예제 #1
0
void __init da8xx_register_mcasp(int id, struct snd_platform_data *pdata)
{
	/* DA830/OMAP-L137 has 3 instances of McASP */
	if (cpu_is_davinci_da830() && id == 1) {
		da830_mcasp1_device.dev.platform_data = pdata;
		platform_device_register(&da830_mcasp1_device);
	} else if (cpu_is_davinci_da850()) {
		da850_mcasp_device.dev.platform_data = pdata;
		platform_device_register(&da850_mcasp_device);
	}
}
예제 #2
0
int __init da8xx_register_edma(void)
{
	struct platform_device *pdev;

	if (cpu_is_davinci_da830())
		pdev = &da830_edma_device;
	else if (cpu_is_davinci_da850())
		pdev = &da850_edma_device;
	else
		return -ENODEV;

	return platform_device_register(pdev);
}
예제 #3
0
int __init da8xx_register_spi_bus(int instance, unsigned num_chipselect)
{
	if (instance < 0 || instance > 1)
		return -EINVAL;

	da8xx_spi_pdata[instance].num_chipselect = num_chipselect;

	if (instance == 1 && cpu_is_davinci_da850()) {
		da8xx_spi1_resources[0].start = DA850_SPI1_BASE;
		da8xx_spi1_resources[0].end = DA850_SPI1_BASE + SZ_4K - 1;
	}

	return platform_device_register(&da8xx_spi_device[instance]);
}
int __init davinci_serial_init(struct davinci_uart_config *info)
{
	int i;
	char name[16];
	struct clk *uart_clk;
	struct davinci_soc_info *soc_info = &davinci_soc_info;
	struct device *dev = &soc_info->serial_dev->dev;
	struct plat_serial8250_port *p = dev->platform_data;

	/*
	 * Make sure the serial ports are muxed on at this point.
	 * You have to mux them off in device drivers later on if not needed.
	 */
	for (i = 0; p->flags; i++, p++) {
		if (!(info->enabled_uarts & (1 << i)))
			continue;

		sprintf(name, "uart%d", i);
		uart_clk = clk_get(dev, name);
		if (IS_ERR(uart_clk)) {
			printk(KERN_ERR "%s:%d: failed to get UART%d clock\n",
					__func__, __LINE__, i);
			continue;
		}

		clk_enable(uart_clk);
		p->uartclk = clk_get_rate(uart_clk);
		p->clk = uart_clk;

		if (!p->membase && p->mapbase) {
			p->membase = ioremap(p->mapbase, SZ_4K);

			if (p->membase)
				p->flags &= ~UPF_IOREMAP;
			else
				pr_err("uart regs ioremap failed\n");
		}

		if (p->membase && ((p->type != PORT_AR7) ||
					cpu_is_davinci_da850() ||
					cpu_is_davinci_da830()))
			davinci_serial_reset(p);
	}

	return platform_device_register(soc_info->serial_dev);
}
예제 #5
0
파일: psc.c 프로젝트: 1plus4/ev3sources
/* Enable or disable a PSC domain */
void davinci_psc_config(unsigned int domain, unsigned int ctlr,
		unsigned int id, char enable)
{
	u32 epcpr, ptcmd, ptstat, pdstat, pdctl1, mdstat, mdctl;
	void __iomem *psc_base;
	struct davinci_soc_info *soc_info = &davinci_soc_info;
	u32 next_state = enable ? 0x3 : 0x2; /* 0x3 enables, 0x2 disables */

	if (!soc_info->psc_bases || (ctlr >= soc_info->psc_bases_num)) {
		pr_warning("PSC: Bad psc data: 0x%x[%d]\n",
				(int)soc_info->psc_bases, ctlr);
		return;
	}

	psc_base = soc_info->psc_bases[ctlr];

	mdctl = __raw_readl(psc_base + MDCTL + 4 * id);
	mdctl &= ~MDSTAT_STATE_MASK;
	mdctl |= next_state;
	/* For SATA force the domain turn on */
	if (cpu_is_davinci_da850() && (id == 8) && (ctlr == 1))
		mdctl |= 0x80000000;
	__raw_writel(mdctl, psc_base + MDCTL + 4 * id);

	pdstat = __raw_readl(psc_base + PDSTAT);
	if ((pdstat & 0x00000001) == 0) {
		pdctl1 = __raw_readl(psc_base + PDCTL1);
		pdctl1 |= 0x1;
		__raw_writel(pdctl1, psc_base + PDCTL1);

		ptcmd = 1 << domain;
		__raw_writel(ptcmd, psc_base + PTCMD);

		do {
			epcpr = __raw_readl(psc_base + EPCPR);
		} while ((((epcpr >> domain) & 1) == 0));

		pdctl1 = __raw_readl(psc_base + PDCTL1);
		pdctl1 |= 0x100;
		__raw_writel(pdctl1, psc_base + PDCTL1);

		do {
			ptstat = __raw_readl(psc_base +
					       PTSTAT);
		} while (!(((ptstat >> domain) & 1) == 0));
	} else {
int __init da8xx_register_spi(int instance, struct spi_board_info *info,
			      unsigned len)
{
	int ret;

	if (instance < 0 || instance > 1)
		return -EINVAL;

	ret = spi_register_board_info(info, len);
	if (ret)
		pr_warning("%s: failed to register board info for spi %d :"
			   " %d\n", __func__, instance, ret);

	da8xx_spi_pdata[instance].num_chipselect = len;

	if (instance == 1 && cpu_is_davinci_da850()) {
		da8xx_spi1_resources[0].start = DA850_SPI1_BASE;
		da8xx_spi1_resources[0].end = DA850_SPI1_BASE + SZ_4K - 1;
	}

	return platform_device_register(&da8xx_spi_device[instance]);
}