static void testRingbuffer(int type)
{
TaskHandle_t th[2];
int i;
rb = xRingbufferCreate(32 * 3, type);
testtype = TST_MOSTLYFILLED;
xTaskCreatePinnedToCore(task1 , "tskone" , 2048, NULL, 3, &th[0], 0);
xTaskCreatePinnedToCore(task2 , "tsktwo" , 2048, NULL, 3, &th[1], 0);
uartRxInit();
printf("Press 'r' to read an event in isr, any other key to write one.\n");
printf("Test: mostlyfilled; putting 10 items in ringbuff ASAP, reading 1 a second\n");
vTaskDelay(15000 / portTICK_PERIOD_MS);
printf("Test: mostlyempty; putting 10 items in ringbuff @ 1/sec, reading as fast as possible\n");
testtype = TST_MOSTLYEMPTY;
vTaskDelay(15000 / portTICK_PERIOD_MS);
//Shut down all the tasks
for (i = 0; i < 2; i++) {
vTaskDelete(th[i]);
}
xt_ints_off(1 << ETS_UART0_INUM);
}
/* "inner" restart function for after RTOS, interrupts & anything else on this
* core are already stopped. Stalls other core, resets hardware,
* triggers restart.
*/
void IRAM_ATTR esp_restart_noos()
{
// Disable interrupts
xt_ints_off(0xFFFFFFFF);
// Enable RTC watchdog for 1 second
rtc_wdt_protect_off();
rtc_wdt_disable();
rtc_wdt_set_stage(RTC_WDT_STAGE0, RTC_WDT_STAGE_ACTION_RESET_RTC);
rtc_wdt_set_stage(RTC_WDT_STAGE1, RTC_WDT_STAGE_ACTION_RESET_SYSTEM);
rtc_wdt_set_length_of_reset_signal(RTC_WDT_SYS_RESET_SIG, RTC_WDT_LENGTH_200ns);
rtc_wdt_set_length_of_reset_signal(RTC_WDT_CPU_RESET_SIG, RTC_WDT_LENGTH_200ns);
rtc_wdt_set_time(RTC_WDT_STAGE0, 1000);
rtc_wdt_flashboot_mode_enable();
// Reset and stall the other CPU.
// CPU must be reset before stalling, in case it was running a s32c1i
// instruction. This would cause memory pool to be locked by arbiter
// to the stalled CPU, preventing current CPU from accessing this pool.
const uint32_t core_id = xPortGetCoreID();
const uint32_t other_core_id = (core_id == 0) ? 1 : 0;
esp_cpu_reset(other_core_id);
esp_cpu_stall(other_core_id);
// Other core is now stalled, can access DPORT registers directly
esp_dport_access_int_abort();
// Disable TG0/TG1 watchdogs
TIMERG0.wdt_wprotect=TIMG_WDT_WKEY_VALUE;
TIMERG0.wdt_config0.en = 0;
TIMERG0.wdt_wprotect=0;
TIMERG1.wdt_wprotect=TIMG_WDT_WKEY_VALUE;
TIMERG1.wdt_config0.en = 0;
TIMERG1.wdt_wprotect=0;
// Flush any data left in UART FIFOs
uart_tx_wait_idle(0);
uart_tx_wait_idle(1);
uart_tx_wait_idle(2);
// Disable cache
Cache_Read_Disable(0);
Cache_Read_Disable(1);
// 2nd stage bootloader reconfigures SPI flash signals.
// Reset them to the defaults expected by ROM.
WRITE_PERI_REG(GPIO_FUNC0_IN_SEL_CFG_REG, 0x30);
WRITE_PERI_REG(GPIO_FUNC1_IN_SEL_CFG_REG, 0x30);
WRITE_PERI_REG(GPIO_FUNC2_IN_SEL_CFG_REG, 0x30);
WRITE_PERI_REG(GPIO_FUNC3_IN_SEL_CFG_REG, 0x30);
WRITE_PERI_REG(GPIO_FUNC4_IN_SEL_CFG_REG, 0x30);
WRITE_PERI_REG(GPIO_FUNC5_IN_SEL_CFG_REG, 0x30);
// Reset wifi/bluetooth/ethernet/sdio (bb/mac)
DPORT_SET_PERI_REG_MASK(DPORT_CORE_RST_EN_REG,
DPORT_BB_RST | DPORT_FE_RST | DPORT_MAC_RST |
DPORT_BT_RST | DPORT_BTMAC_RST | DPORT_SDIO_RST |
DPORT_SDIO_HOST_RST | DPORT_EMAC_RST | DPORT_MACPWR_RST |
DPORT_RW_BTMAC_RST | DPORT_RW_BTLP_RST);
DPORT_REG_WRITE(DPORT_CORE_RST_EN_REG, 0);
// Reset timer/spi/uart
DPORT_SET_PERI_REG_MASK(DPORT_PERIP_RST_EN_REG,
DPORT_TIMERS_RST | DPORT_SPI01_RST | DPORT_UART_RST);
DPORT_REG_WRITE(DPORT_PERIP_RST_EN_REG, 0);
// Set CPU back to XTAL source, no PLL, same as hard reset
rtc_clk_cpu_freq_set_xtal();
// Clear entry point for APP CPU
DPORT_REG_WRITE(DPORT_APPCPU_CTRL_D_REG, 0);
// Reset CPUs
if (core_id == 0) {
// Running on PRO CPU: APP CPU is stalled. Can reset both CPUs.
esp_cpu_reset(1);
esp_cpu_reset(0);
} else {
// Running on APP CPU: need to reset PRO CPU and unstall it,
// then reset APP CPU
esp_cpu_reset(0);
esp_cpu_unstall(0);
esp_cpu_reset(1);
}
while(true) {
;
}
}
void timer0_detachInterrupt() {
timer0_user_cb = NULL;
xt_ints_off(1<<XCHAL_TIMER1_INTERRUPT);
}
