void setup() {
// Initialize D0 + D7 pin as output
// It's important you do this here, inside the setup() function rather than outside it or in the loop function.
pinMode(D2, OUTPUT);
digitalWrite(D2, LOW);
delay(50);
digitalWrite(D2, HIGH); //Reset both MCPS
// delay(50);
clocks.begin();
power.begin(1);
clocks.pinMode(0,OUTPUT);
power.pinMode(0,OUTPUT);
clocks.digitalWrite(0,HIGH);
power.digitalWrite(0,HIGH);// Register macros
// Register macros
cleg.registerMacro("high", "1");
cleg.registerMacro("low", "0");
// Register custom functions with the engine
cleg.registerFunction("echo", CommandFunction_echo);
cleg.registerFunction("information", CommandFunction_information);
cleg.registerFunction("McpReg", CommandFunction_PrintMCP);
tServer.setProcessCallback(processData);
tServer.connect();
}
void
setup(void)
{
mcp.begin();
mcp.set_pin_mode(OUTPUT);
}