static void ft_pcie_ls_setup(void *blob, const char *pci_compat, unsigned long ctrl_addr, enum srds_prtcl dev) { int off; off = fdt_node_offset_by_compat_reg(blob, pci_compat, (phys_addr_t)ctrl_addr); if (off < 0) return; if (!is_serdes_configured(dev)) fdt_set_node_status(blob, off, FDT_STATUS_DISABLED, 0); }
void ft_cpu_setup(void *blob, bd_t *bd) { int off; int val; const char *sysclk_path; struct ccsr_gur __iomem *gur = (void *)(CONFIG_SYS_FSL_GUTS_ADDR); unsigned int svr; svr = in_be32(&gur->svr); unsigned long busclk = get_bus_freq(0); /* delete crypto node if not on an E-processor */ if (!IS_E_PROCESSOR(svr)) fdt_fixup_crypto_node(blob, 0); #if CONFIG_SYS_FSL_SEC_COMPAT >= 4 else { ccsr_sec_t __iomem *sec; sec = (void __iomem *)CONFIG_SYS_FSL_SEC_ADDR; fdt_fixup_crypto_node(blob, sec_in32(&sec->secvid_ms)); } #endif off = fdt_node_offset_by_prop_value(blob, -1, "device_type", "cpu", 4); while (off != -FDT_ERR_NOTFOUND) { val = gd->cpu_clk; fdt_setprop(blob, off, "clock-frequency", &val, 4); off = fdt_node_offset_by_prop_value(blob, off, "device_type", "cpu", 4); } do_fixup_by_prop_u32(blob, "device_type", "soc", 4, "bus-frequency", busclk, 1); ft_fixup_enet_phy_connect_type(blob); #ifdef CONFIG_SYS_NS16550 do_fixup_by_compat_u32(blob, "fsl,16550-FIFO64", "clock-frequency", CONFIG_SYS_NS16550_CLK, 1); #endif sysclk_path = fdt_get_alias(blob, "sysclk"); if (sysclk_path) do_fixup_by_path_u32(blob, sysclk_path, "clock-frequency", CONFIG_SYS_CLK_FREQ, 1); do_fixup_by_compat_u32(blob, "fsl,qoriq-sysclk-2.0", "clock-frequency", CONFIG_SYS_CLK_FREQ, 1); #if defined(CONFIG_DEEP_SLEEP) && defined(CONFIG_SD_BOOT) #define UBOOT_HEAD_LEN 0x1000 /* * Reserved memory in SD boot deep sleep case. * Second stage uboot binary and malloc space should be reserved. * If the memory they occupied has not been reserved, then this * space would be used by kernel and overwritten in uboot when * deep sleep resume, which cause deep sleep failed. * Since second uboot binary has a head, that space need to be * reserved either(assuming its size is less than 0x1000). */ off = fdt_add_mem_rsv(blob, CONFIG_SYS_TEXT_BASE - UBOOT_HEAD_LEN, CONFIG_SYS_MONITOR_LEN + CONFIG_SYS_SPL_MALLOC_SIZE + UBOOT_HEAD_LEN); if (off < 0) printf("Failed to reserve memory for SD boot deep sleep: %s\n", fdt_strerror(off)); #endif #if defined(CONFIG_FSL_ESDHC) fdt_fixup_esdhc(blob, bd); #endif /* * platform bus clock = system bus clock/2 * Here busclk = system bus clock * We are using the platform bus clock as 1588 Timer reference * clock source select */ do_fixup_by_compat_u32(blob, "fsl, gianfar-ptp-timer", "timer-frequency", busclk / 2, 1); /* * clock-freq should change to clock-frequency and * flexcan-v1.0 should change to p1010-flexcan respectively * in the future. */ do_fixup_by_compat_u32(blob, "fsl, flexcan-v1.0", "clock_freq", busclk / 2, 1); do_fixup_by_compat_u32(blob, "fsl, flexcan-v1.0", "clock-frequency", busclk / 2, 1); do_fixup_by_compat_u32(blob, "fsl, ls1021a-flexcan", "clock-frequency", busclk / 2, 1); #if defined(CONFIG_QSPI_BOOT) || defined(CONFIG_SD_BOOT_QSPI) off = fdt_node_offset_by_compat_reg(blob, FSL_IFC_COMPAT, CONFIG_SYS_IFC_ADDR); fdt_set_node_status(blob, off, FDT_STATUS_DISABLED, 0); #else off = fdt_node_offset_by_compat_reg(blob, FSL_QSPI_COMPAT, QSPI0_BASE_ADDR); fdt_set_node_status(blob, off, FDT_STATUS_DISABLED, 0); off = fdt_node_offset_by_compat_reg(blob, FSL_DSPI_COMPAT, DSPI1_BASE_ADDR); fdt_set_node_status(blob, off, FDT_STATUS_DISABLED, 0); #endif }