void
loop(void)
{
mcp.write(0x0000);
delay(1000);
mcp.write(0xFFFF);
delay(1000);
}
void CommandFunction_PrintMCP(Print * printer, CommandEngine::Tokens & tk, CommandEngine::CommandLineEngine::FunctionFlags ff) {
if (ff == CommandEngine::CommandLineEngine::FF_HelpText) {
printer->println("Help with Echo command:");
printer->println("echo [value1] [value2] [value3] [value...]");
printer->println("[value] = either a macro $ or a literal value");
printer->println("Mostly for debugging the engine.");
return;
}
for(int i = 0;i < 0x15;i++){
printer->print("Clocks Reg ");
printer->print(i);
printer->print(" ");
printer->println(clocks.readRegister(i));
printer->print("Power Reg ");
printer->print(i);
printer->print(" ");
printer->println(power.readRegister(i));
}
}
void setup() {
// Initialize D0 + D7 pin as output
// It's important you do this here, inside the setup() function rather than outside it or in the loop function.
pinMode(D2, OUTPUT);
digitalWrite(D2, LOW);
delay(50);
digitalWrite(D2, HIGH); //Reset both MCPS
// delay(50);
clocks.begin();
power.begin(1);
clocks.pinMode(0,OUTPUT);
power.pinMode(0,OUTPUT);
clocks.digitalWrite(0,HIGH);
power.digitalWrite(0,HIGH);// Register macros
// Register macros
cleg.registerMacro("high", "1");
cleg.registerMacro("low", "0");
// Register custom functions with the engine
cleg.registerFunction("echo", CommandFunction_echo);
cleg.registerFunction("information", CommandFunction_information);
cleg.registerFunction("McpReg", CommandFunction_PrintMCP);
tServer.setProcessCallback(processData);
tServer.connect();
}
void
setup(void)
{
mcp.begin();
mcp.set_pin_mode(OUTPUT);
}