void init_tlbs(void)
{
int i;
for (i = 0; i < num_tlb_entries; i++) {
set_tlb(tlb_table[i].tlb, tlb_table[i].epn, tlb_table[i].rpn,
tlb_table[i].perms, tlb_table[i].wimge,
tlb_table[i].ts, tlb_table[i].esel, tlb_table[i].tsize,
tlb_table[i].iprot);
}
return ;
}
int board_early_init_r(void)
{
const unsigned int flashbase = CONFIG_SYS_FLASH_BASE;
int flash_esel = find_tlb_idx((void *)flashbase, 1);
/*
* Remap Boot flash + PROMJET region to caching-inhibited
* so that flash can be erased properly.
*/
/* Flush d-cache and invalidate i-cache of any FLASH data */
flush_dcache();
invalidate_icache();
if (flash_esel == -1) {
/* very unlikely unless something is messed up */
puts("Error: Could not find TLB for FLASH BASE\n");
flash_esel = 2; /* give our best effort to continue */
} else {
/* invalidate existing TLB entry for flash + promjet */
disable_tlb(flash_esel);
}
set_tlb(1, flashbase, CONFIG_SYS_FLASH_BASE_PHYS,
MAS3_SX|MAS3_SW|MAS3_SR, MAS2_I|MAS2_G,
0, flash_esel, BOOKE_PAGESZ_256M, 1);
/* Disable remote I2C connection to qixis fpga */
QIXIS_WRITE(brdcfg[5], QIXIS_READ(brdcfg[5]) & ~BRDCFG5_IRE);
/*
* Adjust core voltage according to voltage ID
* This function changes I2C mux to channel 2.
*/
if (adjust_vdd(0))
printf("Warning: Adjusting core voltage failed.\n");
brd_mux_lane_to_slot();
select_i2c_ch_pca9547(I2C_MUX_CH_DEFAULT);
return 0;
}
int board_early_init_r(void)
{
const unsigned int flashbase = CONFIG_SYS_FLASH_BASE;
const u8 flash_esel = find_tlb_idx((void *)flashbase, 1);
/*
* Remap Boot flash region to caching-inhibited
* so that flash can be erased properly.
*/
/* Flush d-cache and invalidate i-cache of any FLASH data */
flush_dcache();
invalidate_icache();
/* invalidate existing TLB entry for flash */
disable_tlb(flash_esel);
set_tlb(1, flashbase, CONFIG_SYS_FLASH_BASE_PHYS,
MAS3_SX|MAS3_SW|MAS3_SR, MAS2_I|MAS2_G,
0, flash_esel, BOOKE_PAGESZ_16M, 1);
return 0;
}
int board_early_init_r(void)
{
const unsigned int flashbase = CONFIG_SYS_FLASH_BASE;
const u8 flash_esel = find_tlb_idx((void *)flashbase, 1);
/*
* Remap Boot flash + PROMJET region to caching-inhibited
* so that flash can be erased properly.
*/
/* Flush d-cache and invalidate i-cache of any FLASH data */
flush_dcache();
invalidate_icache();
/* invalidate existing TLB entry for flash + promjet */
disable_tlb(flash_esel);
set_tlb(1, flashbase, CONFIG_SYS_FLASH_BASE_PHYS, /* tlb, epn, rpn */
MAS3_SX|MAS3_SW|MAS3_SR, MAS2_I|MAS2_G, /* perms, wimge */
0, flash_esel, BOOKE_PAGESZ_256M, 1); /* ts, esel, tsize, iprot */
return 0;
}
int board_early_init_r(void)
{
const unsigned int flashbase = CONFIG_SYS_NAND_BASE;
const u8 flash_esel = 0;
/*
* Remap Boot flash to caching-inhibited
* so that flash can be erased properly.
*/
/* Flush d-cache and invalidate i-cache of any FLASH data */
flush_dcache();
invalidate_icache();
/* invalidate existing TLB entry for flash */
disable_tlb(flash_esel);
set_tlb(1, flashbase, CONFIG_SYS_NAND_BASE, /* tlb, epn, rpn */
MAS3_SX|MAS3_SW|MAS3_SR, MAS2_I|MAS2_G, /* perms, wimge */
0, flash_esel, /* ts, esel */
BOOKE_PAGESZ_64M, 1); /* tsize, iprot */
return 0;
}
unsigned int setup_ddr_tlbs(unsigned int memsize_in_meg)
{
unsigned int tlb_size;
unsigned int ram_tlb_index;
unsigned int ram_tlb_address;
/*
* Determine size of each TLB1 entry.
*/
switch (memsize_in_meg) {
case 16:
case 32:
tlb_size = BOOKE_PAGESZ_16M;
break;
case 64:
case 128:
tlb_size = BOOKE_PAGESZ_64M;
break;
case 256:
case 512:
tlb_size = BOOKE_PAGESZ_256M;
break;
case 1024:
case 2048:
if (PVR_VER(get_pvr()) > PVR_VER(PVR_85xx))
tlb_size = BOOKE_PAGESZ_1G;
else
tlb_size = BOOKE_PAGESZ_256M;
break;
default:
puts("DDR: only 16M, 32M, 64M, 128M, 256M, 512M, 1G"
" and 2G are supported.\n");
/*
* The memory was not able to be mapped.
* Default to a small size.
*/
tlb_size = BOOKE_PAGESZ_64M;
memsize_in_meg = 64;
break;
}
/*
* Configure DDR TLB1 entries.
* Starting at TLB1 8, use no more than 8 TLB1 entries.
*/
ram_tlb_index = 8;
ram_tlb_address = (unsigned int)CONFIG_SYS_DDR_SDRAM_BASE;
while (ram_tlb_address < (memsize_in_meg * 1024 * 1024)
&& ram_tlb_index < 16) {
set_tlb(1, ram_tlb_address, ram_tlb_address,
MAS3_SX|MAS3_SW|MAS3_SR, 0,
0, ram_tlb_index, tlb_size, 1);
ram_tlb_address += (0x1000 << ((tlb_size - 1) * 2));
ram_tlb_index++;
}
/*
* Confirm that the requested amount of memory was mapped.
*/
return memsize_in_meg;
}
