);
GPIO_ResetBits(BLINK_PORT, (0xF << LED1));
// traceprintf("\rtrace start OK\n\r");
// Codec_GPIO_Init();
// Delay(1);
// /* Reset the Codec Registers */
// Codec_Reset();
// Delay(1);
// /* Initialize the Control interface of the Audio Codec */
// Codec_CtrlInterface_Init();
// Delay(1);
if(1)
{
GPIO_SetBits(BLINK_PORT, (0xF << LED1));
// WavePlayBack(AUDIOFREQ, 1);
WavePlayerInit(AUDIOFREQ);
GPIO_ResetBits(BLINK_PORT, (0xF << LED1));
}
while(1) //eugene loop
{
// Codec_CtrlInterface_Init();
GPIO_SetBits(BLINK_PORT, (0x1 << LED1));
// Codec_Write();
Codec_ReadRegister(0x00); //test read of codec
GPIO_ResetBits(BLINK_PORT, (0x1 << LED1));
Delay(1000);
}
if(1) //test
{
init_builtin_cmds();
serial_term();
}
}
printf("*** JUMP to Application now ...\n\r");
run_app(0x08000000);
/* Infinite loop */
while (1);
}
