static void __init rbtx4927_mem_setup(void)
{
if (TX4927_REV_PCODE() == 0x4927) {
rbtx4927_clock_init();
tx4927_setup();
} else {
rbtx4937_clock_init();
tx4938_setup();
}
_machine_restart = toshiba_rbtx4927_restart;
#ifdef CONFIG_PCI
txx9_alloc_pci_controller(&txx9_primary_pcic,
RBTX4927_PCIMEM, RBTX4927_PCIMEM_SIZE,
RBTX4927_PCIIO, RBTX4927_PCIIO_SIZE);
txx9_board_pcibios_setup = tx4927_pcibios_setup;
#else
set_io_port_base(KSEG1 + RBTX4927_ISA_IO_OFFSET);
#endif
/* TX4927-SIO DTR on (PIO[15]) */
gpio_request(15, "sio-dtr");
gpio_direction_output(15, 1);
tx4927_sio_init(0, 0);
}
static void __init rbtx4927_mem_setup(void)
{
char *argptr;
if (TX4927_REV_PCODE() == 0x4927) {
rbtx4927_clock_init();
tx4927_setup();
} else {
rbtx4937_clock_init();
tx4938_setup();
}
_machine_restart = toshiba_rbtx4927_restart;
#ifdef CONFIG_PCI
txx9_alloc_pci_controller(&txx9_primary_pcic,
RBTX4927_PCIMEM, RBTX4927_PCIMEM_SIZE,
RBTX4927_PCIIO, RBTX4927_PCIIO_SIZE);
txx9_board_pcibios_setup = tx4927_pcibios_setup;
#else
set_io_port_base(KSEG1 + RBTX4927_ISA_IO_OFFSET);
#endif
/* TX4927-SIO DTR on (PIO[15]) */
gpio_request(15, "sio-dtr");
gpio_direction_output(15, 1);
tx4927_sio_init(0, 0);
#ifdef CONFIG_SERIAL_TXX9_CONSOLE
argptr = prom_getcmdline();
if (!strstr(argptr, "console="))
strcat(argptr, " console=ttyS0,38400");
#endif
}
static void __init rbtx4927_mem_setup(void)
{
u32 cp0_config;
char *argptr;
/* enable caches -- HCP5 does this, pmon does not */
cp0_config = read_c0_config();
cp0_config = cp0_config & ~(TX49_CONF_IC | TX49_CONF_DC);
write_c0_config(cp0_config);
if (TX4927_REV_PCODE() == 0x4927) {
rbtx4927_clock_init();
tx4927_setup();
} else {
rbtx4937_clock_init();
tx4938_setup();
}
_machine_restart = toshiba_rbtx4927_restart;
#ifdef CONFIG_PCI
txx9_alloc_pci_controller(&txx9_primary_pcic,
RBTX4927_PCIMEM, RBTX4927_PCIMEM_SIZE,
RBTX4927_PCIIO, RBTX4927_PCIIO_SIZE);
txx9_board_pcibios_setup = tx4927_pcibios_setup;
#else
set_io_port_base(KSEG1 + RBTX4927_ISA_IO_OFFSET);
#endif
tx4927_sio_init(0, 0);
#ifdef CONFIG_SERIAL_TXX9_CONSOLE
argptr = prom_getcmdline();
if (!strstr(argptr, "console="))
strcat(argptr, " console=ttyS0,38400");
#endif
}
static void __init rbtx4938_mem_setup(void)
{
unsigned long long pcfg;
if (txx9_master_clock == 0)
txx9_master_clock = 25000000; /* 25MHz */
tx4938_setup();
#ifdef CONFIG_PCI
txx9_alloc_pci_controller(&txx9_primary_pcic, 0, 0, 0, 0);
txx9_board_pcibios_setup = tx4927_pcibios_setup;
#else
set_io_port_base(RBTX4938_ETHER_BASE);
#endif
tx4938_sio_init(7372800, 0);
#ifdef CONFIG_TOSHIBA_RBTX4938_MPLEX_PIO58_61
pr_info("PIOSEL: disabling both ATA and NAND selection\n");
txx9_clear64(&tx4938_ccfgptr->pcfg,
TX4938_PCFG_NDF_SEL | TX4938_PCFG_ATA_SEL);
#endif
#ifdef CONFIG_TOSHIBA_RBTX4938_MPLEX_NAND
pr_info("PIOSEL: enabling NAND selection\n");
txx9_set64(&tx4938_ccfgptr->pcfg, TX4938_PCFG_NDF_SEL);
txx9_clear64(&tx4938_ccfgptr->pcfg, TX4938_PCFG_ATA_SEL);
#endif
#ifdef CONFIG_TOSHIBA_RBTX4938_MPLEX_ATA
pr_info("PIOSEL: enabling ATA selection\n");
txx9_set64(&tx4938_ccfgptr->pcfg, TX4938_PCFG_ATA_SEL);
txx9_clear64(&tx4938_ccfgptr->pcfg, TX4938_PCFG_NDF_SEL);
#endif
#ifdef CONFIG_TOSHIBA_RBTX4938_MPLEX_KEEP
pcfg = ____raw_readq(&tx4938_ccfgptr->pcfg);
pr_info("PIOSEL: NAND %s, ATA %s\n",
(pcfg & TX4938_PCFG_NDF_SEL) ? "enabled" : "disabled",
(pcfg & TX4938_PCFG_ATA_SEL) ? "enabled" : "disabled");
#endif
rbtx4938_spi_setup();
pcfg = ____raw_readq(&tx4938_ccfgptr->pcfg); /* updated */
/* fixup piosel */
if ((pcfg & (TX4938_PCFG_ATA_SEL | TX4938_PCFG_NDF_SEL)) ==
TX4938_PCFG_ATA_SEL)
writeb((readb(rbtx4938_piosel_addr) & 0x03) | 0x04,
rbtx4938_piosel_addr);
else if ((pcfg & (TX4938_PCFG_ATA_SEL | TX4938_PCFG_NDF_SEL)) ==
TX4938_PCFG_NDF_SEL)
writeb((readb(rbtx4938_piosel_addr) & 0x03) | 0x08,
rbtx4938_piosel_addr);
else
writeb(readb(rbtx4938_piosel_addr) & ~(0x08 | 0x04),
rbtx4938_piosel_addr);
rbtx4938_fpga_resource.name = "FPGA Registers";
rbtx4938_fpga_resource.start = CPHYSADDR(RBTX4938_FPGA_REG_ADDR);
rbtx4938_fpga_resource.end = CPHYSADDR(RBTX4938_FPGA_REG_ADDR) + 0xffff;
rbtx4938_fpga_resource.flags = IORESOURCE_MEM | IORESOURCE_BUSY;
if (request_resource(&txx9_ce_res[2], &rbtx4938_fpga_resource))
printk(KERN_ERR "request resource for fpga failed\n");
_machine_restart = rbtx4938_machine_restart;
writeb(0xff, rbtx4938_led_addr);
printk(KERN_INFO "RBTX4938 --- FPGA(Rev %02x) DIPSW:%02x,%02x\n",
readb(rbtx4938_fpga_rev_addr),
readb(rbtx4938_dipsw_addr), readb(rbtx4938_bdipsw_addr));
}
