static void i2c_early_init_bus(unsigned bus) { ROMSTAGE_CONST struct soc_intel_skylake_config *config; ROMSTAGE_CONST struct device *tree_dev; const struct lpss_i2c_speed_config *sptr; enum i2c_speed speed; pci_devfn_t dev; unsigned devfn; uintptr_t base; uint32_t value; void *reg; /* Find the PCI device for this bus controller */ devfn = i2c_bus_to_devfn(bus); if (devfn < 0) return; /* Look up the controller device in the devicetree */ dev = PCI_DEV(0, PCI_SLOT(devfn), PCI_FUNC(devfn)); tree_dev = dev_find_slot(0, devfn); if (!tree_dev || !tree_dev->enabled) return; /* Skip if not enabled for early init */ config = tree_dev->chip_info; if (!config) return; if (!config->i2c[bus].early_init) return; /* Prepare early base address for access before memory */ base = EARLY_I2C_BASE(bus); pci_write_config32(dev, PCI_BASE_ADDRESS_0, base); pci_write_config32(dev, PCI_COMMAND, PCI_COMMAND_MEMORY | PCI_COMMAND_MASTER); /* Take device out of reset */ reg = (void *)(base + SIO_REG_PPR_RESETS); value = read32(reg); value |= SIO_REG_PPR_RESETS_FUNC | SIO_REG_PPR_RESETS_APB | SIO_REG_PPR_RESETS_IDMA; write32(reg, value); /* Initialize the controller */ speed = config->i2c[bus].speed ? : I2C_SPEED_FAST; lpss_i2c_init(bus, speed); /* Apply custom speed config if it has been set by the board */ for (value = 0; value < LPSS_I2C_SPEED_CONFIG_COUNT; value++) { sptr = &config->i2c[bus].speed_config[value]; if (sptr->speed == speed) { lpss_i2c_set_speed_config(bus, sptr); break; } } }
static void i2c_early_init_bus(unsigned int bus) { ROMSTAGE_CONST struct soc_intel_skylake_config *config; ROMSTAGE_CONST struct device *tree_dev; pci_devfn_t dev; int devfn; uintptr_t base; /* Find the PCI device for this bus controller */ devfn = i2c_bus_to_devfn(bus); if (devfn < 0) return; /* Look up the controller device in the devicetree */ dev = PCI_DEV(0, PCI_SLOT(devfn), PCI_FUNC(devfn)); tree_dev = dev_find_slot(0, devfn); if (!tree_dev || !tree_dev->enabled) return; /* Skip if not enabled for early init */ config = tree_dev->chip_info; if (!config) return; if (!config->i2c[bus].early_init) return; /* Prepare early base address for access before memory */ base = EARLY_I2C_BASE(bus); pci_write_config32(dev, PCI_BASE_ADDRESS_0, base); pci_write_config32(dev, PCI_COMMAND, PCI_COMMAND_MEMORY | PCI_COMMAND_MASTER); /* Take device out of reset */ lpss_reset_release(base); /* Initialize the controller */ lpss_i2c_init(bus, &config->i2c[bus]); }
/* Get base address for early init of I2C controllers. */ uintptr_t dw_i2c_get_soc_early_base(unsigned int bus) { return EARLY_I2C_BASE(bus); }