static void ft_pcie_ls_setup(void *blob, const char *pci_compat,
unsigned long ctrl_addr, enum srds_prtcl dev)
{
int off;
off = fdt_node_offset_by_compat_reg(blob, pci_compat,
(phys_addr_t)ctrl_addr);
if (off < 0)
return;
if (!is_serdes_configured(dev))
fdt_set_node_status(blob, off, FDT_STATUS_DISABLED, 0);
}
void ft_cpu_setup(void *blob, bd_t *bd)
{
int off;
int val;
const char *sysclk_path;
struct ccsr_gur __iomem *gur = (void *)(CONFIG_SYS_FSL_GUTS_ADDR);
unsigned int svr;
svr = in_be32(&gur->svr);
unsigned long busclk = get_bus_freq(0);
/* delete crypto node if not on an E-processor */
if (!IS_E_PROCESSOR(svr))
fdt_fixup_crypto_node(blob, 0);
#if CONFIG_SYS_FSL_SEC_COMPAT >= 4
else {
ccsr_sec_t __iomem *sec;
sec = (void __iomem *)CONFIG_SYS_FSL_SEC_ADDR;
fdt_fixup_crypto_node(blob, sec_in32(&sec->secvid_ms));
}
#endif
off = fdt_node_offset_by_prop_value(blob, -1, "device_type", "cpu", 4);
while (off != -FDT_ERR_NOTFOUND) {
val = gd->cpu_clk;
fdt_setprop(blob, off, "clock-frequency", &val, 4);
off = fdt_node_offset_by_prop_value(blob, off,
"device_type", "cpu", 4);
}
do_fixup_by_prop_u32(blob, "device_type", "soc",
4, "bus-frequency", busclk, 1);
ft_fixup_enet_phy_connect_type(blob);
#ifdef CONFIG_SYS_NS16550
do_fixup_by_compat_u32(blob, "fsl,16550-FIFO64",
"clock-frequency", CONFIG_SYS_NS16550_CLK, 1);
#endif
sysclk_path = fdt_get_alias(blob, "sysclk");
if (sysclk_path)
do_fixup_by_path_u32(blob, sysclk_path, "clock-frequency",
CONFIG_SYS_CLK_FREQ, 1);
do_fixup_by_compat_u32(blob, "fsl,qoriq-sysclk-2.0",
"clock-frequency", CONFIG_SYS_CLK_FREQ, 1);
#if defined(CONFIG_DEEP_SLEEP) && defined(CONFIG_SD_BOOT)
#define UBOOT_HEAD_LEN 0x1000
/*
* Reserved memory in SD boot deep sleep case.
* Second stage uboot binary and malloc space should be reserved.
* If the memory they occupied has not been reserved, then this
* space would be used by kernel and overwritten in uboot when
* deep sleep resume, which cause deep sleep failed.
* Since second uboot binary has a head, that space need to be
* reserved either(assuming its size is less than 0x1000).
*/
off = fdt_add_mem_rsv(blob, CONFIG_SYS_TEXT_BASE - UBOOT_HEAD_LEN,
CONFIG_SYS_MONITOR_LEN + CONFIG_SYS_SPL_MALLOC_SIZE +
UBOOT_HEAD_LEN);
if (off < 0)
printf("Failed to reserve memory for SD boot deep sleep: %s\n",
fdt_strerror(off));
#endif
#if defined(CONFIG_FSL_ESDHC)
fdt_fixup_esdhc(blob, bd);
#endif
/*
* platform bus clock = system bus clock/2
* Here busclk = system bus clock
* We are using the platform bus clock as 1588 Timer reference
* clock source select
*/
do_fixup_by_compat_u32(blob, "fsl, gianfar-ptp-timer",
"timer-frequency", busclk / 2, 1);
/*
* clock-freq should change to clock-frequency and
* flexcan-v1.0 should change to p1010-flexcan respectively
* in the future.
*/
do_fixup_by_compat_u32(blob, "fsl, flexcan-v1.0",
"clock_freq", busclk / 2, 1);
do_fixup_by_compat_u32(blob, "fsl, flexcan-v1.0",
"clock-frequency", busclk / 2, 1);
do_fixup_by_compat_u32(blob, "fsl, ls1021a-flexcan",
"clock-frequency", busclk / 2, 1);
#if defined(CONFIG_QSPI_BOOT) || defined(CONFIG_SD_BOOT_QSPI)
off = fdt_node_offset_by_compat_reg(blob, FSL_IFC_COMPAT,
CONFIG_SYS_IFC_ADDR);
fdt_set_node_status(blob, off, FDT_STATUS_DISABLED, 0);
#else
off = fdt_node_offset_by_compat_reg(blob, FSL_QSPI_COMPAT,
QSPI0_BASE_ADDR);
fdt_set_node_status(blob, off, FDT_STATUS_DISABLED, 0);
off = fdt_node_offset_by_compat_reg(blob, FSL_DSPI_COMPAT,
DSPI1_BASE_ADDR);
fdt_set_node_status(blob, off, FDT_STATUS_DISABLED, 0);
#endif
}
